Question about 1998 Hyundai Elantra

1 Answer

Rear brakes there is a knocking noise in the rear brakes when i press the brake pedal

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

The rear brake drums are out of round and need to be machined or replaced. The shoes should then be adjusted to meet the drum with a slight drag. This should solve your problem

Posted on Sep 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why noise in car when pressing on gas pedal grinding


It's the car pulling to that side? Sticking brake pad possible. When did you have brakes done last off at all? Front brakes go out twice as fast as rear brakes. If you can Charlie jack up that side put car in park, set emergency brake and chock rear tires. Pull off that tire and see if rotor is grooved or scored badly. It may have been sticking and wore down faster. Also check CV BOOT. If torn u joints get dirty and will grind. Hope this was some help.

Feb 05, 2015 | 2005 Chrysler Pacifica

1 Answer

I have a 99" Ford Windstar LX, When I press on the brakes the pedal shakes and it makes a grinding noise after driving a few miles the abs light goes on. I have replaced, pads, rotors, master cylinder,...


if you replaced all the brake parts I would check your hub bearings and cv axels if the noise is coming from front if the noise is in the rear check your e brake shoes located inside of the rear brake rotors if u have disc rear brakes or your rear brake bearings .. hope this helps

Oct 12, 2013 | 1999 Ford Windstar

1 Answer

Brake Problem, Land Rover Discovery 1.


The noise comes from the rear i take it. this being the case the rear brakes need adjusting and a dab of anti seize put un the contact pionts of the brake shoes

Nov 27, 2012 | Land Rover Cars & Trucks

1 Answer

Adjusting brakes 1988 mazda capella


You are adjusting brakes, or need to know how to adjust brakes. In general, in between the two shoes on the back there is a screw with a star wheel on it that gets turned with brake pedal is pressed. Sometimes this screw hangs up from lack of turning and needs to be taken apart and lightly lubed. There is usually a plug that can be knocked out in the backing plate behind the shoes so this star wheel can be turned from under the car. Most cars if this screw is turning free can be adjusted tighter by simply backing up and pressing the brake pedal several times. That will keep pushing the star wheel and adjust the brake shoes out. I am talking about rear brakes in general and am thinking that the Mazda has some simularities.

Dec 25, 2011 | 1988 Mazda 626 Turbo

2 Answers

Need to press on the gas more to get the speed i used to; engine noise, lower fuel average, need to press brake pedal further down to stop car; why?


COULD BE DIRTY FUEL INJECTORS OR STOPPED UP FUEL PUMP FILTER WHICH IS ON THE FUEL PUMP.EXCESSIVE BRAKE PEDAL TRAVEL CAN BE BRAKE POWER BOOSTER NOT GETTING ENOUGH ENGINE VACCUM OR BRAKE BOOSTER CHECK VALVE OR BRAKE BOOSTER FAULTY.YOU COULD HAVE LOW BRAKE FLUID LEVEL IN MASTER CYLINDER.OR NEW BRAKE SHOES HAS NOT BROKE IN.

Jul 11, 2010 | 2008 Toyota Camry

2 Answers

2001 silverado changed rotors and break still brake pedal goes to floor and makes noise randomly 96000 miles


This will be in the rear,right?The rear are what gives you brake pedal height,so check the rear,this is the most likely cause.

Jan 26, 2010 | 2001 Chevrolet Silverado 1500

1 Answer

Knocking when brakes applied


REAR BRAKE NOISE - SHOE AND LINING KIT
A shoe and lining kit is available for installation if an Elantra (XD) or Accent (LC)
equipped with rear drum brakes exhibits a chattering noise from the rear brakes when
the brakes are applied.

APPLICABLE VEHICLES:
• Accent (LC) and Elantra (XD) equipped with rear drum brakes and in the following
Production Date and VIN Range:
SERVICE PROCEDURE:
For further information, refer to the applicable Shop Manual.
Model Production Date Range VIN Range
ACCENT (LC) May 21,1999 - Dec. 28, 2005 ALL WITH DRUM
BRAKES.
ELANTRA(XD) June 30, 2000 - May 23, 2006 JOB#1-
KMHDN46016V363974

ACCENT SHOE & LINING
KIT
ASSEMBLY
58305-25A00 58305-25F00 7"(00MY - 05MY)
58305-25A10 58305-25F10 8"(00MY - 05MY)

May 03, 2009 | 2003 Hyundai Accent

1 Answer

Brakes


you need to go to an engineer and tell him your brakes are making that sound

Jun 06, 2008 | 2003 Volkswagen Passat

Not finding what you are looking for?
1998 Hyundai Elantra Logo

Related Topics:

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...