Question about 1992 Chevrolet Corsica

2 Answers

92 chevy corsica

Hosed off engine now in runs ruff

Posted by on

  • veemax85 Sep 18, 2008

    Thanks. I will look at spark plugs next but I dont think there is a distributor cap. 3.1 multi port engine has 3 coil paks. i dont see a cap but let me know if I am wrong..Thanks Brian

  • dizzycooper Feb 03, 2009

    have 92 corsica. runs rough. dirty air flow sensor. anyone know how to clean?

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 136 Answers

Buy a can of WD40 and spray every thing electrical you see including the distributer cap inside and out. If any water got into the fuel system, Buy a water removal product at any auto parts store and put it in your tank.

Posted on Sep 18, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 421 Answers

Check all off your spark plug holes for water, also pull off the distributor cap and dry it out, if you have an air compressor try blowing off all ignition components with a blow gun, you may also try leaving it idle for awhile to dry everything up but my best guess would water down the spark plug holes or inside the distributor cap, good luck and please rate this -Jeff

Posted on Sep 18, 2008

  • jeff r
    jeff r Sep 19, 2008

    well then i would also try to dry out the circuit board that the coils plug into and make sure the contacts are not wet there should be 2-8mm bolts holding down each coil unbolt them and dry off the contacts and the circuit board -Jeff

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my 92 chevy corsica overheating after putting in a new water pump....radiator...and thermostate....whats wrong


did you clean your engine coolant system
you might have some dirt inside the block so the coolant can not pass
and check your temp sensor it is possible it could be defect.

Oct 21, 2014 | 1992 Chevrolet Corsica

1 Answer

I have a 92 Chevy Corsica that over heats on occasion .. I.don't know why? I put in a new new coolant bottle but not sure if I connected the hoses right? Can somebody help me figure out where they go...


You MUST bleed all air from the lines . There is a bleeder near the air filter and one by the belts . If it continues to over heat , then u have a blown headgasket .

Jun 01, 2012 | 1992 Chevrolet Corsica

1 Answer

Temp gage dose not work...


A bad body ground to engine or frame check all

Apr 06, 2012 | Chevrolet Cars & Trucks

1 Answer

Hi, My Corsica 92 start well but stops when I


Could be your idle air control valve is not allowing the engine to idle properly when you put a load on it.

Mar 30, 2010 | 1992 Chevrolet Corsica

2 Answers

I wanted to change my thermostat in my 93 chevy corsica but do not know where it is located


follow your upper radiator hose from the radiator back to the engine it will be under the housing hose connects to

Aug 10, 2009 | 1993 Chevrolet Corsica

1 Answer

Runs really ruff it ant the plugs and wires


some of the parts and what not (ecu ect) my not work on the 92 engine. Check With dealer or on line to see what years are acctually interchangeable. It could be somthing simple like needing to upgrde a sensor or reprograming the computer. Hope this helps

Apr 15, 2009 | 1998 Ford Explorer

1 Answer

I have no spark on 92 3.1 chevy corsica the coils are good


I would try and pull code, check all the relays and fused for continuity with a ohm meter. Then check to see if you have power to the coil/coils ?
Then trace the wirng from the coil output to the wiring ?
If the wiring , relay, fused check okay inside the engine . The ignition switch has to be checked.
Good luck , I hope this was helpful

Mar 15, 2009 | 1992 Chevrolet Corsica

1 Answer

Location of crank position sensor on 92 chevy corsica 3.1


You will have a no start or stalls after engine gets hot and then cools down restarts, the sensor is on the front of the engine mounted into the cam gear cover if it is not visiable get under the, (here is a picture) car and look.d37e0b9.jpg

Jan 21, 2009 | 1988 Chevrolet Corsica

1 Answer

92 chevy corsica when starting engine reves real high and then idles normal what could cause this?


as , with most corsicas , around that time , it seems that there is a general problem with the cruise control . . .
try unhooking the arm that connects the cruise control to the engine . . . should be easy to take off ,
and see if that helps the problem

Aug 04, 2008 | 1988 Chevrolet Corsica

Not finding what you are looking for?
1992 Chevrolet Corsica Logo

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...