Question about 2004 Chevrolet Avalanche

1 Answer

Bad break light

Left break light works but not the right can you help...

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 405 Answers

Have you checked the bulb on the side? Remove the bulb and check the filament, replace if nesacary. If it is not the bulb then it is a wiring issue on that side, and it's not a fuse because if the fuse was blown neither side would work.

Hope this helps

Posted on Sep 10, 2008

6 Suggested Answers

alicantecoli
  • 22041 Answers

SOURCE: top break light works, right

fit new bulbs ,how simple is that ??

Posted on Nov 17, 2008

keithheavili
  • 410 Answers

SOURCE: Break lights are not working on my 2001 ford expedition

You need to replace your brake light switch which is located on your brake pedal. The reason that the right and left are out and the middle isn't is because there are two sides to the switch for vehicles with three brakes lights. It is a very easy part to replace and is relatively inexpensive. Change that switch out and you will be good to go. Let me know if you have any other questions. Thanks for rating my response and for using FixYa!

Posted on Jul 19, 2009

dennymulford
  • 1055 Answers

SOURCE: the break lights don't work

brake light switch or bad groung at the lights

Posted on Aug 07, 2009

  • 65 Answers

SOURCE: left tail/break light is not working. replaced

IF NOT THE FUSE IT SHOULD BE A LOOSE EARTH

Posted on Feb 28, 2010

  • 6982 Answers

SOURCE: Break lights, turn signals not

Without being there to actually do some checking, I'd take a look at the signal switch itself. (In the top of the column) First though, check the bulbs, as I have seen (but rarely) a filament in a bulb break and re-connect itself to the other leg of the circuit.

Posted on May 05, 2011

Testimonial: "Thanks for the advice. We already checked this and that was not the problem. Don't know if we'll ever figure it out."

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Which fuse is for the left brake light on 2005 Hyundai Sonata


http://binatani.com/wp-content/uploads/2011/06/2010-Hyundai-Sonata-Engine-Compartment-Fuse-Panel-Diagram.jpg

Labeled STOP, there is only one because both lights come on at the same time. Maybe bad lamp, bad socket or broken wire seperated connector.

Sep 15, 2014 | Cars & Trucks

1 Answer

My left brake light does not work could it be a fuse & if so which one do i change


IF YOU HAVE JUST ONE BREAK LIGHT OUT, CHANCES ARE THE BULB IS BAD
REAR LIGHTS HAVE TWO ELEMENTS ONE FOR RUNNING LIGHTS AND A SECOND ELEMENT FOR THE BREAK LIGHT THE ELEMENT FOR THE LEFT BREAK LIGHT IS BAD

Apr 29, 2011 | Ford Taurus Cars & Trucks

1 Answer

My rear lights do not work i have break lights signal both left and right and hazards but they dont work


I would start by inspecting ALL your fuses. If they're good then you probably have a bad headlight switch -(tail lights, dash light - also run off headlight switch)

Apr 07, 2011 | 2006 Pontiac G5

1 Answer

Jaguar xj6 break light cancels signal


Replace the turn signal switch. Bad contact inside causing a crossing of the circuits. When the turn signal is applied it should open the brake light circuit allowing for just the signal to work. Doesn't sound like the switch is doing it's job.

May 23, 2010 | 1989 Jaguar Vanden Plas

1 Answer

96 contour. left tail light, 1 and 2nd break light are out.


Everything works, more or less, so you know that the switches and fuses are good. That means that you've got either bulb problems or power/ground problems. First, try swapping the bulbs around to see if the "bad" lights will work with the known "good" bulbs in them. If so, you just need to replace some bulbs. If not, check the sockets inside and out for corrosion, clean them (wire brush, steel wool, sandpaper, etc.) if necessary, and use a voltmeter or automotive tester to make sure that you have power and ground to each socket. The fast flash on the turn signal is just an indicator that a bulb is out.

Bill B

Apr 28, 2010 | 1996 Ford Contour

1 Answer

The break lights don't work


brake light switch or bad groung at the lights

Aug 07, 2009 | 2004 GMC Envoy

1 Answer

Right read blinker/break light dont work, turn signal blinks rapidly


It's the bulb. There are two filliments in the bulb. One is for when you turn your lights on and the other is for breaking and blinker flashing. When the break filliment goes bad it causes the blinker to flash very rapidly. 100% the bulb. Change it and all will be good again. P.S. if it were a fuse none of the break lights or blinkers would work.

Apr 20, 2009 | 2005 Ford Explorer

2 Answers

Changed break line but still have no pressure in breaks


to do a complete job. you need to bleed all 4 wheels, starting from Right Rear. Right front. Left Rear. Left Front.

Apr 07, 2009 | 1995 Chevrolet Silverado 2500

Not finding what you are looking for?
2004 Chevrolet Avalanche Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...