Question about 2006 Ford Fusion

2 Answers

I was told his morning that my 2006 Ford Fusion A/C has a leaking evaporator core. Cost to replace about $1,100. My next move is to check the warranty but if that fails what do you think my next move should be?

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Get 2 estimates, parts from Ford will be higher in cost, but higher in quality.

Posted on Aug 30, 2011

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 184 Answers


Please get a second opinion. It's very unlikely that evaporator itself is leaking. Usualy the leaks occur in joints between pipes.

Hope it helped.


Posted on Aug 30, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 ford fusion fuse box diagram

Here you go , you can check it out for yourself . click on technical Information , five rectangular box's will pop up ,click on All TSB's and diagrams for every make and model - FREE .Next page go to the bottom an click on I agree , Next page click on wiring diagrams ,then add your vehicle info . then under system click on electrical distribution , then subsystem fuse panel ! then click search , then click on the blue link . 2006\FM\WRFM06FUS018a .

Feb 09, 2013 | 2006 Ford Fusion

2 Answers

2006 Ford Fusion 2.3L I4 Engine Check engine light ODBC code is P0455. I have already replaced the gas cap. The computer codes were cleared by disconnecting the battery. The check engine light and same...

If you have already replaced the gas cap then you need to start looking for splits in your evap lines, and the evap canister for your vehicle. This procedure is easier done at a shop then by the DYI due to how many different lines that you have, and you may have a small slice in a line that only opens up under certain conditions. The p0455 is a very difficult code to diagnosis

Jun 06, 2011 | 2006 Ford Fusion

1 Answer

2006 Ford Fusion 2.3L I4 Engine Check engine light ODBC code is P0455. I have already replaced the gas cap.

The check engine light won't go out unless you (1) clear the code with a tester or (2) give the computer a chance to determine the problem is no longer there. It has to go thru several test cycles detecting no problem before the computer will turn the light off. You could also have another problem causing an evaporative emission leak (like a vent hose for instance).

Jun 06, 2011 | 2006 Ford Fusion

1 Answer

I have a 2006 Chrysler Town & Country and have been told the air conditioner rear evaporator core needs to be replaced at a cost of $1,000. The car has 39,000 miles on it. Have you heard of similar...

similar thing just happened to a friend bring it to a dealer that can look at and get a second opinion, friend was told the same thing and it ended up being a leak from one of the valves

Jun 02, 2011 | 2006 Chrysler Town & Country

1 Answer

Where is the air conditioner sensor in ford fusion

There are a few sensors or as i call them switches, the low preasure/cycling sw. and the high preasure switch (sw.) theres a temp sensor inside the heater box on the evaporator core, the switches are located on the lines one is on the suction line and the other is on the high preasure line.

Jun 26, 2010 | 2006 Ford Fusion

1 Answer

My a/c on the ford fusion i have already relpaced the blower motor blower moter resistor and cleaned the evaporator and checked the freon levels everything ok the only thing is that somtimes in throws hard...

Have you put a scanner on it,and followed a trouble chart,for a 2006 Fusion?
Have you watched the mode door actuators,when switching the DATC Control?

May 14, 2010 | 2006 Ford Fusion

1 Answer

2006 Ford Fusion a/c not working. Has trouble code PO538 stating the evaporator temperature sensor circuit high. Where is this located?

its inside the hvac box under the dash you may or may not have to romove the hvac unit to change it. circuit high means an open circuit so check connectors and such

Apr 15, 2010 | 2006 Ford Fusion

1 Answer

Bad evap sensor

This is sandwiched under the dash and requires dash removal to remove and replace.

Jun 01, 2009 | 2006 Ford Fusion

1 Answer

Been told the regulator in the driver's door electric window has failed but want to check that this is correct - - live in Dunfermline

I have a 2006 Fusion and the window was not properly working, was told it was the regulator. They replaced it and the problem went away. Later the had to do the same to the driver window. 2 down 2 to go!!

Jul 29, 2008 | 2006 Ford Fusion

Not finding what you are looking for?
2006 Ford Fusion Logo

Related Topics:

228 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides