Question about 1997 Chrysler Town & Country

1 Answer

Wipers the lights on my console for my rear wipers are flashing and I cant get them to stop

Posted by on

  • dzapata66 Oct 06, 2008

    i have the same problem

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

The climate control panel has come out of calibration..
to re-calibrate it you need to have
Set Blower motor ON HIGH
Set Mode position to Panel
Open all A/C outlets
Set Temperature to Cold (Both slide pots if equipped)
Depress WASH and REAR WIPER button simultaneously for 5 Seconds (Until all LED's light)

All LED's will turn on for 5 Seconds
When done REAR WIPER LED is the only LED flashing. Push Rear Wiper to exit

your a/c system must be functioning properly for it to re-calibrate.

Posted on Jan 12, 2009

  • maddog02 Jan 12, 2009

    and the engine must be running

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Dodge grand caravan .there is a module that needs reprogrammed,this happens all the time. How?


Put your controls all the way to cold(mine is all the way to left). Turn your blower switch all the way to High. Put the position to console vents(all the way left).Hold down top left button(rear wiper) and bottom left button(rear washer) at the same time until all lights are solid. Then release. Let the buttons flash until only top left(rear wiper) is flashing. Then press top left(rear wiper) to end test.Should help those pesky flashing lights unless there are deeper Problems!

Nov 17, 2011 | 1998 Dodge Grand Caravan

1 Answer

I have a 1998 Plymouth voyager and the climate control lights are flashing. I ran a test i found on the internet and got it down to two lights flashing(the ac and the recirculate). I got it to where the...


OK got your message on the other post (About the van) I am assuming that your Voyager is equipped with Automatic Climate Control. Follow the instructions below and you will get a better idea of what is wrong with your system.

Calibration/Diagnostics
1. To enter calibration/diagnostics test, set parking brake. Start and warm engine to normal operating temperature. With engine idling, turn blower switch to high. Turn mode switch to panel. Open all outlets. Move temperature to full cold.
2. Press and hold rear wash and rear wiper buttons simultaneously for 5 seconds (Until ALL LEDs illuminate). All LEDs should illuminate for 5 seconds. Rear wiper and intermittent rear wiper button LEDs will flash alternately during calibration/diagnostics test.
3. After approximately 60 seconds, if only the rear wiper button LED is flashing, calibration is successful and the system is okay. If rear wiper and intermittent rear wiper button LEDs are flashing, Diagnostic Trouble Codes (DTCs) are present. (See "Reading Diagnostic Codes" below)
4. To exit calibration/diagnostics test at any time, press the rear window defogger button, rear wiper button, or cycle the ignition off and then on. Test will automatically terminate 15 minutes after calibration/diagnostics is entered.

Reading Diagnostic Codes
1. Perform calibration/diagnostics test. If a DTC is present after calibration/diagnostics test has been performed, system will flash rear wiper and intermittent rear wiper button LEDs in sequence. Rear wiper represents code level, and intermittent rear wiper button LED represents code value.
2. Each time the rear wash button is depressed, rear wiper button LED wil cycle to the next code level in numeric sequence. After code level 5 is reached, rear wiper button LED will cycle back to code level 1. See table below.

dttech_67.gif

May 12, 2011 | Plymouth Voyager Cars & Trucks

1 Answer

Lights are flashing on the heater controles [the ac , back wiper , all buttons there ] what fixes that. on my 98 dodge caravan


push and haold in the rear wiper and rear washer butts for 5sec or until all lights flash but make sure yor motor is warm and that the ac is on high first.. wait until all lights except for the rear wiper light are off then press the rear wiper button once more..

Jun 19, 2010 | 1998 Dodge Caravan

1 Answer

The rear wiper lights flash and until they stop flashing, which takes a while, no other buttons work, no fan for heating, no rear defrost, nothing til they stop flashing, HELP!!!!


try this key on engine runningblower on hight temp sset at cold . hold down the top button and the third on the control all the lights will start flashing after the module calibrates the light should go off.Good luck

Aug 09, 2009 | 1997 Dodge Caravan

2 Answers

Lights flash on ac rec and rear wiper buttons. Put on new ac com


With my 1998 TC you have to start car turn to cold and fan on high. Tehn hold down the rear wiper and WASH buttons until the lights start flashing differently. Let it run through until only the rear wiper light is blinking. You should here it cycling through the different functions. When it is jsut the rear wiper blink press that button and the system is reset if there are no problems. A low voltafge problem had caused mine to act up.

Aug 05, 2009 | 1998 Chrysler Town & Country

1 Answer

Need to reset flashing instrument lights


Here's what i found is supposed to work.

1. Set blower to HIGH
2. Set mode position to PANEL (AC vent air)
3. Open all AC outlets
4. Temp. on full cold
5. Start engine
6. Push WASH and REAR WIPER switches for 5 seconds until all panel lights are on solid
System will then go through it's paces as it calibrates the climate controls
7. When calibration is complete only the REAR WIPER switch/light should be flashing. Press this switch to extinguish the light
and all should work normally.

Mar 26, 2009 | 1998 Plymouth Voyager

1 Answer

Flashing lights


Hi, had the same problem today. Solution: Start engine, blower on max, air direction to cabin, press rear wiper and rear wash buttons simulanteously for 5 seconds (all lights now on steady). Calibration test starts and lights flsh alternately. After first test, AC and recurculation lights flash for the cool down test. If all test pass then rear wiper light blinks slowly (press to exit self test). If AC and recurculation test fails then just 2 lights stay on. To repeat this part of the test press just AC and rear wash simulanteously ( may take several attempts and usually best when engine is cold). Again exit by pressing the rear wiper button once it is the only one flashing (slow blink).

This does work but it took me 15 minutes to finally switch them off!!!

Jul 28, 2008 | Chrysler Voyager Cars & Trucks

Not finding what you are looking for?
1997 Chrysler Town & Country Logo

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...