Question about 1991 Chevrolet S-10 Blazer

1 Answer

Cranks but won't start

Engine cranks but won't start, it did start once and seemed to idle normally but shut off the second I put it in gear and won't re-start.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 507 Answers

Jus the motor shut off? Or did all the gagues, lights, everything seem to shut down? If all the gagues acted up, sounds like the ignition switch, not the lock cylinder, the acutal ignition switch.

Posted on Sep 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 dodge magnum 2.7 with 136k miles, I changed the coil pack, spark plugs & a new throttle body all OEM parts... Once the car warms up my idle drops to 625-700 but it feels like it wants to...


Hi Gabro
try this procedure and let me know if it work.make sure the engine is in normal temperature, all accessories are off.
start the engine and let it idle for 1 minute.
put the selector into D and let the engine idle for 30 seconds.
turn the AC on and let the engine idle for 30 seconds.
turn the AC off and let the engine idle for 30 seconds.
put the selector into P and let the engine idle for 30 seconds.
switch engine OFF for 2 minutes.

Feb 04, 2014 | 2006 Dodge Magnum

1 Answer

Engine revs but no acceleration


Clutch plate and pressure plate seem to be too weak to pull the car. Or one of the CV joints is detached from the gear box. To test the clutch plate, park the car on flat surface. Pull the hand brake up, start the car, depress the foot brake pedal, depress the clutch pedal, put the car in 1st gear, press the gas pedal and leave the clutch pedal at once, while keeping the brake pedal depressed.
Follow one of the two following statements:
1. Engine does not shut down and remain start. (Clutch plate, pressure plate and clutch bearing defective - Replace all as a set)
2. Engine shuts down. (Clutch system is OK and does not require any repair).

May 22, 2013 | Honda Civic Cars & Trucks

1 Answer

Terrano diesel 1996 auto transmission starts in the morning but stalls when put into gear. It won't work until after 5 minutes at idle after which time it seems to work. Have had the diesel injec


try a new fuel filter if you haven't replaced it already. you may have a weak injection pump; does it crank for a long time before it starts?

Apr 06, 2013 | Cars & Trucks

1 Answer

1996 mercedes c280 dies when put in drive


Engine stalls or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 15, 2012 | 1996 Mercedes-Benz C-Class

1 Answer

I have a 96 pontiac grand am that doesnt start all the time


Starting Problem # 1: Engine Won't Crank At All

Scenario: You turn the key, but nothing happens: And by nothing, we mean there is no dash light, no sound, nada. The first thing you should do in this case is to pop the hood and check the battery. Either the battery is completely dead or there's a wiring problem in the starting system. Try jump-starting the battery. If that doesn't work, you'll probably have to call for assistance.

Scenario: When you turn the key, you hear a rapid clicking sound, and the dash lights dim. This is your classic low-battery symptom. Jump-starting the battery should get the engine to start.However, if you keep experiencing this problem, you could have a bad battery or alternator, or it could be some­thing as simple as a loose alternator belt. Take your car to a mechanic just as soon as you can.

Scenario: When you turn the key, the lights on the dash come on, but you don't hear anything. Make sure you have the shift selector all the way in park. Move it out of park and then back, or try starting it with the shifter in neutral. If your car has a manual transmission, make sure you have the clutch pressed all the way to the floor. If that doesn't help, you can try jump-starting the battery, but it probably won't work. There's a good chance your car has a bad starter or a problem in the starting circuit. That could mean a prob­lem in the ignition switch, neutral safety switch or starter sole­noid.

Scenario: The dash lights come on when you turn the key, and then go right out, and the engine doesn't crank when you turn the key to start, But, the lights slowly come back on when you release the key. This is another classic: the bad battery connection. When you turn the key to start, the starter pulls so much current that it breaks the connection. Then, when you release the key, the connection slowly comes back. The connection provides enough power to turn the dash lights on, but not enough to crank the starter. Cleaning and tightening the battery terminals may fix this prob­lem.

Scenario: When you turn the key, you hear a single, hard clunk. Turn the headlights on and try again. Do the lights dim slightly when you turn the key? If so, you probably have a bad starter or a seized engine. If the headlights don't dim at all, or just barely dim, there may be a connection problem between the starter solenoid and the starter itself.

Scenario: When you turn the key, you hear a loud, scraping or grinding sound like metal on metal. The starter drive is bad, or the ring gear on the flywheel damaged, or both. You may get the starter to engage if you try turning the key a couple of times, but let go of the key right away if you hear the noise again. If the car does start, you should drive it right over to local repair shop and have the problem fixed.

Starting Problem #2: Engine Cranks but It Won't Start

Scenario: The engine seems to crank normally, but the engine doesn't even sound as if it's trying to start. Is there gas in the tank? Gas gauges are notoriously inaccurate. If you have to move your head to one side to get the needle to move off empty, try adding some gas to the tank.

Scenario: When you first turn the key on, you don't hear the fuel pump run. In cars with electronic fuel injection, you should hear a light hum a few seconds from around the fuel tank. That's the electric fuel pump running. If you don't hear the fuel pump run for a couple seconds when you first turn the key on, try cranking the engine until the oil light goes out. That may start the pump running and allow the engine to start.

Scenario: The engine cranks normally, and it sounds like it wants to start, but it won't. You may have flooded the engine. Hold the gas floor and try again. (Let the gas pedal up when it finally starts). If it's raining out, the ignition system may be wet.

Scenario: The engine cranks unevenly in a repetitive-sounding pattern. You may have a bad timing chain or timing belt. Call a tow truck and have it towed to the repair shop.


Starting Problem # 3: Engine Starts but It Shuts Off

Scenario: The engine starts right up, but shuts off as soon as you release the key. This is the classic symptom of a bad ignition switch. A new switch should fix it.

Scenario: The engine starts and runs, but when you put the transmission in gear, the car lurches and the engine shuts off. The converter clutch in the transmission torque converter probably is engaging when it shouldn't. On some cars, you can bypass this by disconnecting the torque converter clutch solenoid; but unless you know which wire to pull, forget about it. Call for assistance.

Scenario: The engine starts and runs, but seems to idle slowly and stalls when you come to a stop. This probably is a fast idle problem. When the engine is cold, it's supposed to idle a little faster than normal to keep the engine running. You may be able to drive using two feet until the engine warms up: one on the gas to hold the idle up a little and the other for the brake. However, don't keep driving it this way. Take your car to your repair shop just as soon as you

Jul 21, 2011 | 1996 Pontiac Grand Am

1 Answer

I have a 93 Dodge Colt 1.5 liter engine. I've noticed in the last month or so after it starts that the idle seems to go high and take 15 or 20 seconds to get back down to normal. Two days ago I went to the...


Its probably your computer. Had the same thing happen to me about ten years back. About 500 dollars. better off finding one on ebay or at a junk yard.

Aug 09, 2010 | 1993 Dodge Colt

1 Answer

Long Crank Time When Hot


Timing belt/chain may have been put it slightly off time, when motor rebuild

Jan 13, 2010 | 1993 Dodge Spirit

2 Answers

'03 Jeep Liberty starts weakly and needs gas pedal to idle


Turning over is what the starter does to the engine ...you can turn an engine over with no spark plugs in it...but you can't start it. Turning over is cranking .....the starter turns (cranks) the engine over (comes from when you had to put a crank in the front of the engine and crank it.)
Does it crank normally but has trouble starting???????

Jun 27, 2009 | 2003 Jeep Liberty

Not finding what you are looking for?
1991 Chevrolet S-10 Blazer Logo

Related Topics:

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...