Question about 1995 Nissan Maxima

1 Answer

Stalling my car stalls sometimes when i slow down at a traffic light and when i apply the brakes fully when the gear is on 'D'

Posted by on

  • 2 more comments 
  • T_Road_G Feb 07, 2009

    I have the same thing happening to me. I just bought the car 3 weeks ago and it ran fine for 4 days and started doing this. The check engine light came on and they said it was the knock sensor and the coolant sensor along with the emissions sensor. I don't know. I need help too before I give the car back to the place i'm buying it from and take it as a loss of my money. Nice car....Too many problems!!!

  • Anonymous Feb 08, 2009

    my car have the same exact problems i have a 95 nissan maxima and everytime i come to stop lights my car stalls on me so i was told that it probaly was the ignition coils so i had them checked and three of them was bad and needed to be replaced so replaced them and car is running smoother but the problem is still there but from here i dont know what to do should i replace all of them or what but hope this inforamtion will help you



    stacy

  • momofhavoc Feb 13, 2009

    Same Problem, I have replacesd the knock & coolant sensor per nissan said they were bad, have replaced fuel injectors, a part on the ignition, cleaned the MAF w/ the proper cleaner. & the IAC valve also. I am at a loss of what to do, have taken to mechanics, they are stumped, The car is still in good condition, only 149,000 miles 1 owner. PLZ Help me!!

  • Anonymous Mar 24, 2014

    When making a left turn at slow speed with the foot not on the accelerator, the car will stall when pressure is applied to the accelerator. The stalling goes away when the wheels are straightened.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Is it possible that the idle speed is set to low?

Posted on Sep 06, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

PROTON gen 2 manual keeps stalling when slowing down EML, battery and oil lights come on but no diagnostic report what can i do


check for a vacuum leak to the brake booster as it appears that the fuel/air mixture is going too lean to keep the engine running.

Jan 08, 2015 | Proton Cars & Trucks

1 Answer

Hi I have a 2002 Corolla with an apexi, when driving it can start to splutter a bit and I have to put my accelerator down fully just to maintain the revs, then as the car slows I have to change down a gear...


Most common problem is the IAC(Idle Air Control) valve.But if you say some times work I will suspect the throttle is clogged. Remove the Air hose,apply full throttle and hold, spray carburetor cleaner on clot using thin long nose player clean inside wall and throttle. don't spray directly inside because the carb cleaner is to aggressive for some of the gasket.
Good Luck

Apr 03, 2014 | Toyota Corolla Cars & Trucks

1 Answer

Online chat


If you have the foot on the brake when stopping and it stalls , try slowing down and stopping on the hand brake to see if the engine stalls . If it doesn't stall on the hand brake then I would suspect a leak in the brake booster that is affecting the engine by letting air into the manifold through the activated booster. If there is no difference have the fault codes read as there may be a missing/ faulty vacuum line connected to a actuator in the gear box.

Mar 10, 2014 | Nissan Cars & Trucks

1 Answer

Stalls at stop light and rush hour traffic


disconnect the vacuum line to the brake booster and plug off to the engine. run the engine and apply the brakes and see if it still cuts out. If not the reattach the vacuum hose and re apply the brakes . If there is a stall then replace the brake booster as there is a fault in it that is allowing air into the manifold on brake application. This problem is not connected to the CPU by sensor so no faults would be recorded.

Dec 22, 2013 | 2008 Chevrolet Impala

1 Answer

I have a grand cherokee laredo 2004. it had a starting problem about two months ago and it took us 8 days to get it started, after replacing the pcm, coil, alternator and the crank sharft sensor. the...


Is the MIL ligh on? have you checked for codes? if no codes stored then you have a vacume or fuel issues. Replace the IAC idler air control valve and or look for vacume leak.

Sep 16, 2011 | 2004 Jeep Grand Cherokee

2 Answers

As you've probably heard before my 91 cav starts fine gets warm stalls at lights starts right back up but cuts off when i put it in gear


pull off the transmission transition switch wire pluged on to tranny
start car drive should be fine never hook op again 0 money
or pay 700 dollars to install a new one
or buy switch pull tranny and install your self

Jul 14, 2010 | 1991 Chevrolet Cavalier

1 Answer

02 escalade, vehical stalls at low idle


if it has over 40,000 miles on it change the drive belt and have the alternator tested and also make sure all of the vaccum lines are on and in place

Mar 06, 2009 | 2002 Cadillac Escalade

1 Answer

Engine stalls when brakes applied


Sounds like you have a vacuum leak. Do you also hear any other noises when you push the brakes?

Nov 01, 2008 | 2005 Hyundai Tucson

Not finding what you are looking for?
1995 Nissan Maxima Logo

Related Topics:

515 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...