Question about 2002 Volvo V70

1 Answer

Drivers door mirror

Heated drivers door mirror not working and the information panel tells me that the drivers door is open when its closed

Posted by on

  • Anonymous Mar 22, 2014

    battery died now things don't work and the door open light on

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 5,158 Answers

I belive you will find some relays on the fuse panel (square box time things) locate the one for that particular device or group of devices you are having problems with and replace it.


Robert

Posted on Sep 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

VW 2000 Beetle 1.8 Turbo driver door lower hinge replacement, also replace the mirror switch as it broke off. And non stop door open chiming when door is closed.


The hinge is a big deal. You will have to remove the door panel and the fender. It is a pretty hefty job. While you have the door panel off you can replace the door latch for the door chime and also the mirror switch. Luckily it is all in the same door. Hope this helps.

May 13, 2015 | 2000 Volkswagen Beetle

1 Answer

2007 Chevy Trailblazer no power @ drivers door


Check the fuse from the manual and replace else, the ground wire on the right door panel has got open / cut.

May 22, 2014 | 2007 Chevrolet Trailblazer

1 Answer

Is there a step by step instruction on how to change the left side mirror on my Mitsubishi Endeavor 04 ? thank you


Maybe try alldata.com, because on my online resource for the 2004 Mitsubishi Endeavor, there is no information on body work.

One could get the part from the salvage yard and look for the bolts like one would do for a GM car

One may have to remove some plastic parts to get at the fasteners.

Also, if there are cables for moving the mirror from the inside, then that should be considered, as well.

Also, if the mirror is heated, that should be considered.
---
(I got this off of Wiki Answers)
Very easily. Open the door, find two rubber circular boots right behind the
mirror. Take them off to expose the 2 bolts that hold the mirror on. Take the
bolts out and unplug the wire. Reverse these steps to install, hole this
helps...

There are three small bolts holding the driver's side mirror on. Two can be
accessed by opening door and removing the two circular rubber boots seen on the
upper end of the door . To access the third bolt you will need to remove the
door panel. you will need a forked driver to help remove the door panel. It can
be bought at any auto parts store. It has a flat Y shaped head that can be
inserted along the lateral and bottom edge of the door panel to pop it way from
the door frame. There are three screws holding the door panel on. Two under the
door handle and one behind the door latch. Then the door lifts up and off. Make
sure you have the window down before you take the panel off because you cannot
access the third bolt unless it is. You will have to unplug the electrical
connects that power the controls on the door handle to completely remove the
door panel. After you remove the panel there will be a hole in the upper right
hand door frame, possibly covered by a black patch. Beneath this is the third
bolt. you will also need to disconnect the light from inside the door frame
before you will be able pull the mirror off. There is a large rubber boot oval
shaped that you can pull out and you will see the electrical connection for the
mirror inside the hole on the right.


Good luck on this repair.

Oct 07, 2010 | 2004 Mitsubishi Endeavor

1 Answer

2003 Navigator: remove driver-side Power Mirror


no need to remove the door.. just open the screws of the inside concole , opening handle and lever .. take out the console and u will see the screws to open the mirror.

Jul 29, 2010 | 2003 Ford Expedition

1 Answer

Ford expedition side mirror (instalation giude)


SECTION 501-09: Rear View Mirrors 2003 Expedition/Navigator Workshop Manual REMOVAL AND INSTALLATION Exterior Mirror Removal and Installation
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
Front Door Trim Panel —Expedition Removal and Installation
NOTE: Left front door shown, right front similar.
  1. Remove the door handle bezel.
    • Use service notch.
  1. Remove the window control switch plate.
    • Use service notch and disconnect the electrical connectors.
  1. s3j~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: To avoid damage to the door trim panel, lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips.
    Remove the two bolts and three screws, and remove the door trim panel.
  1. Remove the weather shield.
  1. Disconnect the exterior mirror electrical connector.
  1. Remove the exterior mirror.
    • Remove the nuts.
cf86471.gif
  1. To install, reverse the removal procedure.
    • Install top nut first.
---
Exterior Mirror Motor Removal and Installation
  1. Position the mirror glass to obtain a gap at the top edge of the mirror and carefully pull the top edge of the glass away from the mirror housing.
  1. Disconnect the heated mirror electrical connectors.
  1. Remove the exterior mirror motor screws and exterior mirror motor.
    • Disconnect the electrical connectors.
  1. To install, reverse the removal procedure.

Oct 26, 2009 | 2003 Ford Expedition

1 Answer

Drivers side mirror fell off the whole assembly how do i fix it


On a 1997 blazer, how to remove drivers side mirror
under your handle to close the door is two 7mm bolt and behind your handle to open the door is a philips screw and that plate behind it comes off then CAREFULLY remove the door panel trust me you dont want to break the plastic then you will see your mirror bolts and electrical wiring

Oct 21, 2009 | 1998 Chevrolet Blazer

1 Answer

Replace driver side mirror on 2001 Nissan Quest


SECTION 501-09: Rear View Mirrors 2001 Villager Workshop Manual REMOVAL AND INSTALLATION Mirror —Exterior Rear View Removal
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
  1. Remove the upper speaker.
    1. Disconnect the electrical connector.
    1. Remove the bolts.
    1. Remove the speaker.
  1. Position the watershield aside.
  1. Remove the exterior rear view mirror access panel.
  1. Disconnect the exterior rear view mirror electrical connectors.
    • Release the wiring harness locator.
  1. Remove the exterior rear view mirror.
    • Remove the bolts.
    • Feed the wiring harness through the door opening.

Mar 31, 2009 | 2001 Nissan Quest

1 Answer

Side mirror of 2005 ford explorer


Exterior Mirror Removal and Installation
All vehicles
  1. NOTE: Left side exterior mirror shown, right side similar.
    Remove the interior door trim panel. For additional information, refer to Section 501-05 .
Front Door Trim Panel Removal and Installation
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Remove the inside door handle bezel from the trim panel.
  1. Remove the window switch assembly.
  1. Disconnect the window switch and power door lock electrical connectors.
  1. Remove the upper trim panel screw at the window switch opening.
5c94a3e.gif
  1. Remove the lower trim panel screws.
2de1016.gif
  1. s2n~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: To avoid damage to the door trim panel, do not pull directly outward for this step.
    Lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips.
  1. Disconnect the power mirror electrical connector.
  1. Remove the trim panel.
  1. Remove the weather shield.
Vehicles with power, heated or approach lamp equipped exterior mirrors
  1. Disconnect the electrical connector.
All vehicles
  1. Remove the bolts.
a2275a5.gif
  1. Remove the exterior rear view mirror (17682).

Feb 23, 2009 | 2003 Ford Explorer

1 Answer

Replacing the passenger side mirror


screw driver will work then there will be 3 10mm nuts

Sep 21, 2008 | 2003 Ford Taurus

Not finding what you are looking for?
2002 Volvo V70 Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Mark Jones

Level 2 Expert

76 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...