Question about 2002 Toyota Camry Solara

1 Answer

Light out on the shifter between the seats

How do you get to the bulb on the automatic shifter between the seats. I get the woodgrain look plastic off, but can't find the bulb.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 178 Answers

The bulb should be mounted under the plate were it says the gear letter you might have to look from the side not straight down

Posted on Sep 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace gear shift light bulb in a 2001 toyota echo


The center console piece around the floor shifter should normally be held in place with plastic clips ( some are held with screws ) and should just pop up with a gentle tug. The bulb can then be accessed for replacement

Apr 11, 2015 | 2001 Toyota Echo

1 Answer

Gear shift light


there is a bulb underneath the shifter panel-pull up the plastic around the shifter and look for it underneath the shifter- it should be a 168-or 194 bulb- cheers Denny

Nov 22, 2013 | 2003 Chrysler Sebring

1 Answer

How do i replace gear shift light bulb in 2004 toyota sienna?


I just replaced the bulb on my 2004 Toyota Siena XLS. This is the bulb under the shifter plate in the center of the dash just above the center glove compartment. It was pretty easy once you have the process. Remove the trim on both sides of the radio in my it was the plastic wood trim. This will expose a 10mm screw on the right at the bottom of the part you just removed. You should use a panel remover tool or in my case the iPhone repair kit tool worked great. You need to turn on the ignition and move the shifter into numeral. Unscrew the shifter knob. Remove the plastic cover over the shifter with the seat heat and power adapters. This is one piece and it's held on by 4 clips. The bulb is just under the shifter panel and you turn it 1/4 of a turn to remove. The part number is 90981-11040-BULB and you will only find it at Toyota.

Nov 11, 2013 | Toyota Cars & Trucks

1 Answer

How do you replace drive indecator light


1. Lift the little carpet in the console rear to the automatic gear shift. Pry with a small flat screwdriver will do the job.2. Remove the three Philips head screws.3. Remove one Philips head screws on each side of the rear console, they are located at the bottom front of the rear console panel. You may have to move the driver and passenger seat back to see the screws.4. Grab the back of the rear console and gently wiggle, pull backward and lift upward. Pull the hand brake so it is easier to remove the loosened rear console panel. 5. Use a flat head screwdriver to pry the rectangular 'cushion' around the automatic gear shift. Gently pry at various spot and the rectangular 'cushion' will come off easily.6. Now you are just one more plastic cover away from the burned bulb. The plastic cover that has those 'P'ark, 'R'everse, 'D'rive letters is held in place by four snap on latches. Use a small flat head screwdriver and gently push the black latches inward in a downward motion, once the screwdriver head gets inside the grey latch holder it will free the black latch. Work on each of the four latches in turn.7. Wiggle the plastic cover until it is completely loosened from the four latches. Gently lift the plastic cover up. The automatic gear shift will stop the plastic from being lifted out completely. You still have enough room to work with. You will see the little burned bulb directly below those 'P'ark, 'R'everse, 'D'rive letters. Gently pull the bulb out. I got my replacement bulb at Canadian Tire, Motomaster instrument replacement bulb 194LL (clear, long lasting, 2 bulbs for $2.99Cdn). It is a push-on bulb.8. Test the bulb by starting your car and dash lights.9. Snap back the plastic 'P'ark, 'D'rive cover. Put back the rear console panel and finally the rectangular 'cushion' around the automatic gear shift.

Dec 17, 2011 | 2006 Toyota Corolla

1 Answer

Indicator light for the automatic transmission doesn't work and how to fix it?


take off the shifter handle then the shifter plastic base and you will find a light bulb in there replace it.

May 17, 2011 | 1997 Honda Civic

1 Answer

Removing an automatic gear shift out of a sc400


position the shifter into the drive position, pull down on the plastic trim directly underneath the leather portion of the shifter. theres two phillips head screws behind that. remove the shifter knob and the plastic piece. the trim will pop out if you pull directly upwards, disconnect the heated seats(if you have them) and the trac button. hope that helps.

Jun 09, 2009 | 1997 Lexus Sc 400

1 Answer

No light under console shifter


Half the answer?

There is a small access panel to the right of the shifter where a small flathead screw driver can be gently placed. Pry out the plastic panel. Now gently work the black trim off that surrounds the shifter using the inside of the hole that you just opened.

The trim will pop up. The silver piece of plastic will pull up. (The part that the shifter works through.) Now you can pull up the piece of plastic that has the gears listed on it. Set this aside. There is a small led bulb under this piece- to the left of the shifter.

Now, I have no idea how to get the bulb out. I have tried prying it out, and I broke the bulb, but it did not work anyway. My point is be careful because the glass went everywhere. Wear eye protection. I am stuck at this point.

There is a piece of black plastic around the base of the bulb, but I cannot figure out how to remove the bulb itself. Access is tight. The bulb is in a "ditch" of plastic with no real room to work in.

I tried to remove the armrest, but there is no access from this side.

Mar 15, 2009 | 2000 Acura TL

2 Answers

Automatic Gear Shifter Light Burned Out


You shifter indicator bulb (194 bulb number) has burned out. Pretty easy and cheap fix. The top of the indicator has to be removed/lifted up and teh bulb needs to be replaced.

Oct 24, 2008 | 2001 Nissan Sentra

Not finding what you are looking for?
2002 Toyota Camry Solara Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...