No lights will come on when car doors are open and if key is in ignition. Car will not start. When tried to tern lights on, car has a buzzing noise. Before it just quit, when i wuz driving it, if i stopped, it'll shut off
An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: Car will now work or start
It looks like you have a problem with the alarm system. Try disconnecting the battery cable for ten minutes or so. Before unplugging battery, ensure you have your car radio security code, should be in car documentation, you may be asked for the code on restart, if you lost it the stereo won't work.
If you still have the problem go back to car dealer and have alarm system checked.
If alarm system is ok or not present, what iremains is a possible wiring contact, that is quite unusuallly related to door lock.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you need a full charged battery or battery replaced [if battery bad and not holding charge] your remote key fob will not work if battery is dead or to weak to start car but key should be able to manually open drivers door --if its not an original key new cut or worn down [may have to jiggle in door ] your anti theft/security lock will come on when you use key in door than you have a few seconds after you open door to put key in ignition and turn to on position before alarm goes off but you need to get battery issue corrected first if key still doesnt work may need to have assistance [slimjim]lock to get in
cud hav computer or module issues--a readout scan shud b done-it shows voltages that a tech can decyfer------try using anothr key-chip cud b worn---------or disconnect batt a few --------or pull plug on computer and clean it-pins get dirty-----may reboot to normal--------go to a private shop for scan-not a dealer
TRANSLATION TO ENGLISH IS: Battery is in good shape, it has gas, fuses check good in center console fuse center and in front of hood, wen i tern the key i can hair relays clicking but ignition wont tern or start ,check starter and its good. OK then do you have a "security" light on in the dash cluster?
Okay, this sounds like theres a problem with the switch inside the door, try this, go to the passenger door and unlock it with the key, note if it has a lock, most newwer cars are only putting locks on drivers door, but if it has one use the key to unlock it and then try to start the car, if theres no lock then try the truck lock, unlock it with the key and try to start the car, if that doesnt work then use the fob to unlock all doors by pushing it two times and then start the car, the problem is the switch inside the door lock, this switch is part of the latch asm, good day.
Turn the key to the start position, but dont start. Wait for lights to stop blinking and push the brake pedal down a few times, light should flash again, turn ignition to off and remove key, exit car and lock doors, use key to open door and then try to start it. Good luck.
It sounds like they disconnected your battery when they worked on your car.... Try this and see if it works..
1-insert and remove key from ignition two times
2-close and open driver door two times
3-insert and remove key once from ign.
4-close and open drvr door twice
5-insert key into ign.,then close driver door
6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.
7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.
8-press lock/unlock together and hold for a second
9-release,and press lock on remote,the door locks will cycle
confirming program.continue to do other remotes you have,steps 8 and
9.if only one in possession,you are done. To end mode open door or insert key into ignition.
You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works