Question about 1991 Lincoln Town Car

1 Answer

Door how do you say at were the door close, the thing of iron were is locked the door, is a piece of iron with lastic, were I can buy this piece of plastic or how is the name of this part. Sorry for my english, I m from Matamoros Mexico across from brownsville texas

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 397 Answers

El nombre in Ingles es "Striker Plate"

Posted on Sep 12, 2008


Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda 1996 lx prestige passenger door lock dose not work ether with key button our buy pushING down on


Need to take inside door panel off and look at inside door latch. The locking rod probably broke at door latch. Or it lucky unhooked. To find whice rod it is. You may need to cut hole in platinum sheet near door latch. Then move one left to right. One will lock it and one will open door. Then check to make sure both ends are connected on the lock rod. Almost sure it is the small plastic piece broken of door latch. And when taking inner door panel off. Make sure all screws are out. And use flat screw driver next to plastic tabs to pop them out. If careful everything will go back together easy.

Jul 11, 2016 | Mazda Cars & Trucks

1 Answer

Front Doors LOCKED OPEN.. How to close?


Lift the door handle as if you were opening it

Hold the handle & use a round phillips to hook
& rotate the white door latch to the open position

May 18, 2014 | 2009 Honda Odyssey

1 Answer

Hi I keep having the same problem with my land rover discovery series I, for some reason a little piece of plastic inside the door handle keeps breaking I've already replaced it once and now its broken...


I am guessing that the plastic bit is what holds the wire /rod in the hole of the lock lever It is a common connection piece in lock manufacture. If that is the case the piece that breaks is the bit that clips around the rod section(the clip fingers break off). Two fixes spring to mind is to use a piece of small wire (paper clip ) reposition the clip and tie to rod ( small zip tie may be easier) or 2 there are metal clips that do the same job( Mazda early models use these) but you could possible get them from a panel repair shop

Jun 20, 2013 | Cars & Trucks

1 Answer

Mazda 3 2010 driver's door locked and won't open


This is what fixed the my car's driver's door that was stuck closed and locked: the plastic piece that function as the manual lock/unlock on the inside of the door (it's black but when the door's unlocked it has a red side facing out) had essentially popped out and everything was jammed. So you push the button back in while you flip the inside handle open. But maybe I was lucky, in that it was only the button that was jammed.

Feb 03, 2013 | 2010 Mazda 3 1.6

1 Answer

The alarm on my 2003 acura tl randomly goes off once it has been set. Any cure?


Have you checkd your fuses & also there is a small plastic/rubber piece somewhere on the driverside door, either on the actual door or on the car frame itself that once u close the door, that peice tells the alarm that its ok to lock and arm. (i dunno if u noticed but u can manually lock ur car w/ ur keys in the ignition, running, only if driver door is closed, from any other door usung the lock button, but not if the driver door is open) If that peice n ur door is worn, eventually it will break causing u to have to use ur key to unlock ur car. BUT, doing that will not disarm the alarm only unlock ur car & it will sound every time & not stop until u pull the fuse to the horn & lights. i had to bring mine to a dealership to get it fixd bc I couldnt figure it out. Paid $300 for a $25 piece of plastic I could have changed myself. Hope this helps..... good luck.

Aug 23, 2009 | Acura TL Cars & Trucks

2 Answers

93 jeep door lock Broken


It might an easy fix...

I had the same problem and it ended up that it only was a metal rod that was unhook from mechanism...

-undo your inside panel by pulling on it
- check the mechanism...

Be careful there is some small plastic pieces that breaks easily after 15 years of life!

hope this helps!

Mar 27, 2009 | 1993 Jeep Wrangler

1 Answer

Rear Door Electric Lock buzzing and stuck


It's the power lock solenoid. There is a tiny plastic piece that connects the solenoid (motor) to the door lock mechanism (thin metal rod or two). Likely, the plastic piece has become disengaged. This is by design so that if there is a problem with the mechanism the motor does not burn out. You will need to have the interior door panel removed to gain access to the interior of the door and the lock rod and solenoid need to be reconnected. The plastic clips used to go for $1-$2 when I worked in auto parts.

Jan 13, 2009 | 2002 Dodge Durango

1 Answer

I cracked the plastic component that is attached to the bottom of my radiator - a hose connects to the platic component - Is that plastic piece a part that I can buy and replace or do I need to replace the...


I assume you are talking about the lastic side tank on the radiator. A radiator shop can repalce the end tank. Call for a price quote first.

Jan 12, 2009 | 1998 Volvo S70

3 Answers

Jetta 2003, trunk won't lock


More than likely the spring inside the latch has come undone. To save some money you can remove the latch from the trunk, open the latch and reset the spring. To Remove the latch you will need to remove the carpeted cover on the trunk lid (there are about 10-15 phillips screws holding it on.) Once the cover is off disconnect the rod going to the latch by opening up the clip thats connected to the actuator. Disconnect the wire harness, Remove the 2 10mm Nuts holding the latch to the lid. Remove the black plastic cover on the latch and remove the electrical piece (the plastic cover wraps over the latch and is secured buy 2 plastic pressure snaps). Look down into the latch and you should see a small spring...on my Jetta the spring wasn't connected. take a small pointed object ( I used a light tester) and reattch the spring to the black hook. Mine had some broken plastic in it and After I removed that it worked fine. Once the spring is back into place reassemble the trunk and you should be good to go. No money spent, and it only takes about a half hour or 45 mins to do.

Dec 01, 2008 | 2003 Volkswagen Jetta TDI

1 Answer

Rear power window will not roll up and can not get door pane off to service, located right rear door


To take panel off you.
1.Unscrew door lock knob.
2.Open door, look where it latches,Take the little black piece off.
3.There is a U-shaped plastic piece at the top of the handle you close the door with,Carefully pry it out.
4.Take the 10mm bolt out.
5.The black plastic piece that holds the chrome handle you open the door with,Slide it to the right.
6.Lift the whole panel straight up.
7.Unplug window switch.
If you pull out the door clips will pull off, You can glue they back on with some 2 part apoxy.
Good Luck

Jul 26, 2008 | 1989 Mercedes-Benz 190

Not finding what you are looking for?
1991 Lincoln Town Car Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...