Question about 1995 Jeep Grand Cherokee

1 Answer

Electrical Issue in 95 Grand Cherokee

I got into my jeep the other day and it was normal until I put the key in the ignition. It made the usual noise when the key was in and the door was open with the dinging noise but as soon as I shut the door it was a steady beep and it continued all the way home. I removed the fuse for that but then all the interior lights stayed on so I removed that fuse. I still have headlights but everything else electrical inside is down because the one fuse leaves the lights on and the other one makes that steady beeping noise. Plus now that those two fuses are out there is a ticking noise that never stops over on the passenger. If anyone knows whats going on or has any suggestions it would be greatly appreciate. Thanks in advance.

GC

Posted by on

  • tzurewich Sep 21, 2008

    I Have the same problem. 1995 Jeep Grand Cherokee. It started off with an intermitent service 4wd switch warning. Now there is a clicking on the passenger side when the doors are opened also the radio pulses when the car is running the warning panel infront of the shifter is dead except for a blink every 3 to 5 seconds. The blinking doesnt get faster with the motor. I pulled all the fuses and reseated them this did nothing. Also Unpluged the hot lead on the battery (to reset the computer) this did nothing. When I turn the consol lights down and turn the headlights on the warning panel starts to work normaly. Something is pulling down the voltage. I am suspiscous of the amplifier under the back seat.

  • leptocephali Dec 20, 2008

    First the alarm would go off when I started my 95 grand cher limited. Then there was problems with some of the interior lights, which were pulsating, then the vehicle information center in the dash started to blink some then start working, there was clicking from the right side of the dash, heat stuck high and cold and no power locks. Does anyone know how to fix this? It's hard to drive my jeep with no heater in Maine this winter due to no windshield defroster. Thanks.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Jeep Master
  • 70,387 Answers

Sounds like the door ajar switch is defective.

Posted on Nov 21, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1996 grand jeep cherokee wants to start..cranks up but wont..however, when i put key in ignition..none of the dials move...they're all dead


First the dials will not normally move until the vehicle is started. This is to reduce the load on the battery when cranking. You need to check for spark and fuel and all of the normal things for a non-starting vehicle.

Jan 12, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Re program my key fobik for a 2011 grand Cherokee jeep


put program key in ignition turn ignition switch to on position engine off for 3 to 15 seconds.you should hear acoustic signal and immobilizer lamp will flash then turn off ignition switch.you need two program keys to do this procedure twice. with in sixty second insert non program key in the ignition switch turn to on position engine off for at least with ten minutes you should hear acoustic noise immobilizer lamp flashing turn off ignition switch if all failed the dealership have to use diagnostic equipment to reprogram ignition key or keys.

Oct 26, 2012 | 2011 Jeep Grand Cherokee

1 Answer

Will a transmission out of a 95 jeep cherokee work in a 94jeep grand cherokee


As long as it is the same engine, they should swap. the main problem you would have is the electrical connectors which i do not believe change until 1996

Mar 06, 2012 | 1994 Jeep Grand

1 Answer

1993 jeep takes long time to start after turning key on have changed gass pump have put new fuel pump module in fuse box when fuel pump was replaced it started good for a few days


have the key in ignition turn off all excessories so you can hear,turn key to on postion listen to see if pump is working,sounds like a power anttena noise,if you hear this,then have the fuel pressure regulator checked,as could be loosing pressure,causing the hard start issue,or the pump could be bad,listen to car,then go from there.

Sep 02, 2011 | 1993 Jeep Grand Cherokee

2 Answers

I have a 2002 Jeep Grand Cherokee. I put my key


ur cylinder lock is going bad...... needs to be replaced

Apr 13, 2010 | 2002 Jeep Grand Cherokee

1 Answer

Sometimes my 2002 jeep grand cherokee will not start. It's in park and still will not start. When I first start it in the morning, no problem. Later in the day after I shut it off, it will not start. I...


u need a good car electrician to check the faulty electrical circuit that goes on and off at times or have ur car diagnosed electronically using an electronic scan tool to check if ur having a faulty signal from ur relays or your on board computer/ it seems to me the real culprit is ur ignition key cylinder that when not properly set wont give electrical connection to power up the starter....its definitely an electrical issue....

Apr 09, 2010 | 2002 Jeep Grand Cherokee

2 Answers

2002 Jeep Grand Cherokee Electrical Problem


Try cleaning both battery connectors--both cable ends and posts with a common internal/external brush set available at auto supply dealers. Apply a corrosion inhibitor grease (from the same dealers) liberally to insides and outsides of posts and cable ends. Check the far ends of both cables for tightness and lack of corrosion.

Aug 01, 2009 | 2002 Jeep Grand Cherokee

3 Answers

1999 JEEP GRAND CHEROKEE LAREDO


i have a 95 jeep grand cherokee lerado from time to time my alarm goes off i dont have a remote 4 my alarm but i found out that if you put the key in the driver door and unlock it. it will reset the alarm!!!!!

Nov 19, 2008 | 1995 Jeep Grand Cherokee

1 Answer

I have a 95 jeep grand cherokee limited 5.2 l. that will notstart


i had electrical problems on my cherokee before u start getting in to deep disconnect your battery for 1min then reconnect maybe computer at fault but doing this will reboot it

Nov 14, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

452 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...