Question about 1993 Ford Thunderbird

2 Answers

Blower motor where is my blower motor on a 1993 ford thunderbird?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Some time my blower motor will not run wite the thermosta or it will run only in full spead

Posted on Oct 09, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

You will need to remove your glovebox to gain access to your blower motor

Posted on Sep 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 thunderbird climate control


check to see if you have a temprature control module that goes into the duct work by the fan or under the glove box-it may be bad

Mar 26, 2013 | 1993 Ford Thunderbird

1 Answer

1995 Ford Thunderbird blower motor stays on


If yours is equipped with automatic climate control, check the blower motor resistor behind the glove box.

Jul 16, 2012 | 1995 Ford Thunderbird

1 Answer

I need a spark plug wiring diagram for a93 ford thunderbird?


you don't list what motor you have, but here is a link that has all Ford motors,, just click on your motor and it will show you the firing order http://autorepair.about.com/library/firing_orders/bl-ford-firing-93.htm

Sep 01, 2011 | 1993 Ford Thunderbird

1 Answer

How to replace a blower motor in a 1996 ford thunderbird lx


Removal
  1. Remove the glove compartment liner to gain access to the heater blower motor and blower motor wheel assembly mounting screws.
  1. Use a small screwdriver to remove clip retaining hydraulic damper strut.
  1. Remove four screws and remove the heater blower motor assembly and blower motor wheel assembly from the heater blower motor housing.
Installation
  1. Using a new seal, position the heater blower motor and blower motor wheel assembly to the heater blower motor housing with the flat side of the flange near the heater blower motor switch resistor (18591). Install the four retaining screws.
  1. Tape the heater blower motor power lead to the air inlet duct to keep the wire away from the blower outlet during installation.
  1. Install the heater blower motor and blower motor wheel assembly in the vehicle.
  1. Install the glove compartment liner.

Oct 07, 2010 | 1996 Ford Thunderbird LX

2 Answers

1995 Ford Thunderbird v8 lx heater fan is slow


If it is slow,on all speeds,then the blower motor is most likely the problem,replace it.

Feb 25, 2010 | 1995 Ford Thunderbird

2 Answers

Blower motor resistor


The blower motor resistor is located near the blower motor. It is held in place by 2 screws, and has a wire clip connected to it. Very simple fix.

I hope this helps you, and I wish you luck on your repair.

May 01, 2009 | 1995 Ford Thunderbird

1 Answer

1994 thunderbird no heat


the blower motor resistor that's located in the plenum. has about 4 wires and is about 2" x 3"

Feb 24, 2009 | 1994 Ford Thunderbird

4 Answers

Blower motor problem


Replaced automatic Control module in dash and module at blower and the blower Still have no heat. Original problem was smoke for vents and no blower help...1994 thunderbird

Jun 13, 2008 | 1996 Ford Thunderbird LX

Not finding what you are looking for?
1993 Ford Thunderbird Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...