Question about 1992 Isuzu Rodeo

1 Answer

Where is the fuel pump

Can't find the fuel pump on my 1992 isuzu bighorn

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 76 Answers

Fuel pump is in gas tank. hope this helps

Posted on Nov 01, 2008

2 Suggested Answers

stevenhurc
  • 450 Answers

SOURCE: I need advice on installing a new fuel pump 1992 Isuzu Rodeo

fuel tank has to be removed to remove fuel pump sender unit. make sure tank is near empty so its not as heavy to remove
some models have two round rings on top of tank, one is sender unit (for gauge) the other incorporates the fuel pump
others have one round ring which is both in one
remove the one near middle section of tank
be carefull not to bend float arm for sender unit if twin type (sender & fuel pump in one)

Posted on Jul 03, 2009

simontricket
  • 235 Answers

SOURCE: Isuzu bighorn diesel 4jg2 engine timing diagram

http://www.jeepolog.com/UserFiles/downloads/trooper_manual.pdf

This site has it .

Posted on Aug 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What's your question?what can cause an isuzu trooper(bighorn) not to start after changing the seal from the fuel pump common raill?


no year stated
no engine stated,
is this USA car, ?
if not need that, location, country.
im sorry not all bighorns have same engine...so.....

Feb 15, 2016 | Isuzu Cars & Trucks

1 Answer

1992 isuzu bighorn 3.1 turbo diesel, rebuilt injection pump, will not cold start


1: compression good.
2: glow plugs hot.
3: test fuel, does test fuel work??????
yes, you did it wrong
no, #1 or #2 caused.

Aug 27, 2014 | Isuzu Cars & Trucks

1 Answer

How to remove and reinstall an alternator for 1992 isuzu bighorn deisel


loosen alternator mount bolt (2 i recall) and remove tension adjusting nut. then the drive belt should be slack. take off belt, disconnect vacuum lines and connector, then undo mounting bolts.
remove alternator.
reinstall is the reverse process.

Jun 22, 2014 | 1992 Isuzu Pickup

2 Answers

I have a 3.1TD bighorn 5 speed manual, is it cambelt or cam chain ?


why not just log in to all data and not have us print out every page in the book.???
3.2 diesel with cam /pump belt

24593742-1k2qbj1z0ojvr1joorbx4qug-3-0.jpg

Jun 08, 2014 | 1992 Isuzu Trooper

1 Answer

ISUZU BIGHORN FUEL PUMP VIDEO


old post
sorry this is not youtube. not in the least.
why not google after all Google owns them. $1.5billion buy out.

and say what do you want to do with pump
play with it.
watch it shake, or buzz.
watch someone remove it and get a nice bath in gas. or worse.
or pump simulation video, Xray like, (how it works)

Jun 07, 2014 | 1998 Isuzu Trooper

1 Answer

1993 isuzu bighorn diesel engine holds revs to 3000 rpm for about 30 seconds and then dies


Do you think the primary fuel filter under the tank could be blocked or water is in the fuel?

Mar 25, 2014 | 1993 Isuzu Trooper

1 Answer

Sunroof not closing isuzu bighorn


OK given that this won\'t help the original enquirer but for all those who like me have had this prob and found themselves here well here\'s a solution that\'s not complex on all isuzu trooper/bighorns mk 2s ( as far as I know) early 90s have a manual over ride . You need a coin or flat head screwdriver and a 6mm Alan key. Now look above the the back seats in the middle you will find a little bung use coin / screwdriver to turn it out don\'t dig it out. Inside you will find a small Alan bolt turn with Alan key to open or close sunroof (Isuzu hand book 1992 page 4_17) PS there is a tool for the job located in the glove box if you still have it!!

Nov 16, 2013 | Cars & Trucks

2 Answers

I need a diagram of the timing marks on my Isuzu 4JB engine


I have just changed 3 Coils and 6 leads on my Isuzu bighorn 1992. The starter is turning when I keyed it, but there doesn't seem to be any electricity going through. Can you tell me what is the problem here?

Oct 14, 2009 | 1992 Isuzu Rodeo

1 Answer

How do you read the DTC´s from my Isuzu Bighorn 1992


a bighorn??should have an OBDII connection interface,then with the right software its not a problem.But by the time you pay for all that its cheaper to take it to garage

Feb 02, 2009 | 1992 Isuzu Trooper

Not finding what you are looking for?
1992 Isuzu Rodeo Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...