Question about 1989 Peugeot 405

1 Answer

406 Peugeot fuel pump - Diesel

My immobiliser has red and green lights, won't switch off is that the lift pump or is a there a quick fix solution?

Posted by on

  • gov-h Nov 07, 2008

    on my 406 also the red and green lamps on the imobiliser keypad are ligth at the same time, is said that there is a system failure.

    But also said to bye a new keypad and engine management control unit.

    Are told these are coded together, is this truth. no idea..

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 166 Answers

Yes the control pad and the engine management are connected via a unit called the BSI this very expensive to replace around the $1500 AU price so you don't want to replace it if you dont have to the 406 had problems with immobilisers ecu which is able to be unpluged, most of the time this will solve the problem.
if need be tow the car to the dealer and ask them to unplug the imobiliser

Posted on Dec 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Peugeot 406 1.9td will not start when the code is placed on the keypad of the immobiliser. both red and green lights are on the keypad and sometimes it will start perfect any solutions greatly appriciated?


you could try resrtting the key pad by unplugging it for 15 mins and then plugging it back in mate






if this helps let me know


cheers
big mike

Apr 30, 2011 | 1989 Peugeot 405

1 Answer

I have a peugeot partner van 1997, and I want to bye pass the immobiliser, as the van will not start. The red and green light are staying on. do you have any suggestions please? It is with a mecahnical...


Leave it for half an hour with the ignition on and door closed, it should re set (this happens when the wrong code is used for more than 3 times) check for a sticking button, sometimes they go sticky with a lot of use, if you do get the green light just umplug the keyboard when running and it disables the system. If you cannot get the green light try leaving the battery off overnight with the lights switched on then connect the battery, if still no with the ignition on and someone in the car spark the earth lead to the battery untill the green light comes on.

Apr 13, 2010 | 1991 Peugeot 405

2 Answers

Peugeot 406 hdi electronic immobiliser warning


The ignition key may be defective or in need of a battery to generate the code needed to disarm the immobilizer. Hope this helps!

Mar 05, 2010 | 2005 Peugeot 405

1 Answer

I ran my peugeot 406 out of diesel and i think there is an air lock as it starts but doesnt keep running? i had to click on 2006 peugeot 405 as it wouldnt let me select a product. my car is infact a 1996...


406 1996 Diesel would either be 1.9D, 1.9TD or 2.1TD

Each of these use a vacuum type distribution pump, which means once the fuel has managed to get to the pump via means of initial priming it looks after itself by constantly sucking fuel. If the engine stops after a a short time it could be a blockage caused by running very low on fuel. First thing to check is the primer system. You may have the squeazy balloon type or the purflux set up with a hand primer button. The issue is common to be at this point but hard to diagnose.

What I have done in the past is disconnect the pipe going to the main pump and given a seperate feed from a pipe submerged in a can of diesel, if it runs fine then it rules out mechanical and pump issues leaving it only to be a supply issue.

Regards

Lloyd

Dec 21, 2009 | 2006 Peugeot 405

1 Answer

I have a peugeot 406 hdi executive with no handbook.The car wont start,I think i have immobiliser problem and i need to enter code into keypad.Where is the keypad located?


this car has no key pad as to new, after 1999 all pads are gone and its done through your key, is it cranking over ok, i suspect a faulty lift pump, you have to listen for a wine when you turn the key on, its the lift pump under rear seat.

Aug 16, 2009 | 2006 Peugeot 604

2 Answers

Peugeot 406 immobiliser keypad will not accept code


hi, on your keypad, when key turned on, do have the red and green light on.
if so its locked out, will not start even with correct code.
need to know that first
and diesel or petrol.
i know your car is before a 1999 what year is it

May 17, 2009 | 2000 Ford Escort

2 Answers

Cambelt change peugeot 406 2.1 turbo diesel


have you changed a peugeot or citreon 1.9 or1.9 td, if so its the same.

Mar 07, 2009 | 1991 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

757 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

60792 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...