Question about 1998 Mazda Millenia

1 Answer

Car is not accelerating properly, the power is simply not there to accelerate - the check engine light flashes as this happens engine light is on and the engine is howling, as well as no power.

Posted by on

  • rharve Oct 16, 2008

    My Car also does not have the power and also and when the gear shifts the car jerks. I have a check engine light while diagnostics it mentioned the knock sensor has gone bad.



    1998 Mazda Millenia (110,000)

  • Anonymous Mar 22, 2009

    when i first start the car i have full power and all is welll...all of a sudden be it after i have stopped at a light or slowed down while acceleratin all of a sudden as soon as my rpm's reach 2 1/2 i have no power...if i pull over shut car down and restart everything is back to normal.....any ideas??

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Check for timing belt has jumped and is out of timecheck for plugged exhaust

Posted on Nov 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The engine falters at low speeds


The flashing engine check light means a code is being stored in the computer. You need to have this code read and this will tell you what system is malfunctioning.

Feb 19, 2014 | Daewoo Tacuma Cars & Trucks

1 Answer

2003 blazer p301 code ive changed coil plugs check engen still flashing when accelerating


The flashing light means the problem is serious enough to damage the catalytic converter.
The code means cylinder 1 is not producing power. So it could be fuel, compression, or ignition related.

Feb 05, 2014 | Chevrolet Blazer Cars & Trucks

1 Answer

2007 Grand Prix Acceleration Problem


Check the ignition wires and the module

Jul 05, 2013 | 2004 Pontiac Grand Prix

1 Answer

While merging onto the highway when my car hit 3 and 4th gear the engine seemed to "stutter/misfire" during harder acceleration. Check engine light also flashed briefly during hard acceleration. Dur


Could be a transmission problem or something as simple as bad spark plugs.
The engine is under the most load when RPM is low and you are trying to accelerate, such as when it upshifts.
You should have the computer checked for trouble codes and hopefully that will point you in the right direction to test.
If the spark plugs have more than 50,000 miles of wear you might start with replacing them.

Feb 06, 2013 | 2008 Saturn Astra

1 Answer

Low fuel pressure on mazda rx8 2008 model, car does not accelerate properly on gets full power after 6500 rpm


You will need to have the fuel pressure monitored under a load with a special tool and also drive it for a while and see if the check engine light comes on, if it does have the system scanned and diagnose the codes received.

Oct 18, 2012 | Cars & Trucks

1 Answer

Engine light flashes when accelerator pedal is applied accompanied by severe power loss and trouble revving up


the check engine light is flashing to alert you to the fact that the engine has a missfire in the ignition system, don't continue to drive this with the condition or u can overheat and damage the catalytic converter.

May 11, 2009 | Mercedes-Benz E320 Cars & Trucks

1 Answer

Momentarily Sluggish Acceleration


Are you loosing power to the ecu when the car is shut down? most cars with an ECU that controls timing, fuel, or boost can be forced to relearn the car if the ECU looses power (called a "limp" mode). I'd look into this. Also are you getting any check engine lights? considering the description of the problem, this would help to diagnose. Try getting the car started and running normally, then turn the car off but do not kill the power to the car, just stop the motor from running...Fire the engine back up and try to give the car a good stomp on the gas and see if you get the same sluggish problems...my 2 cents... Good luck future auto DIY's

Apr 16, 2009 | 2003 Volkswagen Jetta TDI

1 Answer

Car is not accelerating properly, the power is simply not there to accelerate - the check engine light flashes as this happens


this is due to several reasons, could be 1 of your 4 coils needs replacing, could be spark plug/ h t lead problem, could be your catalityc converater has melted, these are very very common problems not only having to keep the oil toped up but also having to change these more expensive componants about every year ,it eats electrics for fun. you need to take it to a mazda garage for a plug in diagnosis.

Aug 04, 2008 | 2008 Mazda Rx-8

Not finding what you are looking for?
1998 Mazda Millenia Logo

426 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...