Question about 1991 Toyota Pickup

1 Answer

Ignition wire from starter

I put a motor out of a 894runner n a 91 p/u4x4.had 2 change wire harness,and cant find the ignition wire n the harness.i cut the one out of old 1,and need 2 now how and were 2 wire it n 2,and how please help cant get 2 work only vehicle HELP.u can also contact me at 937-377-7003

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 47 Answers

They are like a ring main red live black newtral

Posted on Jan 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Replacing battery harness and starter


Don't know exactly for your car but starter motors usually have a large thick cable direct from the positive side of the battery to the starter motor drive. Another thick cable from the motor body to an earth (or negative) point on the engine or car body and a smaller / thinner wire to the starter solenoid which comes from your ignition switch.

Apr 19, 2015 | 2008 Dodge Avenger

1 Answer

Which wires go to what in the radio


ITEM - WIRE COLOR - POLARITY - WIRE LOCATION
12V - red - POSITIVE - ignition harness
STARTER - white - POSITIVE - ignition harness
IGNITION - red - POSITIVE - ignition harness
ACCESSORY - red - POSITIVE - ignition harness
SECOND ACCESSORY - yellow - POSITIVE - ignition harness
BRAKE WIRE - white - POSITIVE - brake pedal switch
RADIO 12V - red - POSITIVE - radio
RADIO GROUND - black - NEGATIVE - radio
RADIO SWITCH - yellow - POSITIVE - radio
RADIO ILLUMINATE - pink - POSITIVE - radio
POWER ANTENNA - gray/orange - POSITIVE - radio
LF SPEAKER - white - brown - radio
RF SPEAKER - green - orange - radio
LR SPEAKER - yellow - black - radio
RR SPEAKER - orange - blue - radio

Jul 02, 2011 | Hyundai Motor 2003 Elantra

1 Answer

I have got the starter diconnected from my 2005 5.7 jeep gc but I cant get it out to replace it


1. Disconnect and isolate negative battery cable.
2. Raise and support vehicle.
3. Note: If equipped with 4WD and certain transmissions, a support bracket is used between front axle and side of transmission. Remove 2 support bracket bolts at transmission. Pry support bracket slightly to gain access to lower starter mounting bolt.
4. Remove two mounting bolts (2).
5. Move starter motor towards front of vehicle far enough for nose of starter pinion housing to clear housing. Always support starter motor (1) during this process, do not let starter motor hang from wire harness.
6. Tilt nose downwards and lower starter motor far enough to access and remove nut that secures battery positive cable wire harness connector eyelet to solenoid battery terminal stud. Do not let starter motor hang from wire harness.
7. Remove battery positive cable wire harness connector eyelet from solenoid battery terminal stud.
8. Disconnect battery positive cable wire harness connector from solenoid terminal connector receptacle.
9. Remove starter motor.

May 14, 2011 | 2005 Jeep Grand Cherokee

1 Answer

I have a 91 3000gt with non turbo i want to put twin turbo out of same year car in it is the wireing harness the same can i just install motor and plug in ecu and be ready to go


even though harness may be compatible, all your ignition components will vary, get a manual on both engines with wiring diagrams before proceding.. you will need help of an expert at these modifications

Sep 09, 2010 | 1991 Mitsubishi 3000GT

1 Answer

91 honda accord startin problems


The key switch went bad in my 88 Honda DX.I found out the problem quite by accident.Try playing with the switch very carefully and see if it will start for you! Yes the engine will spin buy it will not feed the coil so it will start.Good Luck!

Mar 22, 2010 | 1991 Honda Accord

1 Answer

I am trying to change the ignition switch in my 91 chevrolet truck and i cant get the old switch out.


f
The ignition switch is usually mounted to the steering column and is operated by a linkage rod.
NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.

78b188a.gif

The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch:
  • Remove the ignition switch wiring harness.
  • Unbolt it from its position.
  • Bolt the new switch into position.
  • Attach the witing harness.

Good luck (remember rated this help)

Jan 05, 2010 | 1991 Chevrolet C1500

1 Answer

Need a wiring diagram that will assist in installing a remote car starter for a 2003 4x4 kia sorento


12 VOLT CONSTANT GREEN (+) and BLUE (+) IGNITION SWITCH HARNESS STARTER RED (+) IGNITION SWITCH HARNESS STARTER 2 N/A IGNITION 1 YELLOW (+) IGNITION SWITCH HARNESS IGNITION 2 N/A IGNITION 3 N/A ACCESSORY/HEATER BLOWER 1 ORANGE (+) IGNITION SWITCH HARNESS ACCESSORY/HEATER BLOWER 2 WHITE (+) IGNITION SWITCH HARNESS KEYSENSE N/A PARKING LIGHTS ( - ) WHITE (-) @ HEADLIGHT SWITCH PARKING LIGHTS ( + ) RED/BLACK (+) @ DIMMER SWITCH POWER LOCK BLUE (TYPE B) IN DRIVERS KICK PANEL, at DOOR HARNESS POWER UNLOCK WHITE (TYPE B) IN DRIVERS KICK PANEL, at DOOR HARNESS LOCK MOTOR WIRE WHITE (+) IN DRIVERS KICK, at DOOR HARNESS DOOR TRIGGER RED/BLACK (-) DRIVER KICK PANEL HIGH IN BLUE PLUG DOMELIGHT SUPERVISION USE DOOR TRIGGER, Requires Part #775 Relay TRUNK RELEASE RED/ORANGE ( - ), Requires Part #775 Relay IN DRIVERS KICK PANEL, harness to rear of vehicle SLIDING POWER DOOR N/A HORN BLUE/BLACK ( - ) @ STEERING COLUMN HARNESS TACH RED (-) @ COIL PACK WAIT TO START LIGHT N/A BRAKE WHITE ( + ) @ SWITCH ABOVE BRAKE PEDAL FACTORY ALARM DISARM ORANGE (-) IN DRIVERS KICK PANEL

Dec 21, 2009 | 2003 Kia Sorento

1 Answer

Old plastic ignition switch caught fire,have to replace wires rt


supply to switch,switched supply ,and starter motor ,with the posibility of an aux for teh radio

Aug 12, 2009 | 1993 Isuzu Rodeo

4 Answers

My 91 jeep won't start...


The Starter relay is bad.

May 05, 2009 | 1991 Jeep Wrangler

1 Answer

1995 Chevy Blazer Wire Color Codes


95-97 blazer or 94-97 S-10
12volts red (there will be 2)+ ignition harness
Starter purple or yellow + ignition harness
Ignition pink + ignition harness
Second Ignition white or pink/white + ignition harness
Accessory orange + ignition harness
Power Lock lt. blue + either kick panel
Power Unlock white + either kick panel
Lock Motor gray drivers kick panel
Unlock Motor tan drivers kick panel
Parking Lights+ brown switch or rear harness
Door Trigger white - keyless module
Dome Supervision use door trigger
Trunk/Hatch Pin tied in with doors
Trunk/Hatch Release black/white + switch or keyless
Tachometer white AC ECM
Brake Wire white + at brake pedal switch
Parking Brake black at the pedal
Horn Trigger black - steering column

Jun 13, 2008 | 1995 Chevrolet Blazer

Not finding what you are looking for?
1991 Toyota Pickup Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...