Question about 1991 Toyota Land Cruiser

1 Answer



Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Hi you would have an automatic i have a book manual and the a/t oil temp warns that the automatic transmission fluid temp too high.if it comes on while driving pull over and put the selector in p with engine idling wait till light goes off. if it doesnt contact toyota dealer. might be temp sensor.see how you go with this solution

Posted on Apr 24, 2009

  • MARCO SALAS Apr 04, 2012

    Hi Aaronhill and Faxfarmer, I have had the same issue on A-T OIL TEMP COMING ON after driving fast for an hour on the highway, I pulled over for five minutes (engine off) and the light didn{t turned on again. I stop later to check fluid level and temp, and all was OK. Never happened again in the last two weeks. Can you share the sensor specs and location to check it?



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Reverse lights stuck on my 2005 Toyota prado when in drive

there is a sensor on the right side of the main gearbox.
Disconnecting the wires the reverse lights should be off...
If not try check wire harness...

Greetings - Claudio

Feb 11, 2015 | 2005 Toyota LandCruiser Prado

1 Answer

Transmission over temp light comes on. transmission works fine but once went into limp mode

have a pressure test done on the box to check for internal faults. Any high pressure leaks will cause heat. check the filter and while the pan is off adjust the bands and clutch packs . Check the radiator cores are not blocked as engine temperature will affect the transmission oil temperature . check oil level as extra oil will cause frothing and over heating.

Apr 03, 2014 | 2011 Mitsubishi Outlander Sport

1 Answer

When I drive my 02 caravan for 10 minutes the oil light cuts on and the car cuts off. After letting it rest over night, I drive it again and it does the same thing. It seems like it cuts off after the...

Hi, try putting in a new oil pressure switch. If the light continues to come on, you will need a new oil pump. The oil pressure switch cuts off the fuel pump when the oil pressure is low. Please let me know if you have more questions.

Sep 15, 2011 | 2002 Dodge Caravan

1 Answer

What type of oil for a 1993 toyota landcruiser

petrol or diesel require different oils.and ambient temperatures come into play.for average temps of say minus 5C to plus 30C use 20/50 (the best you can afford)it dont matter if its synthetic or normal cos it should be changed every 3000 miles wih a new filter.this is from toyota WORLDWIDE.(NATO/WHO use them all over africa/middle/far east/Russia.who is going to argue....

Nov 08, 2010 | 1993 Toyota Land Cruiser

1 Answer

I've a 2006 Toyota Landcruiser 3.0 D4D and the Oil light has come on for the 2nd time in a month for no reason - jeep was serviced & oil filter & oil changed in July, on checking in aug when the...

oils sensor on the bottom of the sump are prone for the seal to go road muck and water gets in and gives a false reading. remove the plug and clean out and clean the connections and fit new seal.

Jul 06, 2017 | Toyota Land Cruiser Cars & Trucks

1 Answer

I have a 1993 Toyota Prado Landcruiser SX. Dumb little thing, but annoying- there is a light to show that the oil level is low. There is also a dipstick, which I regularly check, making the light...

Have you checked for any oil leaks inside the engine compartment or at the bottom ? The light will turn off when the problem is solved. Try disconnecting the negative battery terminal with the engine off. Leaving it for 10 seconds then reeconnecting it back again.

Dec 16, 2009 | 1993 Toyota Land Cruiser

1 Answer

What do the dash lights on a toyota landcruiser

I don't have one of those vehicles but in the Path Finder it meant Low oil pressure or low oil. If your oil level is correct get the oil pump checked out before the engine is damaged.

Aug 27, 2009 | 1997 Toyota Land Cruiser

1 Answer

95 Landcruiser Turbo warning light comes on under heavy load

If you are "lugging" the engine, you will get increased exhaust temperature (EGT), this will trigger your "turbo" light(not a good thing), ideally you should have an aftermarket "pyrometer" fitted to your car, this will show you the optimum revs etc you should be using in any given circumstance.Or revise your driving technique, ie change down gears earlier.
The turbo should be idled down after long trips or heavy towing, this allows the oil temps to stabilise and turbine speeds to stabilise, thus idle for 2-5 minutes.

Dec 23, 2008 | 1995 Toyota Land Cruiser

1 Answer

1986 toyota landcruiser - auto box - quick chance setup kit for valve plate

Fitting an overdrive auto or a 5speed manual transmission will give a little more top end ......or..... fit larger tyres. V8 should have enough torque to cope well at lower speeds.

Jul 16, 2008 | 1986 Toyota Land Cruiser

Not finding what you are looking for?
1991 Toyota Land Cruiser Logo

1,587 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides