Question about 2002 Suzuki Aerio

1 Answer

Idle air control valve

Need to replace one but the part is $300.00 It looks just like one from a 2002 ford ranger for $60.00 any chance they are the same??

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 56 Answers

It could be the same the connector,shape but the difference is the certain ohms for different cars

Posted on Sep 11, 2008

1 Suggested Answer

  • 33 Answers

SOURCE: 2002 ford ranger 4.0v6. fuel economy loss, rough

Burnt valve problems. Get header work performed.

Posted on Apr 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix fault code P1507


Possible causes
- Faulty Idle Air Control (IAC) valve
- Idle Air Control (IAC) valve harness is open or shorted
- Idle Air Control (IAC) valve circuit poor electrical connection
What does this mean? Tech notes
The P1507 code means that the engine idle is out of factory specification. Sometimes the Idle Air Control (IAC) may have carbon built up. Disconnect the car battery, remove the valve, clean, re-install valve, and drive the vehicle for about 5 minutes with the headlights and A/C ON to get the idle relearned.
If the problem persist, the IAC valve may need to be replaced.

Read more: http://www.engine-codes.com/p1507_ford.html#ixzz3sFPyZe00

Nov 22, 2015 | 2000 Ford Ranger SuperCab

1 Answer

Ford Ranger doesn't idle when engine is warm. Why?


is the check engine light on is so have code read 1st-second try cleaning the throttle body where air goes into the engine where the rubber hose attaches clean with a throttle cleaner wipe cleaner out i say this due to the idle air control motor may be dirty,and last you may have a faulty egr valve

Feb 18, 2013 | 2002 Ford Ranger

1 Answer

92 ford ranger when first started excessively high idle


Could be a vac leak, or a faulty idle air control valve on the throttle body.
The computer controls idle speed by regulating the amount of air entering the intake.

Sep 23, 2012 | 1992 Ford Ranger

1 Answer

2003 ford ranger intermittent idle


One possibility is a buildup of dirt and sludge in and around the idle air control valve. The buildup causes the idle air valve to stick.

Jun 24, 2012 | 2003 Ford Ranger Regular Cab

1 Answer

Code P1537$10 whats code and how do I fix it,it is on a 2002 ford ranger with 2.3 liter engine.


DTC P1537 - Intake Manifold Runner Control Stuck Open Bank 1 and 2

It controls the length and speed of incoming air for a certain engine rpm to optimize swirl, efficiency, and minimize knocking. It's long and fast for low rpm and idle, short and large volume for higher engine loads. How's your truck running? I'm guessing it would be lean at idle if it's stuck open. I would look at your vacuum lines on the intake manifold. I think it would be vacuum operated.

Keep in mind that the IMRC Valves are located on the back of the intake and are listed as an item that the dealer needs to diagnose and repair.

Hope this helps.

Oct 06, 2011 | 2002 Ford Ranger Regular Cab

1 Answer

2002 ford ranger starts cold. will idle fine but dies after i rev it up, then will not start again. replaced plugs, plug wires, and battery.


When the engine is idling, listen very carefully to with the hood open for something that sounds like rushing air. There might be a vacuum leak on the engine (all you need to do is make sure the vacuum hose is tight). This should be a rubber hose that plugs onto a hose barb or into a small hole in the engine. There is a piece call the pcv valve that you probably need to replace if you don't hear any air leaks.

Jun 09, 2011 | 2002 Ford Ranger Regular Cab

3 Answers

My 2000 ranger idles really low and sonetimes even dies. ihave to push gas pedal little bit to get it started


The Idle Air Control (IAC) is not working.... This is a very common problem and very easy to fix. The IAC will run you about $50 (USD) and the only tools needed is a 8mm socket. Disconnect the electrical connector, remove the 2 8mm hex screws, remove IAC. Reverse order to install.

It looks like the picture below


dttech_6.jpg

Mar 25, 2011 | 2000 Ford Ranger SuperCab

2 Answers

2004 Ford Ranger Low Idle


I figured out what was going on. supposedly on ford rangers the Idle Air Control Valve (IAC Valve) goes bad. i got a trouble code looked it up and sure enough it is the IAC Valve. Under 100 bucks for the part

Jul 04, 2008 | 2004 Ford Ranger

Not finding what you are looking for?
2002 Suzuki Aerio Logo

Related Topics:

330 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...