Question about 2000 Daewoo Korando

Open Question

Daewoo Matiz Dipped Headlights Fault

Hi,i have tested the fuse and relay but still no dipped headlights the main beam is ok, any ideas thanks keith

Posted by on

  • faye_owens Oct 04, 2008

    I have same problem but mine is opp. I have dipped headlights but not full beams... I have high beams tho,... Strange !!

  • joners01 Nov 05, 2008

    same issue happened today....

    Highbeams only work when the stalk is pulled in, not pushed out in to their 'on' position.

    Side lights work, however no low beams :(


×

5 Suggested Answers

  • 1 Answer

SOURCE: Suzuki swift Headlight problem

Have you checked to see if this is a wiring problem or maybe a relay problem?

Recently my lights would work on side lights and not anything else and this was down to dodgy wiring and needed a new relay unit.

Posted on Jul 28, 2008

  • 109 Answers

SOURCE: upgrading nissan almera dipped headlights?

I would have the complete headlight circuit checked out by a competent tech before buying more bulbs.

Posted on Nov 21, 2008

  • 1 Answer

SOURCE: renault clio extreme dip headlight fault 04 model

Mine was the relay

Posted on Feb 18, 2009

CHA55Y
  • 13 Answers

SOURCE: A4 Dipped headlights not working

check fuse, Underneath your fuse panel cover you will see a map of what fuse is what, find the headlamp spot, pull out the fuse have a look at the space between the contacts, you should see a contact wire connecting both post to one another, if not or you see a partially melted wire, replace fuse prob from nearest service station ($2) have you been through any cold or overly wet days when this occurred? any bumps in the carpark? Also consider these elements to the effect it can have on your car, lamps are very sensitive and can be blown from even the touch of bare fingers, they heat to extreme temps, bumps and moisture can cause severe damage, but not usually at once. And finally you can go down the track of popping out the switch in the dash and checking its integrity, not much goes on behind the dash to cause damage so I'd say this would be the least likely.... as you mentioned the stalk prob I'll say this.. indicating stalks and alike are much more "high traffic" instruments due to their multiple use nature and are much more prone to fault. this dosen't cover everything, after checking its not the simpler issues, it just gets a little more complicated checking relays, ecu modules and so on.. I'd also suggest looking up on google or even looking at vwwatercooled.org.au I go there all the time, they are all supa VW / Audi fans and will love to help, just do a search for the same issue posted / answered before starting a whole new thread, not that they would really mind I guess ha ha good luck mate, check the fuses ;7) Chas

Posted on Jun 08, 2009

  • 51 Answers

SOURCE: Dipped headlight not working, but full beams do work

yes there is only one bulb but it has both high and low beam built into it you will have to take the bulb out and get a new one and when you put the new one in DONT TOUCH THE GLASS OF THE BULB

Posted on Aug 26, 2009

Testimonial: "Thanks, didn't think of the two-in-one bulb possibility."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dipped headlights are intermittent


Look for the RELAYS for the lights. They are usually on the fuse box. Replace the headlight relay.

Jan 06, 2014 | 2001 Volkswagen Beetle

1 Answer

I couldnt choose Citroen in the option so please discard the audit etc. I have a CITROEN C2 VTS (NU57 XSG) and have replaced the original headlights with Citroen (morette) twin headlights, i am wanting a...


loop the main beam to the second light simple ,find the feed with a meter when the main beam is on ,simple to do but be warned here ---make sure the light has a certificate of homoglonation and a E number in the headlight glass or you could face a big fine for unauthorised modification of a motor vehicle ,also this sort of work can only be signed off by a authorised garage with a Value Added Tax certificate and a inspection to change the cars papers at the local car testing station ,or dont drive in spain as they will impound the vehicle

May 06, 2011 | Audi TT Cars & Trucks

1 Answer

Main beam and dip not working,checked fuses and relays under bonnet all ok, is there another relay somewhere


More than likely the dimmer switch has gone bad. The lever you use to flip between hi/low beams will need to be replaced.

Feb 21, 2011 | Mitsubishi Pickup Cars & Trucks

1 Answer

05 Renault Grand Scenic. No dipped headlights. Bulbs and fuses OK


Are u sure that the bulbs are OK? I had no dipped lights on mine, & thought it must be a fuse or another electrical fault. It turned out, both bulbs had gone. I think this often happens when one side goes, the other soon follows.

Feb 10, 2010 | 2005 Renault R5

1 Answer

No dipped beam headlights on audi a4 1,9td 2003


Check up dipped beam headlights fuse inside fuse box. For Audi A4 the fuse box is located on the left side of dashboard behind a plastic cover (for left hand steering wheel vehicle). On inner face of the plastic cover you will find the fuse diagram. If the dipped beam headlights fuse is OK, check up dipped beam headlights bulbs.

Dec 28, 2009 | 2004 Audi A4

1 Answer

Headlights


It May not be your fuse. The headlight unit uses one bulb for dipped headlights and another for main beam. On your fuse panel cover should be a sticker with symbols on relating to which fuse has which purpose

Dec 18, 2009 | 2002 Hyundai XG350

1 Answer

No low beam only high beam


check the ground connection of the bulbs. check the light switch. the headlight relay is located under the dash or under the hood.

Nov 25, 2009 | 1994 Mazda 323

1 Answer

Low Beam headlights don't work. High Beam work fine and diriving lights work as well.


hi from uk provided you have checked bulbs are ok? then this fault may be the relay for the low /dipped beam has gone faulty if you check h/book you may find location of low beam relay there is relay for high and one for low beams if you find both relays ? try switching? this will confirm relay fault if you then have low beam but no high ? b4 you buy new relay other than tis the other possible fault may be the actual di/high beam stick control ?

Nov 09, 2009 | 1998 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

411 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

yadayada
yadayada

Level 3 Expert

66302 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...