- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
sounds like one of light bulbs was malfunctioning and caused the flasher unit to blink rapidly and iy burned out. Replace front and rear turn lite bulbs and see if flasher flashes. if not check fuse and replace fuse. If fuse okay replace flasher unit. Good luck
Hello. On a turn signal if the light turns on when the blinker is moved to the left or right, more than likely it is a turn signal flasher. Make sure bulbs are good. If it is a bad bulb the flasher would flash faster. Check flasher. good luck
I don't have your wiring diagram, but often, the turn lights and the flasher circuit use two different fuses, so it is not surprising that one would work and the other doesn't.
On a car this old, you are looking not only for burned fuses, but also corroded fuses. Pull the fuses out and examine them for corrosion, and clean their sockets.
Sometimes turn signals will not blink if you have a bulb out (insufficient current flow to trigger the blinker circuit) so if you have a bulb out on each side, that could cause both sides to fail to blink.
IF TURN SIGNAL LIGHT DONT WORK SOME TIMES.CHECK FOR BLOWED OR LOOSE FUSE.CHECK TURN SIGNAL BULBS AND CHECK BULB SOCKETS FOR CORROSION.CHECK TURN SIGNAL FOR BAD GROUND.USE JUMPER WIRE BETWEEN GROUND SIDE OF THE TURN SIGNAL BULBS AND A GOOD CHASIS GROUND.IF ALL IS GOOD TURN SIGNAL SWITCH IS BAD OR FLASHERS GOING BAD.TURN SIGNAL FLASHER LOCATED ON CENTER CONSOLE SIDE PANEL GRASP THE FLASHER UNIT AND DETACH IT FROM THE FUSE BOX.IF YOU HAVE EARLY MODEL VECHICLE FLASHER UNIT LOCATED AT THE FRONT OF THE FUSE BLOCK.
In the fuse panel with the fuses inside the car there are two big round units plugged into the fuse panel, one is your turn signal flasher one is your hazard flasher. I would start with those and move to other things if that doesn't fix it. Hope this Helps.
you need to check to see which bulbs don`t work both front and back lights for the signal on the side it`s not working,you don`t say if any signals work or not if no signals work then you need to check the fuses under the dash on the driver`s side.now if it`s just one side then check the lights as mentioned above.if one isn`t then replace the bulb.if neither bulb is working then it sounds like the signal flasher is not working.turn on the hazard flashers and check the lights front and back.if all bulbs work then leave the hazards on and look under the dash for the flasher that is making the noise,this will show what the signal flasher will look like,then find the signal flasher on the fuse panel under the dash it should be located on the fuse panel.and replace
replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher