Question about 2006 Chrysler Town & Country

1 Answer

Power Locks both front power locks are inoperative. Neither the door switch nor the keyless remote work. All other door functions, (windows, mirrors, rear vents, etc.) work, as does the other functions on the remote.

Posted by on

  • 9 more comments 
  • genaroreyes1 Sep 22, 2008

    Power locks and keyless remote does not work on my 2005 Town and Country. Back door does not even lock. Changed battery on key but it made no difference.

  • Anonymous Sep 28, 2008

    I have the same problem. When this happens I have to pull the first two fuses (a red and a yellow) then putr them back in and everything works OK.

    fuses are still good but the circuit must have to be broken to recycle.

  • Melody White
    Melody White Sep 28, 2008

    I've had this happen before. Right now, the remote and the locks will not lock. At least my power doors are still working. They went as well last time. I pulled the IOD fuse, left it out 10 minutes, and put it back. Everything has been fine for about 6 months. I'll try it again.

  • emctony Nov 04, 2008

    Remote keys will not open or close the locks. All doors must me locked manually. When remote is pressed parking lights light up and horn beeps as if it were working but locks do not work from remote or from either door lock button?!

  • Anonymous Nov 12, 2008

    Disconnect/wait 1 hour/ reconnect battery to reset locks.

  • ofavreau Nov 28, 2008

    I had a similar problem - both front door locks & both sliding doors inoperative ... I had varied success by removing and replacing various fuses - then I simply disconnected the [-] battery cable from the battery (for a couple of minutes) - now everything is back to 'normal' ... I just wish I knew what causes this to happen - in the first place ...

  • gopher2 Dec 21, 2008

    Have the same issues. Battery was replaced and immediately had problems with power doors and locks. Removed neg (-) battery cable which fixed the power doors and locks. Unfortunately, now the heat/ac and radio are not working properly. There's about a 10 minute delay before they mysteriously start working. Any additional advice? Thks.

  • Anonymous Jan 20, 2009

    I have a 2006 Town & Country Limited. One of the rear sliders will not open/lock using the remote door entry. This is the second T&C that has done this. We have tried pulling the battery cable off and checked the fuses. Any other solutions??

  • tubman636 Apr 06, 2009

    I have a similar problem with my 06 Touring Edition. The passenger sliding door lock will not operate with the others. Right now I have the inside panel off. The actuator does make a sound on the lock and unlock operation, but nothing happens. I have disconnected all the connectors, and plugged them back in. I will try the battery cable and fuse try as well.

  • Bevelry Jakobe Jul 16, 2012

    Love the info. It never would have occurred to me to remove the negative battery cable to reset the locks. Our 2005 Town & Country hadn't had working POWER locks for about 6 months. I figured it was an expensive relay or something and hadn't had the funds to take it in to get it looked at. I just removed the negative battery cable for a while and replaced it and now my power locks are working again. Yay!!! Thanks so much!!

  • Anonymous Mar 23, 2014

    All doors lock except driver s door power locks work and lock all doors except drivers door



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 512 Answers

There is an update for the bcm on 2005 caravans for this need to see your local dealer

Posted on Oct 19, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2003 grand marquis ls door locks and trunk not working

Hi, sounds like you may have lost power. Check your fuses, remember, you have fuses in the cab and under the hood. Hope that helps

Oct 10, 2017 | Cars & Trucks

1 Answer

2000chrysler 300m doors not locking by switchs only by key how do fix

As per this problem,there are help links provided to troubleshoot the exact cause of problem.Click the link below to go through the procedure :----Diagnosis & Testing Power Windows?
Door locks or windows not working on car?

------------Car windows will go down but come right back up

Electric Window Motor REMOVAL and INSTALLATION ?
Driver side power window wont go up on ford expedition?

How to replace window motor and regulator on jaguar S-Type?

How to remove window motor and regulator?
power locks, power window and power mirror on the passenger side not working ?
All power windows not working?

-----------Power windows works intermittently?
--------Power window fuse location?
----------Power windows will not go up and relay clicks when switch is pressed?
----------Keyless keypad on drivers door stopped working?

Remote will not unlock Rear door ?
Door locks or windows not working on car?


Car door will not close?

All power door locks not working on?


Repairing car Door lock Actuator?

How to Access car door panel?

Vehicle door panel components?
----------Front Door dis-assembly diagram?

Rear Door dis-assembly diagram?

How to test Power door locks?
--------This will help.Thanks.

Feb 17, 2012 | Chrysler 300M Cars & Trucks

1 Answer

Power window control,power door lock,door running light,all not working on 2004 GMC Sierra passenger front door.I have not pulled the door panel off yet.Lights and locks work on other doors.Is this a...

If your power mirrors w not fold and the keyless entry is inop, it is the passenger door power controle module. ( the assy. with all the switches on it on the passenger door)

Oct 12, 2010 | GMC Sierra Cars & Trucks

1 Answer

95 S10 blazer 4dr power door locks inop, new battery installed in remote, all fuses good, still inop?

1. Locate the red two wired programming connector located near the central locking control module that is located behind LH Lower instrument panel. Drop the panel and you will see the red programming connector that is not connected to anything.
2. Inside the Red programming connector you will see to pins..
Jump two pins with a section of wire.
3. System should now lock and unlock doors to indicate vehicle has entered programming mode.
4. Press any button on keyless remote once. System should now lock and unlock doors indicating the keyless remote has been programmed.
5. Repeat step 4 to program other remote.
6. Remove jumper wire from programming connector to exit programming mode.
7. Test Remote(s)

Dec 22, 2009 | 1995 Chevrolet Blazer

1 Answer

Power windows inop

a brake in ur wires in the door,on a 04 grand i had the same problem,in the wire harness were the junction box is rust had broken one of the male prongs

May 04, 2009 | 2004 Jeep Grand Cherokee

2 Answers

Power Locks

you need to locate the relays for those items... generally on the fuse panel.... replace the relays that control the problem you have.


Nov 26, 2008 | 2005 Chrysler Town & Country

4 Answers

2004 Jeep Grand Cherokee driver side power windows do not work

I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Nov 25, 2008 | 2004 Jeep Grand Cherokee

1 Answer

Door locks open by themselves randomly

some possibilities

The power door locks may self-activate or cycle on some vehicles. This may be caused by a misadjusted front door lock linkage, excess solder in the front door power window switch, water infiltration of a potential open wire harness connector inside the front doors, wiring harness chafe on the door check strap, or a damaged Remote Keyless Entry (RKE) key fob.

Nov 16, 2008 | 1996 Mercury Sable

1 Answer

Power Locks

if I remember correctly there may be a tsb(technical service bulletion) related to this issue. it requires your dealer to reset the body control module(bcm)

Oct 13, 2008 | 2002 Chrysler Town & Country

Not finding what you are looking for?
2006 Chrysler Town & Country Logo

905 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides