Question about 1998 Chevrolet Venture Cargo

1 Answer

Venture 1998 engine vibrating

I have venture 1998 and when im on neutral the engine is vibrating and i feel it on the stearing wheel and also its start vibrating when i shift from N to D starting drive after after i reach 20 to 40 speed the vibration gone

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 99 Answers

It may be the harmonic balancer

Posted on Jan 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Steering wheel vibrates when Im stopped at a light


You may have front brake rotors which are slightly warped. The ABS only comes into play under very hard brakeing conditions. Typically you may also feel a slight pulse in the brake pedal as you slow down.That would be my best guess.If you have a vibration when you are stopped, that may be a motor mount issue. Either the front and/or rear mount may be weak.They are designed to isolate small engine vibrations you might feel when the car is at a stand still The motor mounts are designed to isolate small engine vibrations at a stand still at idle as well as limit the amount of travel the engine can make under a load. As a car gets older, the rubber which is what the mounts are made of get harder and often collapse slightly and can cause your condition because they are no longer plyable.Maybe this might shed some light on your problem. Good luck.

Mar 24, 2014 | Nissan Altima Cars & Trucks

2 Answers

Vibration in stearing wheel from engine while parked is this normal have two with same problem


No it's not. Usually a moderate vibration in park or neutral is a bad motor mount or transmission mount.

Dec 31, 2012 | Cars & Trucks

1 Answer

My land cruiser 1993 pull to the right when im doing acceleration...and have some vibration while cruising...done balancing front and rear....done alignment. Pls advice....


Check for a brake, bearing or axle problem on the right wheels. A warped rotor could drag on the brakes and produce vibration. A bad bearing may also drag and vibrate. The easy test is to jack up the right side and spin the wheels by hand with the transmission in neutral.

Another possibility is a differential problem. You may detect that in the right side spin test. If you don''t find anything, try jacking up the rear end of the vehicle and spinning each rear wheel while watching what the other does. If they don't feel or act the same, or if you hear nasty sounds in the rear end, that would be your problem. If you have 4WD or FWD, do this test on the front end.

Feb 08, 2011 | Toyota Land Cruiser Cars & Trucks

1 Answer

Vibration


you need to isolate this better. does the vibration occur only when the car is moving or do you feel it when sitting in park and racing the engine a little.=lock into something on the engine. do you feel it in the steering wheel= front tire bad,out of balance,bent wheel.does it seem more like you feel it in the seat like the car itself is vibraitng=look at the rear tires. check that all wheel lug nutts are tight.turning corners and acellerating at the same time the vibration could be a CV axle joint. the axles could also cause a vibration.may have to be put on a lift and see if it vibrates when running of the ground. it can be hard to find .

Feb 21, 2010 | 1996 Toyota Corolla

1 Answer

Vibration on front passenger wheel but not through stearing wheel.not wheel balance as wheels rotated.


first check your wheel nuts are all tight.also check wheel size is the wheel the same size as the other wheels.take the car to tyre center.how do you know you know you have a vibration if its not through the stearing.most likly in the back wheels.adrian;;;;;;;;;;;

Jan 22, 2010 | 2006 Suzuki Swift

1 Answer

Vibration and noise from front end while driving


Jack up the front end and put stands under it and block rear wheels. Look at axle boots and see if they are cracked. Try turning wheel back and forth sharply and see if you can hear any clicking. Problem could be outer axle joints. If the boots are cracked or you hear a clicking noise you will have to replace the axle. The axle and boot come as a complete unit. Please let me know what you find out.

Apr 13, 2009 | 2002 Chevrolet Venture Passanger

1 Answer

1998 dodge caravan transmission


I hope this helps with your problem have someone to take and put the car in the air on jack stands do not start the car be sure to put something behind the back wheels first for safety put the car in neutral have someone put on gloves and see if they can turn the wheels in the front if you can not turn the wheels it is either a bad caliper on the brakes or a bad axle

Jan 02, 2009 | 1998 Dodge Caravan

2 Answers

Legacy wagon , shaking when hot


front wheel drive? may not be the enging may be CV joints or wheel bearing,

Dec 20, 2008 | 1993 Subaru Legacy

Not finding what you are looking for?
Cars & Trucks Logo

345 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...