Question about 1995 Chevrolet Lumina

1 Answer

My 93 chevy lumina doesnt get gas into the cylinders. i think my fuel injectors have all stopped witch probably means that their is a fuse out, but i checked them all as well as checking all the fuel pressure up until the injectors. could their be a computer chip out?

Posted by on

  • RnnMr7 May 11, 2010

    my 1995 chev lumina doesnt get gas into cyinders.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 64 Answers

Sounds like there is no driver signal to the injectors if they have fuel pressure and no fuse is blown. check the wire harness that feeds the injectors and see if its loose or damaged, and check that the connectors arent all corroded up inside. Use an ohm meter and see if there is continuity all through the wires to the injectors and power to the computer and if so, the computer may have died on you

Posted on Jan 02, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Have 04 93 fuel pump runs but no fuel up to the fuel rail code scaner says open circuit injectors all cylinders does that mean ecm??

1. If there is no fuel at the rail, you have a clogged filter.
2. If you mean no fuel coming out of injectors, it could be the wiring, fuse, relay, or computer. Check the cheaper possibilities first. If you provide model and engine size, I can probably give more specific procedures.

Aug 01, 2017 | Cars & Trucks

1 Answer

Cn fuel pressure regulator cause a dead miss on 92 chevy lumina?

A fuel pressure regulator maintains sufficient pressure for all the injectors to operate correctly. If it is not working properly you will have random missing on all cylinders as the injectors are starved for fuel to inject. If you have a constant miss in one cylinder then by moving that injector to a different cylinder will prove injector or spark/coil problems Run fault codes to determine the fault area.

May 26, 2014 | Cars & Trucks

1 Answer

93 altima same fuel injector goes bad 2 times in 1 month

how did you find out it is the injector causing the problem? the injectors are wired in series on these vehicles, it is possible that another faulty injector may be causing the problem. although it may be difficult to find if this happens intermittently. A scope test may be the only way to find the problem. Does the engine light come on with a misfire code on Cylinder #1? P0301 or r u just getting a random misfire code P0300 ? a bit more info on the vehicle may also be helpful........ engine size? # of cylinders 4 or 6 ?

Dec 06, 2013 | 1993 Nissan Altima

1 Answer

I own a 1990 Chevy Lumina APV 3.1, was leaving for an interview. Suddenly my gas peddle was useless. checked for fuel in tank, made sure spark was there an timing was firing, listened for fuel pump, &...

if it's a trottle body with two injectors.remove fuel pressure,Remove the air filter, remove connector from injector,remove the center pin that hold the air filter case.than remove the top injector from tbi,than pry the injector out,

Aug 02, 2013 | 1990 Chevrolet Lumina APV

1 Answer

We have a 97 chevy lumina that had water in the gas and we need to know where the fuel pump reset button is

There is no reset button for an overload situation on the fuel pump. The only reset is for when the vehicle gets into an accident, which activates on impact. So, I don't think this is what you are looking for. I would suggest looking at the fuse panel, which would be located in the engine compartment and it should be labeled. If this is not your problem, then you probably have a problem with the fuel pump itself or the fuel filter is plugged with water. The fuel filters do not like water, so by purging the gas through the bleeder valve you will be putting all that water into the fuel filter. I would suggest removing the fuel filter and purge the fuel/water at that location. You should replace the filter anyway, so I would remove it and see if the pump still works.

I would also suggest putting a couple of bottles of "Heat" or similar products in the tank, because you will not be able to get everything out.

Good luck....

Dec 01, 2011 | 1994 Chevrolet Lumina APV

1 Answer

94 Chevy Lumina Euro Sedan , Only stalls if I ease onto the gas as i normally would pulling out or turning. But if I go heavy onto the gas from a stop it helps avoid the stall. Any advice as to what the...

idle air control valve not working properly idle speed too low faulty transmission tcc solenoid both problems will set off check engine light.replace fuel filter and air filter,clean fuel injectors.

Nov 28, 2011 | 1994 Chevrolet Lumina

1 Answer

My lifters rattle like crazy when the motor is cold, but not when it's warm, why?

alot of time this is cause by cheap gas, what i mean is the octane rating 87,89.or 93 if you are using the 87 octane some chevys will rattle on this gas try using the 89 and see what happens if this doesnt help then you could have a bad lifter which would need to be replaced before it does damage to the rest of your engine. hope this helps.

Jan 09, 2011 | 1997 Chevrolet Lumina

2 Answers

1993 Chevy Lumina

what about your antitheft system i have seen lots of ign key cylinders go bad and cannot read the keys resistance

Oct 09, 2009 | 1993 Chevrolet Lumina

6 Answers

93 chevy lumina euro won't stay running

if you can check for spark when it wont start and fuel pressure and the service port , would be great information , otherwise pattern failure is ignition module and crank sensor (replace them as a set) , after cools off it will run again.

Dec 31, 2008 | 1993 Chevrolet Lumina

Not finding what you are looking for?
1995 Chevrolet Lumina Logo

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides