Question about 1989 Dodge Dynasty

1 Answer

Loosing power at cruising speed

I own a 1991 Dodge Dynasty with the 3.3 litre engine. Car starts fine and runs fine until I get out on the freeway. Sometimes within about 15 minutes or up to a half hour of driving the car looses power. As I push the gas pedal down the car sputters. I let my foot off the gas and the engine smoothes out but I'm forced to pull over. Car never completely dies. I sit for a minute car regains its power and off I go. Problem will repeat down the road after awhile. Doesn't seem to be a problem at slower speeds on back roads. fuel starvation issue?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi. I have two Dynasty LE cars, (a 91 and a 93). Both have the 3.3 litre. The 1991 had almost the same problem as yours except it would only do it once the engine warmed up, (similar to your freeway issue, given distance and time for the engine to warm up to operating temp.) I had it in about three shops before the dealer found an intermittent fault with the cam and crank sensors. I replaced them and now it runs just fine. I hope this helps.

Posted on Nov 06, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

No maintenance done in 3 years. Car starts but does not remain running fuel filter or plugs or both?


do a computer self test.

Insert key into ignition. turn as follows;

off-on, off-on, off-on. " on " is when the dash lights come on and "off" is one click back from on.

Codes with flash out on the check engine light is pairs of numbers; 5-5 being the end of the test.

Google your findings; eg, "1991 dodge dynasty code 22"

Your condition is usually a sign of a bad crank or cam position sensor ( if you cant keep the engine running by pressing on the gas pedal.)

If you can keep the car running by pressing the gas pedal than your problem is the idle control valve or a broken vacuum hose.

autozone.com has a tutorial on these parts.

Aug 19, 2011 | 1991 Dodge Dynasty

1 Answer

1991 Dodge Dynasty LE car will suddenly die while driving. If I pull off the road, turn the ignition off and restart it- will start but when I put it back in gear the engine stalls again. After five or ten...


Sounds like you are having a fuel problem with the fuel filter. If you have not had your car serviced in quite awhile i would do so. At least change the fuel filter and check the air filter as well. Hope thias will help you.

May 26, 2010 | 1991 Dodge Dynasty

1 Answer

Won't shift out of 1st gear


You need to have the transmission computer scanned for codes. It is likely in limp mode because it has a bad speed sensor.

Sep 02, 2009 | 1991 Dodge Dynasty

1 Answer

Fuel pressure drops immediately to zero when engine is shut off.


I am not really familiar with the setup there but I'd be looking for a second relay to kick the pump on when cranking.

Jun 05, 2009 | 1991 Dodge Dynasty

1 Answer

Car wont start and acts like it aint getting no gas


change fuel filter.check fuel pressure.

Apr 06, 2009 | 1991 Dodge Dynasty

1 Answer

Dodge Dynasty Cruise Control problem


THE 2amp FUSE IS IN THE GLOVE BOX FUSE PANEL.

Dec 29, 2008 | 1993 Dodge Dynasty

1 Answer

1990 dodge dynasty 3.3 engine starts fine but a second later dies changed gas filter and fuel pump and regulator still don't stay started.


Same thing happened to my '89 Dynasty. Turns out the security system was engaged and this stops the motor from running; therefore. a thief cannot drive away with the car! The system is set by using the power locks or an autolock fob, but not by locking manually. Disconnecting the battery will also engage the security system. To disengage, close the driver or passenger (front) door and turn the key in the lock.

Aug 19, 2008 | 1989 Dodge Dynasty

Not finding what you are looking for?
Cars & Trucks Logo

364 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

71288 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7009 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...