Question about 1995 Chevrolet Blazer

1 Answer

Shocks I have sir shocks on my 1995 Chevy Blazer. I think that the welds on the part that they are supposed to be connectet to have broken free. I would like a picture diagram on how they are supposed to be intalled underneath my vehicle. Can you please help me with this?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 92 Answers

I would have that looked at they need to be sealed

Posted on Dec 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will shocks off a 2001 chevy truck fit a 1995 truck 4wd


The description is vague. If you are asking if shocks from a 2001 Chevy Silverado, K1500 will fit a 1995 Chevy Silverado K1500, the answer is no (on front and rear shocks). I also looked up a 2001 Chevy S10 4wd and a 1995 Chevy 4wd. The answer is yes (on front and rear shocks). I hope that helps but if not please write back with the exact two vehicle descriptions.

Jan 11, 2014 | Cars & Trucks

1 Answer

'99 chevy blazer 4x4 LT


the heater issue is probaly a short in wiring. the tire is a wheel bearing needing replaced.

Apr 06, 2010 | 1999 Chevrolet Blazer

1 Answer

Need a engine wiring diagram for a 1995 chevy blazer 4.3L engine


Try the dealer for that. They'd print you the copies free from their microfiche.

Nov 10, 2009 | 1995 Chevrolet Blazer

1 Answer

1995 chevy blazer won't go into park. everything else ok . what do i need to adjust and where?


Hi,

I think the linkage is out of adjustment or posiibly the park pin is broken in the transmission.

It could be any of these two only. Check for it.

Do let me know if it helped.

Thanks
Kanu

Oct 13, 2009 | 1995 Chevrolet Blazer

1 Answer

Couple of days ago car started choking like I was running out of gas my gas guage could be broken but can someone tell me where the carburator ? is so that I can put gas in it.


Your 95 Blazer does not have a carburetor (correct spelling too) It is fuel injected so injectors are used for each cylinder instead of a carburetor. If you run out of fuel and your vehicle is facing uphill when that happens you should have some fuel in the tank left. When leveling at a level position the vehicle will start again. You see the fuel pump is in the fuel tank and fuel is needed at all times to prime when starting. If on a grade the fuel goes to one end if only a gallon or two is left and the pump will **** air only causing a stalling problem I added all this in just so you remember this incase it ever happens to you

May 25, 2009 | 1995 Chevrolet Blazer

2 Answers

Transmission replacement


It will if your blazer has a 4.3. It will bolt right in.

Apr 16, 2009 | Chevrolet Blazer Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...