An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.
An expert whose answer got voted for 20 times.
Re: 2008 renault scenic cd code
When the battery is changed the cd loses its code. to retreve it get the chasiss number. its located on a plate inside the drivers door. its starts with VF!. ring your renault dealer with this number and they will give you the 4 digit code and instructions on inputing it. obviously write it down in case you need it again
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
When you disconnect your battery and then reconnect it again, it disables the radio. This is an anti-theft protection for your car radio. The enable your radio the activation code is in your vehicle owner's manual. If you do not have this code you need to go to your Renault service centre and get them to enter this code for you.
Most likely to be a faulty resistor block, which has 3 resistors and a thermal fuse controlling fan speeds 1,2 and 3, maximum speed 4 by-passes the resister block. It may also be poor electrical connections to the resistor block caused by overheating. Renault ask for approximately £350 to carry out repairs, a replacement resistor block will cost £50. If you decide to carry out the repairs yourself, be advised that if you are not competent to carry out such work you, could cause electrical damage or worse an electrical fire.
Yes, if you do not have a code reader, go to autozone and have them run a diagnostic, this is free, and ask them to clear the code when they are done. If you want to go another route, disconnect the negative battery cable for about 7 minutes to reset the ECU. This should clear the codes also.
you need to ring a renault garage with the chassis num. they will give you a 4 digit code. to enter the code yo must use the control for the radio attached to the steering wheel. if the code for example is 3456 you turn the wheel on the control until the first 0 reaches 3.then click the wheel towards your self to move to the next digit. hen you have all the digits in hold the wheel for approx 3 seconds to enter the code