Question about 2003 Toyota Camry

1 Answer

FUSE PDL I JUST NOTICED THAT MY CAR IS MISSING A FUSE PDL5. Can you tell what is this fuse for?

Posted by on

  • lisa santos
    lisa santos Feb 11, 2014

    it the adjust pedal relay for the acc pedal position circuit

  • lisa santos
    lisa santos Feb 11, 2014

    on the gas pedal

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 98 Answers

Can you descrive the box? or the rows that are in and around it, i think it is your mirror heaters, the thing is if the fuse is removed then theres probably a short, i would just throw a fuse in there, make sure that there are metel where both pins go though and not just one on one side, the boxes some times have empty spots that are removed bacuase of the model, if its your insturment panel box inside the car (I/P box) and there are 5 in a row, then 4 next to that then 3 then 3 then 3 with other random relays around and the fuse is number 5 then that is the heated mirrors, a car model would help, but if i was you i would just throw a small amp fuse in there and see if it pops, but im guessing it is probably a empty spot for a accessory your car doesnt have. anyways good luck if you give me a specific car model i could be of more help, so let me know what ya do, thanks alot and take care
EriK

Posted on Sep 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Radiator fans not working


you should check fuses first if its been working good then i would dought if fuse jumped OUT of fuse box , there is a fan relay also , could be bad . swap out relay with a good one see if it works. you can also check temp sensor that tells fans to come on . good luck .

Oct 02, 2012 | 1968 Toyota Corona 1900

1 Answer

Door locks on doesnt not have any power and want work , how can i fix that? Its on a ford f-150 model 2005.


This is not real clear to me, sounds like the locks don't work when pressing the lock side of the button ( as in the unlock works ). If so, the lock actuator is most likely the cause.

If this is the PDL do not have power to them, did you check fuses 6, 40, 18 & 107 ?
The PDL are controlled by the VSM ( Vehicle Security Module ) which these fuses are associated with it. If you have a door keypad, does it still illuminate when you press a button ?

If installed, and it does not, could be the connector to the VSM or the ground to it. The VSM is mounted on the rear cab wall, behind the seat back in the Super Cab and Super Crew cab configurations. There is a thread in here on removing the rear seat, to get to it.

Usually the problems seen with the connector are for the auto lamps, so I would suspect the ground wire ( seen this 2 times, not real common ).

Apr 20, 2010 | 2005 Ford F-150

1 Answer

Setting up hill,have to let clch. pdl out to far an give alot gas pdl before it catches


sond like ur clutch is slipping pretty bad look on transmission for the inspection cover normally small rubber kinda like a nock out after u get that off look for clutch fibers b kinda like steel wool

Feb 10, 2010 | 1988 Ford Ranger

1 Answer

I have an amplefier install in my nissan sentra 08', I was moving the wires to make more space and it made a spark. then when I notice the amplefire was shut off, when i turn my car on my fron panel light...


You have a blown fuse somewhere. Find an electrical schematic and figure out which circuit controls the panel light. That will tell you which fuse to replace. Sometimes it is difficult to see that a fuse is blown. Unless you do a continuity test, you might miss it.

Oct 22, 2009 | 2008 Nissan Sentra

1 Answer

No main engine fuse, fuse pump fuse


this model dont have fuel pump fuse , the ecm supply power to pump, check EFI fuse 15amp , if good, then remove rear passenger seat, to check the fuel pump , give me for notice please

May 03, 2009 | Lexus ES 300 Cars & Trucks

2 Answers

I keep hearing a pop when I turn a corner.


a single pop sounds like a possable ball joint. although a click click click would indicate a cv axle an alignment shop would be able to tell

Mar 18, 2009 | 2000 Ford Explorer

1 Answer

Fuse diagram is torn off the cover


turn the blower on put a fuse in every holder see if the blower comes on,bit off trial n error

Jan 06, 2009 | 1993 Saturn SL2

Not finding what you are looking for?
2003 Toyota Camry Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...