Question about 2003 Buick Rendezvous

2 Answers

2004 rendezvous anti- lock brake light came on then awd alarm came on trans wont shift upon acceleration kind of bogs when accelrator is pushed

Posted by on

  • ozzmosis007 Sep 12, 2008

    can"t read the alarm code nothing shows on the readout

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I was wondering did u ever figure out the problem to your car???

Posted on May 25, 2013

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Pull the rear wheel off and check the conector and wires going to each wheel. Each wheel has a wire pair going to it. The connector could be pulled out or the wires might be worn through.

Posted on Oct 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

WHEEL BEARING REPLACED NOW THE AWD AND ATL LOCK LIGHT ARE ON AND MY CAR WONT GET PAST 30MPH, IF I TRY TOO FAST


Buick Rendezvous Service Traction system and Anti-Lock warning ...

forums.edmunds.com > Buick > Buick Rendezvous
Jul 15, 2007 - 31 posts - ‎19 authors See Also: Buick Rendezvous FIX Trac Off ABS warning light DTC sensor hub wheel.... For the service traction,ABS,AWD lights it may be a wheel speed sensor (also .... I drive a 2004 Buick Rendezvous with about 120K miles.Missing: atl

Sep 12, 2015 | 2004 Buick Rendezvous

3 Answers

The anti-lock light is on and it is causing the awd to disable what should I do?


If the ABS is causing the AWD to come on. Scan it and find out which wheel sensor/bearing is bad, replace it. This could happen. Most AWD lights are because the sensor/actuator in the rear axle assembly is bad. A high dollar part.

Jan 03, 2015 | 2003 Buick Rendezvous

1 Answer

I'm replacing the shift solenoid in my 2004 Buick Rendezvous but I can't find any diagrams showing the location or how to change it out. Can you please help?


WHen you refer to the shift solenoid, are you meaning the solenoid that locks and unlocks the shift lever? If so, before you change this, check if your brake lights are working! A common fault for this solenoid to not work is either a blown fuse or failed brake light switch- the solenoid is activated by you pushing the brake pedal which sends its signal from the switch!

I hope this helps? Good luck!

Nov 11, 2013 | 2004 Buick Rendezvous

1 Answer

AWD Disable light came on as well as Anti-lock brake light


the lights going on might also be a warning light for low brakes. if less than 25% remaining the other possibility is sensor issues with anti lock and awd

Sep 18, 2013 | 2006 Buick Rendezvous

1 Answer

Hi, I need to reset the awd,low tire pressure and abs alarms on my 2003 buick can you help me


Any good parts store like Autozone, Advance, etc... can reset your AWD and low tire lights. The abs is sensing a problem with your anti lick brake system - they normally do a "self test" when you start up and reset themselves if "All Systems Go". RE: ABS check wheel sensors etc, and a note on others if reset is done and lights/alarms returns then you have a problem within those systems.

Mar 08, 2011 | 2003 Buick Rendezvous

1 Answer

Brake pedal seems to vibrate or pulsate when pressing brake and brake pads in front and rear have been checked and are still good. Now, the anti-lock light is on and AWD has been disabled. What is the...


FRONT ROTORS WORN OUT.IF ABS AND AWD NOT WORKING THE DEALERSHIP HAS TO FIX.BECAUSE THEY HAVE TO USE DIAGNOSTIC EQUIPMENT TO TROUBLESHOOT AND FIX.

Aug 14, 2010 | 2002 Buick Rendezvous

1 Answer

When i press on the brakes it makes a crack sound and also the awd light is turned on and anti-lock light is turned on


I would look into a possible wheel bearing. Most also incorporate the abs sensor in them. (Anti-lock)

Aug 11, 2010 | 2002 Buick Rendezvous

1 Answer

Anti-lock n AWD


Call the dealership. I seem to remember that Pontiac had a recall for this problem just recently where the antilock brake system would lock op and the system caused people to get into accidents. This is a manufacture defect

Feb 16, 2009 | 2004 Pontiac Aztek

3 Answers

Buick rendevousz headaches


I own the 2002 Buick Rendezvous CX and I've encountered the same problems listed here. The ABS / Traction Control Lamp stays on and was throwing a code for the left wheel speed sensor as well as an anti-lock brake code (both in the wheel bearing hub assembly). I replaced the left and right front wheel hub assembly yet this did not eliminate the abs codes. 
Ultimately, I traced this problem to a break in the wire that leads to the left hub assembly. Although the sensor was properly connected, the wire (which is encased in a plastic housing) was broken. This is the wiring which leads from the abs wiring harness under the hood down to the left wheel abs sensor. 
I would suggest that you simply remove the left wheel and inspect the wire that leads to the abs sensor (there is only one wire on each wheel). Mine literally fell apart when I removed the plastic housing around the wire. I spliced the wire together and put it back in the plastic housing. After this, my abs codes disappeared and my anti-lock brakes began working again!
This is a simple fix that many people spend $1000 + on by replacing the hub assembly which does not fix the problem.

Aug 20, 2008 | 2002 Buick Rendezvous

Not finding what you are looking for?
2003 Buick Rendezvous Logo

236 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...