Question about 2001 Hyundai Elantra

Open Question

NO FIRE Hyundai Elantra 2001

Hi I got a problem !

My engine stalled while i was driving at 100 km/h . Then i could not start it . It wont start it just crank over and over . Timing belt is ok spark plugs are ok and coils are ok .

There is no fire that goes to the spark plugs when the car is cranking . what could it be ?? The Crank shaft sensor ? please help me guys.

Posted by on

  • LordXerox Sep 16, 2008

    I just found what it is ... Crank shaft sensor is broken and SPIDER GEAR is broken too i have to change de engine !

×

6 Suggested Answers

  • 184 Answers

SOURCE: Timing Belt for 05 Hyundai Elantra

unless your well clued up with engines i wouldn't try changing timing belt yourself get somebody experienced to do this because if you don't time engine up properly you could cause serious damage by bending valves.

Posted on Dec 16, 2008

  • 16 Answers

SOURCE: 2002 Hyundai Elantra not starting

check fuel pump

Posted on Mar 14, 2009

ghost4548
  • 776 Answers

SOURCE: 2001 tiburon: cranking but will not start ? No Spark

Based on what you've described so far, you are not familiar with the system you are trying to repair (not intended to insult you). Take/tow the vehicle into a Hyundai Service Center (dealership), pay the diagnostic fee. They will tell you EXACTLY what the problem is and what's needed to fix it (parts, labor, tax, time-frame, etc.).

Posted on Jun 14, 2009

roniecon
  • 6826 Answers

SOURCE: crank case position sensor code 99 hyundai elantra

check timming belt it has jumped a notch

Posted on Jul 01, 2009

  • 225 Answers

SOURCE: 1999 hyundai sonata misfires after replacing crank

if you changed the timing belt and balancer belt. you may be 1 tooth off. will miss like a champ if the belt was changed

Posted on Aug 07, 2009

ghost45
  • 1280 Answers

SOURCE: A loud clunking noise when driving car,sounds

Hmmm.... rear strut bushings.

Posted on Oct 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The car keeps stalling splutters then stops running


Hyundai Elantra Questions - Engine stalls / hesitations at ...

www.cargurus.com > Questions > Hyundai > Elantra

CarGurusApr 20, 2013 - Engine stalls / hesitations at idle and low acceleration - Model: 1999 Hyundai ... stopped... and then at one last desperate pump of the gas pedal, the ...Despite all this, most of the time, the car runs smoothly, and several shops have .....Keep in mind that my car is Elantra 2001 with 82k miles on it, the car will ...

My car keeps shutting off when idle.. - CarGurus

www.cargurus.com > Questions > Chevrolet > Impala

CarGurusFeb 15, 2013 - whenever im on breaks or, it stutters for then cranks right back up. ... of your question, the stalling, hopefully somebody will come by to help you on that. ....Car having trouble starting,rough idling,shutting off at stop 2 answers.

How to Fix a Car That Stalls: 7 Steps (with Pictures) - wikiHow

www.wikihow.com > ... > Cars > Car Maintenance and Repair

wikiHowThere are many things that could cause a car to stall. ... Your engine stops runningbecause it is not igniting gas in the cylinders, this occurs either because there ...

Jan 01, 2016 | Cars & Trucks

1 Answer

2001 elantra stalls, loos of power, check engine line on.


check for vacuum leaks in the small rubber hoses.

Dec 14, 2013 | 2001 Hyundai Elantra

1 Answer

Where is the port to charge the ac on a 2001 hyundai elantra gls


High side should be on the right side of engine, just under the plastic cover, low side is the same side, almost against the fire wall just behind engine.

Aug 01, 2010 | 2001 Hyundai Elantra

3 Answers

Hyundai elantra stalls loss of power while


I just had this problem on a 2001 elantra. I took it in for repair: the MAP (Manifold Absolute Pressure/ intake air temp) sensor was shot. $150 later it works just fine.

Nov 08, 2009 | 2000 Hyundai Elantra

1 Answer

Need info on timing belt 1998 hyundai elantra


The timing belt is normally replaced at 100,000 km (approx. 60,000 mi), but must be checked for wear and tear starting 75,000 km(approx. 45,000 mi) along with a major tune-up.

The switch near the shifter is the ECT (transmission control) which selects NORMal driving mode, and PoWeR mode. It is the battle between economy (NORM) and driving performance (PWR). As tested, the PWR mode delays your A/T upshift to a higher RPM. This utilizes your engine's higher revs, but really cuts into fuel economy.

Hope this helps.

Jun 28, 2009 | 1998 Hyundai Elantra

1 Answer

Accent 2001 won't start after driving for only 100km


you may want to see if your catalitic converter is clogged up. I had a car that had that problem, when you drove too much it would die and wouldn't start for a long time after that. I had the converter replaced and now it drives just fine. May not be the same problem but it could be. and most muffler shops will check for a small fee if not for free.

Nov 28, 2008 | 2001 Hyundai Accent

1 Answer

Engine will not start.


Are you sure timing belt has been replaced correct? who worked on that?
72f582f.gif

Jun 18, 2008 | 2001 Hyundai Elantra

2 Answers

Hyundai 2000 Grandeur


Hyundai grandeur was running fine and now simply wont start. it turns over fine but thats it?

May 28, 2008 | 2001 Hyundai XG300

Not finding what you are looking for?
2001 Hyundai Elantra Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...