- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
no tail light on passenger side. replaced tail light circuit board, fuses and bulbs. I havebrake lights ... 2003 GMC Envoy75,000Visitor. My brake light got ... How do I replace the high mount third brake light on a 2002 gmc envoy? The light does ...
Open the rear hatch and locate the area behind the light you wish to change. You will see two screws that hold the assembly in place. Remove those two screws and push the pins through and the whole assembly will pop out allowing you to access the bulb by twisting the connection and pulling it out. Installation is the reverse. Good luck.
The air bag light will remain illuminated if a fault has been detected in the air bag system.
The onboard computer will need to be interfaced with diagnostic equipment to read the fault.
This is also the only way to reset the light.
Good luck, I hope this helped.
Pop the hood and locate the rubber piece that is behind the headlight. Remove the plastic screw that holds it in place and you can easily just bend down the rubber piece to gain access to the bulbs. The driver side is a little tighter to get into because it sits next to the windshield washer fluid container.The passenger is a lot easier but you do have to remove the air box which is very easy.
2 screw, they are torx head, so you will need a torx driver, any parts store will have them to sell. remove the 2 screws and while pulling back, take your hand from the side and whack the light lens towards the middle of the truck, this will dislodge the clips.