Question about 2003 Mazda MPV

1 Answer

Where is that

Where is code reader conector located?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 43 Answers

Under the driver side dash

Posted on Sep 29, 2008


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need pin locations for analdl connector for a 1996 pontic grand am


Below is a wirinf diagram for the plug. I wasn't sure which engine you had so I went with the 3.1 liter engine. If you need the one for the 4 cylinder or if you need this one bigger (this is the largest I can post on here do to size limits) you can email me at csautomotivecars@att.net but remind me of the make model year and engine size. Hope this helps.


11_16_2011_11_58_52_pm.jpg11_16_2011_11_59_18_pm.jpg

Nov 16, 2011 | 1996 Pontiac Grand Am

1 Answer

Changed radiator on94 honda civic now car


verify the plug of the fan and the fan switch located in termostat housing, if all are pluged in remove the conector of fan switch and short it with little piece of cable, if fan turn on replace the switch! it cost around $20. if the fan no turn on when short the conector verify if the fan conector have 12v if have it changer the fan motor if not check the fuse.

Jun 01, 2010 | 1994 Honda Accord

4 Answers

Where is the computer diagnostic port on a 1999 Park Avenue?


The o b d 2 connector is under the dash ,about where your knees set,on drivers side,but you have to use a code reader to access the codes.

Nov 24, 2009 | 1999 Buick Park Avenue

1 Answer

Where is the code reader located in 1997 nissan quest


You have to buy a code reader, there is no built in code reader for check engine light codes.

Oct 20, 2009 | 1997 Nissan Quest

1 Answer

OBD 2 location


does not have this obd 2 ,anything before 1994 does not have this ,u have a ald conector unde steering colum a code key will flash codes for repair

Jun 28, 2009 | 1988 Buick Regal

2 Answers

Is my 1994 ford escort have an obd or obd II


it might but the obdll starts at 96 and up,but there is another conector under the hood on the passenger side for check engine codes.you can buy a ford code reader to do that with there about 50 dollars.if it does have the obdll it should be under the drivers side dash

Jan 12, 2009 | 1994 Ford Escort

1 Answer

1st and 2nd shift error on code reader in trans


Shift error codes are enabled not only if the solonoids are faulty, does your scanner show you the solonoids switching? you could have a wiring fault. It could also be the pcm not allowing the solonoids to activate. These complicated systems are very difficult to diagnose for us profesionals with all the scanners and machines we have. Find a transmission shop in your area with a system to drive the vehicle bypassing the computor system, this will determine electrical or internal trans failure. But before you do anything check your conections from the transmission to the pcm. Also all the engine conectors and earth straps.

Dec 20, 2008 | 1997 Chevrolet K1500

1 Answer

Check engine light


yes there is, i need to fin directions to tell you how to, or you can buy an unexpensive code reader, they may still available at autozone, it is a little adapter than you plug to your diagnose conector and give you some flashes on led dependong on the code number like 2 blinks follow by small pause and 2 more blinks means code 22, let me know if directions need it.

Jun 27, 2008 | 1995 Mercury Grand Marquis

Not finding what you are looking for?
2003 Mazda MPV Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...