Question about 2002 Jeep Grand Cherokee

1 Answer

2002 grand cherokee lmtd

In the morning when I start up my jeep after a rain it starts but then the head lights flash on and of and buzzers and bells go crazyand I turn on any thing the horn honks . I can drive it but looksand sounds pretty weird. After awhile I turn it off and back on there is a buzzing noise from the relay that is in back of the fuse panel on the driverside...I thnk it is a relay not sure. Then I turn off the jeep and my head lights won't go off even when I turn the switch off.So I have to undo the battery. And also the windows don't work at that point either. IS MY JEEP POSSESED????? Very weird Anyone out there had this problem????
T

Posted by on

  • hootesa Sep 22, 2008

    no leaks

  • yadayada
    yadayada May 11, 2010

    Do you have any kind of water leak into the car, maybe at the windshield area

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 74 Answers

Make sure the cover is properly installed on the fuse block. it has to be water gettin into something thats making it short out, look around at all your wiring and make sure its properly insulated (no bare wire)

Posted on Sep 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2001 Jeep Grand Cherokee - Security Key Flashing/ Wont Crank after dead battery


A flashing key symbol normally means an invalid key. Do you have an other key to try? That all the gauges stay at 0 seems to point to a PCI data bus problem. Was the jeep parked outside or at least standing in the rain? Many times water ingress in connector C200 up in the passengers footwell area is the problem. The connector must be removed, cleaned/dried and reconnected. Ofcourse the source of the water ingress must be found, which many times comes from the windshield.

May 01, 2013 | 2001 Jeep Grand Cherokee

1 Answer

I have a 2002 Jeep Grand Cherokee Laredo V6 4.0 It has been dying on me without warning. I'll be driving and the next thing I know I'm coasting no engine very hard to steer. It may start back up...


Looked up part at autozone it's about 34.00...the sensor is on top of the bell housing a little hard to get to but can be done....$300 is a little steep in my opinion

Jan 25, 2011 | 2000 Jeep Grand Cherokee

1 Answer

I have a 2002 grand jeep cherokee and when i start my car my engine starts shaking and makes the whole car shake


do a self test on your Jeep's computer by turning the ignition key off-on,off-on,off-on ( on is when the dash lights are on, off is one click back). The codes will either flash out on your check engine light in pairs, 5-5 is the end of the test. or if you have a digital odometer the codes will display there. Report back with the codes to help identify any problems.

Oct 13, 2010 | 2002 Jeep Grand Cherokee

2 Answers

2004 Jeep Grand Cherokee (63,000 mi - V8) Check engine light indicates #1 cylinder misfiring. Spent $$ getting system flushed for carbon residue. Drove 3 weeks, started up, ran rough, and light came on...


The miss,does not just come and go,if it is a engine valve,replace the coil and boot,go from there,if this does not solve the problem,then the injector is gone out,or going out.If it is a engine valve,the miss would never get better,then worse,it would be the same all the time,get him to run a air compression test,get the valves up(close)and see if any air is detected threw the exhaust,or the intake,it will be present if the valve is the problem.

Apr 24, 2010 | 2004 Jeep Grand Cherokee

1 Answer

Where do you find the radiator fan relay on 2002 jeep grand cherokee larado


behind head light,, on passenger side, on fenders underside ,remove head light completely,, drill 2 inch hole into protective shield, this will expose switch

Nov 16, 2009 | 2002 Jeep Grand Cherokee

2 Answers

93' Grand Cherokee, dont start, no spark,no gas preassure


my 1996 jeep grand cherokee lmtd. won't start did tune up. cranks but no fire. please help. engine code 54 shows up . cam shaft positioning no signal. . tested all circuit. changed cam shaft positioning sensor twice.still cranks did start once ran for 5 min. changed the sensor again. no luck. help please. keith

Sep 10, 2009 | 1993 Jeep Grand Cherokee

2 Answers

My 2002 Jeep Grand Cherokee Laredo won't start. It began to start then failed. Now it won't start at all. No clicking. Interior lights are on but the headlights make clicking noise continuously inside jeep...


Check that your battery has 12v, check and clean terminal contacts. If battery has less than 12v have it charged and load tested. 9 of 10 times this will get you going...if not, I'll give you the rest of testing later if you need it.

Sep 08, 2009 | 2002 Jeep Grand Cherokee

2 Answers

2002 Jeep Grand Cherokee Lardo misfiring


You say you changed the cam sensor. A1391 code is a crank sensor on the top of the trans. bell housing.

Feb 22, 2009 | 2002 Jeep Grand Cherokee

1 Answer

No parking lights on my 1993 Jeep Cherokee


Recap of my problem:
no parking lights, have headlights, light switch seems to have sweet spot that turns on both head lights and parking lights.

Solution is:
Blown fuse on 15, it works the radio, parking lights, dome lights.

Dec 21, 2008 | 1993 Jeep Cherokee Country

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...