Question about Mitsubishi Outlander
I have had the same problem. I changed fuel filter, added fuel injector cleaner, still runs rough as hell at a idle. Didnt think it could be the fuel pump, because ran ok at hiway speeds, it only stalled when giving less gas, not more. So in theory I figured couldn't be fuel pump. I was so wrong. At hiway speeds you have inertia, engine is running faster already etc. Its the fuel pump. 90% of the time in GM cars thats what it is when it behaves this way.
to change the fuel pump:
In the tank, the following is a run down of how to replace it..
This is actualy a pretty involved repair. You have to have the car jacked up on all 4 corners, or up on a car lift. Disconnected battery, and it is recomended you have as much gas as posible drained from the tank. Then underneath the car you will find the tank with 2 staps holding it in place. Those staps should be taken off or at least out of the way while the tank is being supported. There are vacume lines, the fuel fill and vent lines, and the wiring harness that all have to be unhooked. Once you are sure that all lines are disconnected, drop the tank and pull to the side. Wash the top of the tank off, there will be dirt and rocks on top of it, and you need to get all of these out of the way. You will see where the wiring harness goes into the fuel sending unit. Around that peice is a slide ring that has to be gently hammered counter clockwise. Once it is free from its retaining clips, the fuel sending unit will have to be wiggled out very carefully. Once out, you will see the fuel pump mounted in line on the fuel sending unit. You will have to work out how its mounted in line, and get it off and unplugged. Reinstall the new fuel pump and reverse the procedure.
Lock ring O-ring
Posibly the fuel sending unit if you were having problems with your gas gauge.
Hope this helps!
Posted on Jul 24, 2008
Hello acook2222: My name is Roger and I can help. You will find the fuel filter on the right side of the van.It will be found on the right side frame rail between the fuel tank and engine. Will be held in place by a band clamp with a 13mm bolt through the frame. Should you need further help please just ask. Please rate the answer you received. This wat I know the answer was helpful. Thank You for using Fix Ya. Roger
Posted on Oct 29, 2009
SOURCE: pajero keeps cutting out
sounds like injection pump seals want changing mine is same not got round to doin em yet but it will just get worse ,very common on pajero's seal kit not expensive bout £20 if ya can do it ya self other than that ya prob lookin at £200-£300
take a look at www.pocuk.com
Posted on Nov 04, 2009
Tips for a great answer:
Jun 11, 2016 | 1997 Mitsubishi Pajero
Jun 02, 2013 | 2011 Ford F-250 Super Duty
Feb 25, 2013 | Cars & Trucks
Dec 03, 2012 | Cars & Trucks
Dec 10, 2008 | 1994 Buick LeSabre
Sep 26, 2008 | Mitsubishi Outlander Cars & Trucks
562 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: