Question about 2000 Dodge Ram 1500 Truck

1 Answer

Fix brake line

To replace a brake line on a 2000 dodge ram 1500 v8 auto. 4dr. driver side rearline do you need to drop the as tank

Posted by on

1 Answer

I had the same problem i didnt have to drop the tank just run your line over the top of it and be sure to secure it with no rubs anywhere

Posted on Sep 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas leak from top of the fuel tank in my 96 dodge ram 1500 v8 5.9 pick up


On the top of the fuel pump there is a rubber stopper covering an overflow tube
I had to drop the tank to find it but sure enough it was cracked in half.
Making my gas dump out. Dodge house did not have one in stock and had
to be special ordered. Local auto supply did not have the part either.

Apr 15, 2012 | 1996 Dodge Ram 1500 Club Cab

1 Answer

1995 dodge ram 1500 2 wd, replaced front brake pads, pedal goes to the floor, no air in lines, found leak, apperas to be halfway back, above fuel tank... What's back there that is causing a leak? Only thin...


Hi There.
could be a weak spot in the brake line and has popped when you pushed the pistons back on the brake calipers, (had a similar problem on my toyota previa) only thing you can do is replace brake line and bleed brakes. make sure that there is no build up of road dirt on top of the tank, and check for stone damage incase something got thrown up from the road..
Good Luck.

May 02, 2011 | 1996 Dodge Ram 1500 Club Cab

1 Answer

I changed the front brake lines on my 2004 dodge ram 1500, 4.7 liter, 2WD. do i need to bleed all four brakes?


Yes. It's easy to get air into the other lines. It's also a good time to make sure you have good, new brake fluid. If you didn't already, **** out the stuff in the reservoir and fill it with new, clean stuff. Now, go to your local auto parts store and get a one man brake bleeder, if you don't have one. It's a huge time saver. Starting with the rear passenger wheel, bleed it until you get new, clean fluid. Keep an eye on the reservoir and don't let it get low or you'll get air in and have to start over. Move on to the rear drivers wheel, and repeat the procedure. Next is the front passenger wheel, and last is the front driver's side wheel. Now you will have clean, new fluid in all 4 brakes, and an air-free system.

Nov 19, 2010 | 2004 Dodge Ram 1500

1 Answer

I Have a 99 dodge ram 1500. My question and problem is, I am leaking brake fluid from what appears to be obviously the brake lines. Is this an expensive fix? Seems to be leaking from the drivers side...


I would think that this is one of your least expensive fixes, in the long list of possible problems with vehicles. A tech would replace the line and then do a brake system fill and bleed. If it is the only problem, its possible for a tech to do it without removing a single wheel.

Oct 01, 2010 | 1999 Dodge Ram

1 Answer

How to replace a fuel pump for a 2000 dodge ram 1500 pickup 5.9 engine - 26 gallon tank


You have two choices.
1. Relieve fuel pressure.
2. Disconnect battery.
3. Lift truck, disconnect fuel lines, filler pipe and pump wires and remove fuel tank,

or lift pickup bed to access top of tank.

Aug 22, 2010 | 2000 Dodge Ram 1500 Truck

1 Answer

I need to find the right fuel filter for a dodge ram 1500 v8 5.2L and i need to know how to replace it.


you can go to a dodge dealer or you can look up us autoparts.com an they will ship u one the best way is to run it out of fuel drop the fuel tank and replace it it is the tank

Dec 03, 2009 | 1996 Dodge Ram

2 Answers

Wheres the fuel filter located at,on a 1988 dodge D250 ram truck 360 V8 auto trans.


follow the fuel line up from the gas tank and you will find a round canister this is the filter also it is usually located on the driver side under that area

Nov 13, 2009 | 1988 Dodge Ram Wagon

2 Answers

1999 Dodge Ram van 1500 no pick up power


I had a similiar problem on my 1999 Dodge Ram 1500 Conversion Van. It ended up being a partial collapse of the catalytic converter which didn't allow adequate exhaust. The problem only showed itself because I could not get over 55 mph going up a small hill.

Jul 05, 2009 | 2000 Dodge Ram 1500 Truck

3 Answers

2000 dodge ram 1500 speed sensor location


Hi my name is Allen!

The sensor you are looking for is located in the rear diff housing, its mounts on top of the housing it is also used for ABS if equipped.

For further asistance you may reach me through FixYa!

Dec 27, 2008 | 2000 Dodge Ram 1500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...