Question about 1991 Saab 900

1 Answer

SRS (air bag) warning light

Warning light came on. Error code on computer indicated 1d. No such code listed in my manual. Any idea what this might be?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 566 Answers

Hi from uk the air bag indicator light is also linked with the seat belt restraint system these will retract if involve in impact? the wires run under seatsand have plug connectors these sometimes become loosened with seat movements to+frow also inadvertant dislodge withh vac hose when cleaning carpets? try pulling connectors apart and reconnect then see if light goes off

Posted on Nov 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the air bag sensors on a 2000 Lincoln towncar


Sensor - Front Crash Removal
WARNING: Vehicle sensor orientation is critical for proper operation. If a vehicle equipped with an air bag supplemental restraint system (SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic procedure again.
  1. Depower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in this section.
  1. Remove the radiator upper sight shield (8C291).
  1. Remove the air bag sensor.
    1. Disconnect the air bag sensor electrical connector.
    1. Remove the three screws.
    1. Remove the air bag sensor.
    2. SECTION 501-20B: Supplemental Restraint System 2000 Town Car Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 06/10/2004 Sensor - Side Crash Removal
      WARNING: Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system (SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
      WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
      WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
      NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
      NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
      NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic procedure again.
      NOTE: Left side is shown, right side is similar.
      NOTE: The side crash sensors are located under the carpet beneath the front seats.
      1. Position the seat to gain access to all fasteners.
      1. Depower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in this section.
      1. Remove the front seat. For additional information, refer to Section 501-10 .
      1. Remove the safety belt anchor bolt cover.
      1. Remove the bolt and the safety belt anchor.
      1. Remove the front and rear door scuff plates.
      1. Remove the lower B-pillar trim panel.
      1. Remove the carpet to access the side crash sensor.
      1. Remove the side crash sensor.
        1. Remove the retaining bolts and position the side crash sensor in order to disconnect the electrical connector.
        1. Disconnect the electrical connector.
        1. Remove the side crash sensor and bracket.

Dec 16, 2015 | 2000 Lincoln Town Car

1 Answer

Where is the switch to disable the passenger airbag on a 2003 ford taurus


Supplemental Restraint System (SRS) Depowering and Repowering

Depowering Procedure

WARNING: Always wear safety glasses when repairing an air bag supplemental

restraint system (SF3) vehicle and when handling an air bag module. This will reduce

the risk of injury in the event of an accidental deployment.

WARNING: Never probe the connectors on the airbag module. Doing so can result in

air bag deployment, which can result in personal injury.

WARNING: To reduce the risk of personal injury, do not use any memory saver

devices.

NOTE: Ifa seat equipped with a seat mounted side airbag and or a safety belt

pretensioner (if equipped) system is being serviced, the supplemental restraint system

(SES) must be depowered.

NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the

ignition switch is ON. This is normal operation and does not indicate a supplemental

restraint system (SRS) fault.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle

to the customer

1. Turn all vehicle accessories OFF.

2. Turn the ignition switch to OFF.

3. At the central junction box (Cm), located below the LH side of the instrument panel,

remove the cover and the restraints control module (RCM) fuse F223 (lOA) from

the CTh. For additional information, refer to the Wiring Diagram Manual.

4. Turn the ignition ON and visually monitor the air bag indicator for at least 30

seconds. The air bag indicator will remain lit continuously (no flashing) if the correct

ROsI fuse has been removed, If the air bag indicator does not remain lit

continuously, remove the correct RCM fuse before proceeding

5. Turn the ignition switch to OFF.

6. WARNING: To avoid accidental deployment and possible personal injury, the

backup power supply must be depleted before repairing or replacing any front or

side air bag supplemental restraint system (SRS) components and before set-ricing,

replacing, adjusting or striking components near the front or side air bag sensors,

such as doors, instrument panel, console, door latches, strikers, seats and hood

latches.

To deplete the backup power supply energy, disconnect the battery ground cable

and wait at least one minute. Be sure to disconnect auxiliary batteries and power

supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

Repoweri.ng Procedure

1. WARNING: The restraint system diagnostic tool is for restraint system service

only. Remove from vehicle prior to road use. Failure to remove could result in

injury and possible violation of vehicle safety standards.

Make sure all restraint system diagnostic tool(s) that may have been installed during

the repair have been removed from the vehicle and all SRS components are

connected.

2. Turn the ignition switch from OFF to ON.

3. Install the ROsI fuse F2.23 (lOA) to the DB and install the cover.

4. WARNING: Be sure that nobody is in the vehicle and that there is nothing

blocking or set in front of any air bag module when the battery ground cable is

connected.

Connect the battery ground cable.

5. Prove out the supplemental restraint system (SRS) as follows:

Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to

ON and visually monitor the air bag indicator with the air bag modules installed. The

air bag indicator will light continuously for approximately six seconds and then turn

off. If an air bag supplemental restraint system (SF3) fault is present, the air bag

indicator will:

- failto light.

- remain lit continuously.

- flash.

The flashing might not occur until approximately 30 seconds after the ignition switch

has been turned from the OFF to the ON position. This is the time required for the

restraints control module (RCM) to complete the testing of the SRS. if the air bag

indicator is inoperative and a SRS fault exists, a chime will sound in a pattern of 5

sets of 5 beeps. If this occurs, the air bag indicator and any SRS fault discovered

must be diagnosed and repaired.

Jan 12, 2011 | 2003 Ford Taurus

3 Answers

What is the red warning light "SRS"


It is the air bag malfunction warning light.

This will show if the fuse for the air bag operation has blown or if the fuse is removed and not replaced. There can also be other causes such as problems with the wiring or wiring connections.

As a first step check the fuse panel and ensure the fuse is OK. The fuse location is covered in the owner's manual.

Dec 01, 2010 | 1992 Mercedes-Benz E-Class

3 Answers

2004 volvo s60. need help asap


No! This electrical! I'm having the same problem with my 04R too. I've replaced the alternator and battery. Still having the problem. Dealer says there is module thats going bad and draining my electrical system.........

May 29, 2010 | 2004 Volvo S60

2 Answers

Srs warning light on


Here's a quick check list for most common cost of SRS / Air bag problem.


Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat

(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity2_bing.gif problem.

I DO NOT disconnecting the negative battery connector to clean the code(s)

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.


Cheers,

Mustgo

Oct 08, 2009 | 2007 Toyota Yaris

3 Answers

Air bag light is on


Working on the SRS is very hazardous and therefore is not a DIY repair. Take the car to a professional for diagnosis and repair of the SRS.

Sep 25, 2009 | Hyundai Motor 2002 Elantra

2 Answers

SRS warning light on the dashboard keeps flashing. what is/are the problem/s, it is indicating?


it is a problem with your airbag system what year make and model is your vechile

Jun 23, 2009 | 1995 Ford Escort

1 Answer

Front headrest, ford focus


Seat Backrest — Front adobe.gif Printable View (404 KB) Disassembly
All vehicles
ani_caut.gif WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
ani_caut.gif WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
ani_caut.gif WARNING: Front seat back trim covers installed on seats equipped with side air bags cannot be repaired, they are to be replaced. Cleaning is permissible.
ani_caut.gif WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
NOTE: If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Section 501-20B.
  1. Remove the head restraint.
  1. Remove the head restraint guides.
    • Using a suitable screwdriver, depress the locking tang.
    e0008398.gif

May 31, 2009 | 2004 Ford Focus

1 Answer

I have a 2001 hyundai elantra and the warning lights on the dashboard. I know what the oil light looks like and the airbags. What are the other two lights.


Your best bet is to go HERE and signup for a free account then Downloading your Manual - service sheets, diagrams, parts lists etc.
Hyundai is one of the best with providing their customers with free information about the vehicles!!

I have D/L the manual, and the warning lamps on the instrument cluster are...
Left to right...(starting under temp. Gauge)

WITHOUT TRIP COMPUTER
11. Traction Control Indicator Light (If installed)

12. ABS Warning Light (If installed)

13. Seat Belt Warning Light

14. Oil Pressure Warning Light

15. Charging System Warning Light

16. Parking Brake/Brake Fluid Level Warning
Light

17. Malfunction Indicator Light (MIL)

18. SRS (Airbag) Warning Light

19. Trip Odometer/Odometer

20. Trip Odometer Reset Knob

21. Low Fuel Warning Light

WITH TRIP COMPUTER

7. Front Fog Indicator Light (If installed)

8. Door Ajar Warning Light

9. Trunk Lid Open Warning Light

10. Parking Brake/Brake Fluid Level Warning
Light

11. Malfunction Indicator Light (MIL)

12. Charging System Warning Light

13. Oil Pressure Warning Light

14. SRS (Airbag) Warning Light

15. Cruise Indicator Light (If installed)

16. Seat Belt Warning Light

17. ABS Warning Light (If installed)

18. Traction Control Indicator Light (If installed)

19. Automatic Transaxle Position Indicator Light
(Auto T/A only)

22. Low Fuel Warning Light


Thanks for using FixYa - a FixYa rating is appreciated!!

Feb 21, 2009 | 2001 Hyundai Elantra

2 Answers

Srs warning light


the two systems are not related except in their proximity in your steering wheel. srs is safety restraint system and is probably indicating an issue with your air bag, have the error codes read at an auto parts store or at the dealer to find the problem. It could be that there is a problem with the wiring harness to the steering wheel so both horn and airbag are affected.

Jun 16, 2008 | 1997 Mitsubishi Mirage

Not finding what you are looking for?
1991 Saab 900 Logo

Related Topics:

1,097 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

rgbypoet

Level 2 Expert

161 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...