Question about 1994 Plymouth Voyager

1 Answer

Stalls out in drive not in reverse

After driving a short distance my van quits. If I drive it in reverse it runs without stalling out. what could be causeing this problem

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 421 Answers

Check the wiring harness on top of the transmission for rubbing thru and shorting, there is a bracket the harness attaches to near the battery and most of the time when the transmission is removed people forget to clip it back in place or the clips break and it will rub on the shifter shaft and arc out when the tranny is shifted in certin gears or when the engine moves while driving, sounds like this could be your problem good luck and dont forget to rate this, -jeff

Posted on Sep 18, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My van won't start after driving a short distance, it will start again after 3 to 5 minutes but then will act like it's going to stall while I'm driving. What's wrong?


Hi Greg, I'm AL the owner of Big As Auto Repair in St Charles Mo

Greg, I read your complete message, but nowhere did I see that you replaced the Cam Sensor. The EGR will cause it to stall at stops but usually will not prevent it from restarting. I would try replacing the Cam Sensor before anything else. If you should need further assistance go to my website by clicking here: Auto Repair

Mar 19, 2015 | 1997 Dodge Caravan

1 Answer

1997 honda stepwagon van shaking and stalling after I added oil. was running smoothly before this


3 liters of OIL perhaps you put too much in . and check the PCV and egR valves.

Jul 12, 2014 | 1997 Honda Odyssey

1 Answer

Transmission for 1999 cara van


did you check the fluid in the transmissin it could be low or also it could need a new transmission filter i wouldnt try to drive it it anymore without checkin or changin it because it will burn it up

Feb 16, 2013 | 1999 Dodge Grand Caravan

1 Answer

I have a F250 lariat with a 460 - truck stalls when I put it in gear - even after it runs for 20 min. Sometimes it will stall while I'm driving. I had carborator replaced last year. Hope you can help.


Some possible causes could be:

Vacuum leaks cause an engine to run lean witch can cause the vehicle to stall when put into gear.

Improper base idle adjustment can cause the vehicle to stall when shifted into drive or reverse

A malfunctioning or damaged carburetor can cause the vehicle to stall when shifted into drive or reverse

Improper ignition timing can cause the vehicle to stall when shifted into drive or reverse.

A malfunctioning or damaged transmission or torque converter can cause the vehicle to stall when shifted into drive or reverse

Oct 31, 2010 | 1987 Ford F 250

1 Answer

The van has an issue with stalling. Have replaced the fuel pump, coil pack and it still will not run. If left to sit for awhile, it will start and drive, but only for a very short distance, then stall...


Try cleaning the throttle body. remove the big black air hose and with the engine OFF, hold the throttle open and see how the throttle plate is black. it should be a smooth transition. Carbon ring starves the engine for air at idle, especially when it is warm outside.

Jul 09, 2010 | 1997 Dodge Grand Caravan

2 Answers

Van stalled while I was driving. I was able to restart it after a few minutes and drive a short distance before it stalled again. I had it in the shop for a squealing noise and the mechanic replaced power...


i would bring it back and make sure they didn't leave anything disconnected. there's not much as far as dirvablility stalling issues found on the belt side of the engine but anything is possible. It also sounds like you could have a fuel pump issue or a crank or cam sensor problem.

Mar 01, 2010 | 1997 Dodge Grand Caravan

1 Answer

When put into drive the car shakes and stalls. It


I have a 1989 5-series BMW which sometimes stalls after changing from reverse to drive. It also sometimes shakes when first driving in reverse before changing to drive.

Jan 30, 2010 | 1992 Mazda Protege

1 Answer

Bmw 325i 2003 stall


Sounds like you have a small bit of dirt or grit in the fuel system when accelerating it is drawn with enough force to cut off the fuel supply then is released when engine at Idle.
1 run liquid fuel line/injector cleaner in 1 tank
2 check fuel lines for debris
3 change fuel filters
4 have fuel tank flushed
here is trouble shooting order less expense to greater.

Aug 19, 2009 | 1996 BMW 318

Not finding what you are looking for?
1994 Plymouth Voyager Logo

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...