Question about 2000 Hyundai Accent

1 Answer

Heater malfunction My heater has stopped working at levels 1, 2 and 3. Only works when I crank it up to level 4.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Contributor
  • 40 Answers

It's the switch itself. Common problem. The contacts are bad. Fairly cheap fix.
DO NOT replace any heater components, sucha s the heater core, blower motor or the relays. Those are not the problem.

Posted on Sep 15, 2008

  • Suzanne
    Suzanne Jul 25, 2014

    So how do I fix this



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My heater/AC only work at level 4, how do I get the lower levels to work again?

sounds like you need a new blower resistor, its under the dash on pass. side. if it goes bad your blower will only work on high. its fairly easy to change

May 29, 2014 | 2004 Dodge Stratus

1 Answer

I have a 2005 Altima SE 3.5 .. Whenever I stop and the heater is on, it blows cold air.However, when I drive the air becomes hot ?.. Any hints ? had anybody had the issue before ?

the first thing i would do is check the coolant level when the engine is cold. When the coolant level gets low enough the first thing to stop working is the heater. If the coolant level is good than I would suspect a plugged heater core.

If the thermostat where stuck open you would notice that the temp gauge would read low. If the water pump was not working correctly the vehicle would be overheating.

Apr 10, 2013 | Cars & Trucks

1 Answer

Heater works when driving car but not when at an idle

I'm assuming the heater blower motor does not stop working, but that the heater output temperature drops. Two possibilities: 1) Coolant level is low, 2) some type of blockage is allowing engine coolant to circulate only at higher rpm. Check the coolant level. If it's ok and this is an older vehicle that has never had the coolant system flushed, there may be buildup in the system that blocks circulation in the heater core.

Oct 10, 2012 | 2004 Pontiac Grand Am

1 Answer

Heater stopped working . temperature gauge stays low.fiesta

Priority Activity Part Reason to check
--------- ----------- -------------------------- ---------------------------------------------------------
1 Inspect Antifreeze Needed Coolant Level Low.
2 Inspect Heater Control Valve Leaking or Faulty Heater Control Valve.
3 Inspect Thermostat Thermostat Stuck Open.

May 17, 2011 | Ford Fiesta Cars & Trucks

1 Answer

My heat just stopped working on 2000 Lesabre. What are some possible causes of this

One or more of:

1. Your coolant level is low
2. Your thermostat doesn't close and needs to be replaced
3. The valve from the cooling system to the heater core is stuck
4. Your heater core is clogged

Feb 03, 2010 | 2000 Buick LeSabre

2 Answers

There's no heat coming out of the vent, just cold air. What is the possible solution to this problem

possible low anti freeze, air bound heater core, defective heat blend door control servo. Start with coolant level, if o.k. check hoses feeding heater core. If the lines are both hot suspect blend door servo/control unit. If only one hose hot suspect clogged/air bound core. Special bleed procedure for engine. With engine running, check for bleeder scews at upper hose mounting, open bleeder and watch for steady stream of coolant. Be careful as coolant is hot. If this does not help, disconnect hoses frm heater core when cool and blow out core with compressed air to unclog system. I hope this helps.

Dec 25, 2009 | 2002 Acura 3.2TL

2 Answers

My heater doesn't work. Hot water is circulating,

if both heater hoses going into the fire wall are hot,remove the heater control assembly from dash and make sure cable is connected and do the same under the hood where one heater hose has a valve connected to it,

Dec 15, 2009 | 1985 Chrysler Fifth Avenue

1 Answer

The blower for my heater only seems to work on 1 speed.F350diesel

Change out the resistor for the fan motor it is next to the fan motor on a red plate in the air box

Dec 08, 2008 | 2001 Ford F350 Super Duty SuperCab

Not finding what you are looking for?
2000 Hyundai Accent Logo

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides