Question about 1992 Toyota Camry V6

1 Answer

92 Toyota Camry V4

I have problem with the noise in the rear passenger side door makes noise while try to open the power lock and how to remove the door panel?best regards.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Sounds like the power lock actuator is going.On some cars it's part of the door latch and somethey are sep.. To remove door panel remove all the srews and pull out on panel. actuator is in lower corner of door. should be easy to find just use power locks and listen.

Posted on Sep 13, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Describe how to replace a 96 camry rear passenger door power lock actuator


You will need to remove the door panel, mounted inside the door you will find the lock actuator, it should have a rod connecting attached to the lock cylinder, also there should be an electrical connector. Disconnect the rod and the electrical connector and remove actuator from the door.

Mar 10, 2010 | 1995 Toyota Camry

1 Answer

96 Toyota Camry keys are not working to open locked door from outside. First the passenger side and now the driver's side door.


Try spraying some silicon lubricant into the keyhole and slide the key in and out a few times.

If this does not work you may have to remove the interior door panel and trouble shoot the lock mechanism.

It's also possible the lock cylinders are worn and need to be rebuilt. This can be done by a qualified locksmith (look for a AAA certified locksmith). Or you can order new lock cylinders and get them re-keyed to match your ignition key.

Dec 16, 2009 | 1996 Toyota Camry

1 Answer

I have a 1998 toyota coroloa LE and the passenger side power door locks dont work . I would like to replace them. Also, the power window on the front driver and passenger side dont stay completly up and...


Hello. The power windows each need a new window motor assembly which includes a new track system. The advantage to the assembly is that it is very difficult to remove the motor and install a new one. the power door locks on the passenger side the most likely cause is the power door lock actuator, about a ten dollar part.

Nov 24, 2009 | 1998 Toyota Corolla

1 Answer

Automatic passenger door lock


You should replace power door lock at front passenger side, you can use any 'universal' power door lock. its an unit with a small motor inside that have a mechanism to up and down according electricity from the actuator (master door lock at driver side)
Hope this help :-)

Sep 13, 2009 | 2005 Toyota Corolla

2 Answers

Need instructios to repair 1997 Toyota Camry Broken Exterior Door Handle


Two 10mm bolts, or nuts, hold the handle on from inside the door. dont forget to remove actuating rod from old handle. probably clip is broke also.

May 30, 2009 | 1997 Toyota Camry

1 Answer

All doors open and close with remote except the passenger side ?


Sounds like the most likely cause is the electronic lock actuator is bad. will have to take door panel appart to check.

Jan 09, 2009 | 2000 Toyota Camry

1 Answer

Door lock passenger side


The power door lock actuator is bad.

Dec 24, 2008 | 1997 Toyota Camry

1 Answer

Failed power window


I'd bet on a broken wire in the harness going to the drivers door. I suggest the drivers door because it is used the most often. You can pull the master switch and check the wires for continuity to the harness just under the dash at the fuse box, after removing the lower dash trim panel. Sometimes you can gently pull on the wires of the door harness from under the dash and one will pull right out. Thats how I found mine.

Jul 08, 2008 | 1992 Toyota Camry V6

1 Answer

2003 toyota camry se


You may have inadvertantly locked the passenger windows by pressing the little button to the right of the door locks (on the driver side). It's a push to lock/push again to unlock type button, so try pushing it--if it stays down, then that wasn't the problem. If it comes up, then try the window. I hope that helps

Jul 03, 2008 | 2003 Toyota Camry

1 Answer

92 F150 power window and locks


try taking apart and cleanig all contacts first. make sure you are getting power to switch. Sounds more switches are going bad. They usually last about 5 to 7 years before they start going out.

Jun 11, 2008 | 1992 Ford F150 SuperCab

Not finding what you are looking for?
1992 Toyota Camry V6 Logo

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...