Question about 1993 Pontiac Bonneville

1 Answer

How to remove the stereo in a 93 bonneville?

I have a new stereo i want to put in my car, and i see the dash around it, i just dont know if i can just pop it off and it will pop back on or not, someone please help me.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Just pop off the trim around the radio, take out the two screws and pull out the radio.

Posted on Feb 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93 bonneville heat dont get hot like it should


Make sure the heater core isn't plugged and the water control valve is working correctly.

Nov 06, 2011 | 1993 Pontiac Bonneville

4 Answers

Heater core replacement


Check under the dash, there you find a panel , remove it. There you find the heater core, first remove the hoses connected then remove screws.

Sep 06, 2008 | 2000 Pontiac Bonneville

1 Answer

I need the factory colors for the stereo for a 1988 Pontiac bonneville


1987-88 Pontiac Bonneville Stereo Wiring Constant 12V+ Orange Switched 12V+ Yellow Ground Black Illumination Gray Dimmer Brown Antenna Trigger Pink Antenna Right Front Front Speakers 4" x 6" Dash Left Front (+) Tan Left Front (-) Gray Right Front (+) Light Green Right Front (-) Dark Green Rear Speakers 6" x 9" Rear Deck Left Rear (+) Brown Left Rear (-) Yellow Right Rear (+) Dark Blue Right Rear (-) Light Blue

Dec 25, 2010 | 1988 Pontiac Bonneville

1 Answer

How to remove and put the a new radio in a toyota highlander 2002


  • Disconnect the negative battery cable and ensure it doesn't contact any metal parts. Place the transmission into the "Drive" position and set the parking brake.

  • 2

    Remove the trim from around the stereo by prying at one of the bottom corners with your fingers. Apply pressure until the clips disengage and work your way up the trim. Once the trim is free from the dash set it safely aside.

  • 3

    Locate and remove the six 10mm bolts that hold the stereo in place. Pull the head unit out of the Toyota highlander dash and disconnect the wires from the back of the radio.

  • 4

    Connect the wiring harness adaptor to the original harness. Mount the new stereo into the Toyota radio mounting kit and secure it by following the manufacturer's instructions. Plug the wiring harness adaptor and antenna wire into the back of the new stereo.

  • 5

    Slide the entire stereo assembly into the dash and reconnect the battery cable. Turn the radio on and verify the speakers and controls are working on the new stereo. Secure the stereo in the dash with the six 10mm bolts and replace the trim ring around the radio.

  • Dec 07, 2010 | 2003 Toyota Highlander

    1 Answer

    Oil pressure rises as I accelerate the car/ put my foot on the gas. The service engine light comes on...this has never happened. Its a 93 pontiac bonneville


    what does the pressure rise too? Its normal to rise somewhat. I dont think the Service Engine soon light is related to the oil gauge operation.

    Jul 24, 2010 | 1993 Pontiac Bonneville

    1 Answer

    How do I take the dashboard off to replace the stereo


    dont remove dashboard, there should just be a plastic trim piece around the radio and possibly go over around the guage cluster. it should just clip in, be careful not to break it or the clips

    Mar 11, 2010 | 1997 Pontiac Bonneville

    2 Answers

    Tail lights out as well as dash lights. 1995 pontiac bonneville


    you need a head light switch. buy from carquest (significantly less expensive then dealership).
    remove knobs (small insert on pull knob press in with a small flathead while pulling towards you, twilight knob pops right off)

    take off the cover plate over steering wheel (pop out with flat head screwdriver)

    then cover over instruments (small torx bit 5 screws, 2 hidden by previously removed cover).

    three small bolts hold in light switch.

    http://www.compnine.com/largeimg/9410173C10-017.gif

    may help in clarification

    Aug 24, 2009 | 1995 Pontiac Bonneville

    1 Answer

    93 BUICK LESABRE CUSTOM dashboard dissassembly


    turn air vents to one side once all the way pull on the part sticking out the most they all come out like that.There will be a screw on the top inside of the vent remove these from each vent.On the bottom were your ac control panel is there is plastic wood grain piece that goes across the dash.Get a flat head screwdriver stick in top of wood grain pry out and work your way down.theres also a small piece on the driver side same senerio.theres a couple screws above the gauges also two in top on inside glove box.

    Jan 27, 2009 | 1993 Buick LeSabre

    Not finding what you are looking for?
    1993 Pontiac Bonneville Logo

    Related Topics:

    146 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Pontiac Experts

    yadayada
    yadayada

    Level 3 Expert

    60960 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Pontiac Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...