Question about 1992 Dodge Dakota

1 Answer

92 dakota sport

I have just been given a 92 dakota sport 3.9 V6 man trans 4x4 . One prob the frame is rusted in half on the passenger side . I found an 88 dakota same engine trans and is a 4x4 I was just wondering if anyone knows if it is the same frame under it . ?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Dodge Master
  • 60,769 Answers

Yes they use the same frame.

Posted on Sep 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas leaking front passenger side of ford windstar


Have you looked under the hood? (I don't mean to sound like a wise guy.) There are two shiney metal pipes one on the front of the engine and one on the rear as you look at it from the front. They run from right to left on the engine. These are the fuel racks that feed the fuel injectors, (assuming that you have a 3 litre or larger v6 engine). These can concievably rust at the left, (passenger), end and blow gasoline out the passenger side. It is also possible that gas could be leaking anywhere on the engine and roll off the passenger side of the engine or if the fuel line on the driver's side has rusted over a cross member of the frame and possibly roll to the passenger side. Also, there is pretty good pressure on the fuel line when it is running. If there is a rust hole on the right side of the line itself, it could spray to the passenger side, hit something and drip off from there. These are just possibilities. Good luck. Jeff M.

Apr 01, 2014 | Ford Windstar Cars & Trucks

1 Answer

(correcting question) where is the fuse located for a 88 dodge dakota 4x4 V6


In the fuse block. Remove each fuse 1 by 1 and replace until you find the blown one.

Dec 04, 2013 | Cars & Trucks

1 Answer

92 DAK 5.2 LONG TIME TO SHIFT 2-3 THROTTLE PRESSURE/COMPUTER?


There is no computer control on a 92 dakota

That said there is some sensor inputs but the cable
at the throttle body is about it

You need to remove the trans valve body & clean it

I had a trans shop & a 92 5.2 dakota

I found that if you use half GM dexron fluid & half
ATF+4 (used to be 7176 or whatever the stick says)
& a bottle of the Black Lubeguard that the shifts were
just about as good as I could get them

All ATF+3 or 4 was to soft for me,I like to feel clutch
engagement,but most important it has to be fast so no
slipping occurs

My dakota used to hang in 1st gear when it was cold out
Thus the dirty valve body & temp related issues with aluminum

Check TPS Sensor with an oscilloscope for bad spots

Dec 14, 2012 | Cars & Trucks

1 Answer

Why wont my 1994 dodge dakota go over 60


How man rpms are you at when your are cruising at 60mph?

Dec 13, 2012 | 1994 Dodge Dakota Club Cab

1 Answer

No spark in my 92 Dodge Dakota after replacing the clutch


the crank sensor is between the block and trans passenger side it always gets bumped or broken if not removed before removing or installing trans replace the crcrank sensor that shld do it

May 28, 2012 | 1992 Dodge Dakota

1 Answer

Are there fuel filters in the canisters on the passenger side frame rail on a 87 dakota?


No, the fuel filter is under the hood, front passenger side of the motor. Look below the alternator. What you found on the frame is the "vapor canister", has to do with emissions.

Aug 15, 2011 | 1987 Dodge Dakota

1 Answer

I have a 97 trans sport and when i drive it it pops real loud, and almost feels like passenger side front end jumps


check your front wheel drive axles/half shafts, see if the rubber boots that cover the bearings are not torn or missing.. sounds like you might need to replace the axle/half shaft on the passengers side

Mar 21, 2010 | 1997 Pontiac Trans Sport

3 Answers

Dodge dakota tranny swap


No this trans would not fit as it has the wrong output shaft for the transfer case.

Apr 24, 2009 | 1991 Dodge Dakota

1 Answer

I need to know if a 1992 mazda mx3 1.8l v6 is compatible with a 1996 mazda mx3 1.6l for the suspention and other componants?


nope diffrent trans man not to mention obd1 for 92 obd2 for 96 lots of work man not somthing i would call easy

Mar 26, 2009 | 1992 Mazda MX-3

Not finding what you are looking for?
1992 Dodge Dakota Logo

Related Topics:

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...