- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
should show on fan shroud belt routing.
on idler pully there should be square hole for 3/8 ratchet to go in and turn to loosen belt, but you have to hold pressure on it to take belt off one pully.and also to put back on.
[watch your knuckles]
My sincere apologies for the delayed response. I am personally going back to answer your unanswered questions. I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.
My sincere apologies for the delayed response. I am personally going back to answer your unanswered questions. I have only been a free contributor to this site for the past 4-months.
I do not know if you still need this information, but I am going ahead and answering it anyway.
CLICKon the following LINK. It has several Belt Diagrams, one which will match your specific engine and options (AC/No AC, Power Steering, .etc) that you will need.
Regarding HOW: Standard Rules to Removal the Serpentine Belt: 1. Find the Tensioner(s). (See the Diagrams on Link) 2. Using a Serpentine Belt Tensioner Tool or Wrench or Ratchet Tool: Rotate/Move the Tensioner Pulley/Arm away from contact with the belt and towards the area where the belt is not in contact with the Tensioner Pulley. The Tensioner is spring loaded, and is hard to rotate/move. 3. Remove the loosened belt off one of the other more easily accessed Pulleys. Standard Rules for Installing the Serpentine Belt: a. Pick a Pulley that is most easily accessed. This will usually be on top. This will be the last Pulley that the belt will go on. b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left, right etc. c. Using a Serpentine Belt Tensioner Tool or Wrench or Ratchet Tool: Rotate/Move the Tensioner Pulley/Arm "away" from Belt contact area on the Tensioner. This spring is pretty hard and with a new belt, it will be even harder to install. Rotate/Move this to as-close to the maximum ("open") allowed inorder to have enough slack in the belt to get it up and over the last pulley. d. While keeping the Tensioner Pulley/Arm "open" Using your other hand - Pull the Belt up and over the Last remaining Pulley. e. Before releasing the pressure on the Tensioner, visually inspect the remainder Pulleys and the Belts' Positioning on them. Let me know if this helped... Again my apologies..