My low beams work but when i try to turn my high beams on they do not work and the blue light in the dash does not come on.... they did work but stopped all of a sudden..

I would test the headlight dimmer switch to see if the high beams are being switched or the switch is defective.

is the light setup one ballast for high and low beam ? if so the ballast has gone, probably even the bulbs. replace the ballast and bulbs. some aftermarket ballasts don't last, if you cannot find the right ballast for replacement you will need to replace both ballasts. as every ballast set are set the same and sold in pairs.

I would guess the switch on the steering column
is worn out,thus no high beam feature

That switch & that part of the lighting system has to be tested

Best if you have wiring diagrams & electrical skills

As with almost all folks that come to any web site, I assume
everyone ends up at a repair shop,because no one says otherwise

Faulty switch.

check your fuse box

To clarify, when you pull the turn signal lever towards you, the high beam lights will come on only as long as you hold the lever up. This is the flash to pass feature.
To switch the headlights from low beam to high beam, you push down on the lever towards the dash. Then the high beam lights and the blue indicator light should stay on.

It sounds like you are confused about how your headlamp system is supposed to work. The DRL does not run on the High beam circuit, it runs on the low beam circuit. The fog lamps are supposed operate with the park lamps and also with the low beams, not the high beams. From your description, I would say that your system is operating as designed and you are having trouble telling High from Low. (Don't feel bad, that is why high beam indicators were invented in the first place.)

do you hear the click of the dimmer switch when you move the lever if you do then the steel rod that goes from the lever to the switch itself is working and the switch is moving from the low beam to high beam circuit.if the blue dash indicator is on them power is coming out of the switch to the dash to operate the light.its possible that the dimmer switch may need to be adjusted a little if you don`t hear the click but moves enough to put the dash light on but not enough to turn the high beams on,that is possibly why the low lights stay on.or you have a bad dimmer switch itself

All 4 lights is HIGH beam. The 2 that come on in 'LOW' are the low beams.