Question about 2007 Jaguar XK Convertible

Open Question

Recurring fault in 2001 XKR Jaguar fault code/s PO400, P1642, P1797

Faults can be cleared by electrican but continue to return. Fault P0400 is EGR flow and has been taken apart,cleaned and worked ok for 2 months now engine fault is again displayed.MPG is less than my 1998 Daimler Super8 which is a bigger car. Is it possible to ditch the EGR setup and run without all that junk?

Posted by on

  • oscardog Sep 13, 2008

    I find it difficult to believe that a long distance solution can be achieved, not that I regard it as impossible. Let's see if anyone has a similar problem and then review the situation. Jaguars are beautiful cars but are plagued by shonky engineering.

×

6 Suggested Answers

  • 4 Answers

SOURCE: need to clear fault codes on jaguar x-type 2.5

disconnect the battery for 10 minutes.

Posted on Jul 27, 2008


  • 1 Answer

SOURCE: GEARBOX FAULT MESSAGE

i had the same problem with my s-type, when i went to jaguar dealer for diagnostic and they told me it was trans problem, need new trans and will cost me $4500 to fix it, so i think you will be better off looking for a salvage trans to put it in your car, it will cost you around $1500-$2500 including labor. i hope that will help some of you with gear box fault massage. oh try and find some one who knows a lot about jaguar before you send the car for trans repairs.

Posted on May 15, 2009

  • 599 Answers

SOURCE: 2005 Jaguar X-type p1796, p1797 fault codes -

both of these codes refer to the transmission,it is now in LIMP HOME MODE,the codes refer to open or shorted circuits in the CAN (controlled area network) the computer system in the car. check for blown fuses first,then have the car scanned with a european scan tool which is capable of bi-directional communication with the vehicle,get back to me if you need more help,Please rate my fix as i strive to be the best Thanks Ray

Posted on Dec 09, 2009

  • 1 Answer

SOURCE: Jaguar x type 2004 2.5 petrol V6, 38500 miles, codes P0171, P0174

Have exactly the same issue on 04 jag x type 2.5. So far have replaced fuel filter, air filter k&n, plugs ngk. Codes cleared, same issue. Seems to appear when air temp is cold and eng is warm.
Am replacing upstream O2 sensors and cleaning MAF next. Will keep you posted if it clears up. Did you ever find the cause?

Posted on Mar 07, 2010

alicantecoli
  • 21936 Answers

SOURCE: Have P1642, P1797,P1000 codes showing,

sorry but none of these codes appear in teh jaguar code list but in the generic code list which i have just checked they dont exist either so contact the code reader manufacturer

Posted on Feb 10, 2011

whitehead195
  • 1 Answer

SOURCE: 2002 Jaguar X-Type Engine Faults, Gear box fault,

I have a problem with my steering lost some fluid and steering very stiff

Posted on Jun 03, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

99 maxima ran till it was parked now it turns over will not start gave code p0400 any ideas


The fault is somewhere around the EGR valve - probably the EGR valve or the throttle position sensor.

Before replacing any sensors try removing and cleaning the EGR.

Here's a Youtube link that may be of help to you:

1999 maxima egr Google Search

This link explains about the EGR:
P0400 Exhaust Gas Recirculation Flow Malfunction

CEL code P0400 EGR Flow Malfunction

Mar 27, 2016 | Cars & Trucks

1 Answer

I have 3 codes , po400, po443 & po135 have very low gas milage w/surging


PO135 is your EGR valve, P0400 = EGR Vacuum Leak, (EGR valve may need replacing, or may just have a hole somewhere in the EGR vacuum line ..
PO435 = Air Canister Purge. ( possible water in your air canister needs to be drained).

Jan 08, 2016 | Cars & Trucks

1 Answer

Po400 code


P0400 code is for EGR(engine gas recirculated) flow malfunction.
need to clean EGR canister.

May 02, 2012 | 1998 Nissan Frontier

1 Answer

I HAVE A MITSUBISHI MIRAGE 2000, IT HAS LIT THE CHECK ENGINE AND I TRY TO SEEK FOR THE PROBLEM, IT GIVES ME THE P0400 CODE, HOW CAN I FIX IT??


po400 is egr flow malfunction-- to fix, remove egr and clean the port where it sits, its probably full of carbon. then clean egr as much as you can. and check the wires to it. if above does not cure problem, replace egr valve. have a good day !

May 10, 2011 | Mitsubishi Mirage Cars & Trucks

1 Answer

Have P1642, P1797,P1000 codes showing, what are these codes? Thank You


sorry but none of these codes appear in teh jaguar code list but in the generic code list which i have just checked they dont exist either so contact the code reader manufacturer

Feb 10, 2011 | 1999 Jaguar XK8

1 Answer

Car won't start. Error codes - p1000, p0452, p1642


The following results can be found on http://www.blujag.co.uk and would appear to indicate a fuel system problem. hope this helps
Fault Code P0452
Indicates a Generic Power-train fault
The fault is generally due to a problem in the Emission Control area
Fault Description: Evaporative Emission Control System Pressure Sensor Low Input
Fault Code P1642
Indicates a Manufacturer Specific Power-train fault
The fault is generally due to a problem in the Computer & Output Circuit area
Fault Description: Fuel Pump Monitor Circuit High Input

Jul 16, 2010 | 2003 Jaguar Xkr

2 Answers

1995 millenia fault codes PO400 and PO 115what has to be done to fix these.


The P0400 has to do with a fault in the EGR (Exhaust Gas recirculation) system. The possible cause is leak or blockage, wiring, EGR Valve or EGR solenoid or the ECM.
P0115 has to do with the ECT (Engine coolant sensor) possible causes for this fault is wiring or the Engine coolant sensor itself or the ECM.
I believe I have the testing for both of these if you need them. Send me your email and I will send you the test procedures if you are familiar with how to use Ohm meter and a vacuum tester.
outdoorsman592003@gmail.com

Sep 15, 2009 | 1995 Mazda Millenia

1 Answer

Ck engine code po400


HI
P0400 :- (EGR) exhaust gas recirculation system -flow malfunction
the mine function of this system is economy of fuel and
keep clean air with low emission of bad gases and
hydrocarbon by recirculate the exhaust gas to the engine
intake to re burn the unburnt fuel
the problem cause from :-
hose leak \ blockage , wiring , EGR valve , EGR solenoid , ECM

WITH MY BEST WISHES

Jul 02, 2008 | 1996 Mitsubishi Mirage

Not finding what you are looking for?
2007 Jaguar XK Convertible Logo

Related Topics:

550 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...