Question about 2000 Chevrolet Blazer

1 Answer

4wd service light on

I just bought my blazer and a week later the 4wd service light came on so i pressed the 2wheel hi button it flash, then it would go into 4x4 mode eventualy the service light stayed on permenantly and all the other light stayed off. i was told that i need to have it scaned because i culd burn up my transfercase. any solution please

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

From someone that has had a 2000 Blazer for 6 years now I would say return the vehicle if you can and run the other way. Blazers are VERY poor in consumer reports and I average spending almost 1000 every 2-3 months. Oil cooler lines leaking, Idler Arm, Ball Joints and Bearings (felt like I was on ice in summer), Fuel pump. What a headache. I will never buy another GM.

Posted on Sep 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

After pressing the 4 wheel drive button it just blinks a few times and stops then 2wheel drive lights comes on. 4wheel drive worked fine the day b 4


these damn things do this all the time, my 03 ? you cant count on it to work any day of the week ! you just get lucky and it works. I get all lights flashing, i get the nuetral light on yet it is in 2 hi. I'm tired of all the codes and replacing parts, 700.00 dollars later and still the same. I just drive it and it fixes itself in a day, maybe next time i start truck. It worked the best when i sealed all the electrical plugs in moisture proof wrapping,but a few months later and its a guess game again so i just drive it !

Jan 23, 2011 | 2000 Chevrolet Silverado 1500

1 Answer

Hi i have a 2000 Chev Blazer, the service 4WD light appears now and then , we never use 4WD so was not worried about it until today i tryed to put into 4WD and it would not work the lights on the buttons...


one of my vehicles is actually a 2000 blazer and i had that same problem believe it or not. you should check all the connections to the brain of the 4wd. take off the passenger side right side kick panel. the kick pannel is that piece on the side right there next to the door. take that off and you will see a grey box. pull the wires out and look at the ends. i cleaned mine out with a q tip because there was crud in one of them which screws things up. if that doesnt fix it you may need a new one. they can be really expensive from a dealer so i went to a wrecking yard and pulled one out of another blazer and it only cost $20. it works fine now :) i hope that helps.

Jan 06, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

4 wheel drive lights flashes but then returns to 2wheel drive -- some time it will lock in 4w low but both 4w hi and 4w low lights are on --- have new tccm module.


It is the shift motor for the 4wheel drive - only problem is that a shop has to program the new shift motor to the blazer or it will keep doing the same thing

Dec 08, 2010 | 1994 Chevrolet S-10 Blazer

3 Answers

2001 Chevy s10 Blazer. I have a service 4wd light. i can dissconnect the battery and the light goes away. when i drive the 4 lo light will come on from time to time and flash like its trying to engage and...


2001 Chevy Blazer it likes to stay in 4 low. replaced sensor, pannel motor, older computern to check it was placed for a couple weeks or less it will do the same thing again. Just dies and quits has to be restarted agin still in 4 low . Tried to shift the gears slowly, Place in reverse and 2HD pressed and held while backing up this dinn't work either. To get it home I had to hold it in neutral and run the gears again ginally I got it to a shop. He is out of ideas too.

Jul 28, 2010 | 2001 Chevrolet Blazer

2 Answers

I have a 1996 chevy blazer and dont know how to disengage from four wheel drive to two wheel drive?


As I recall the 96 blazer had electronic shifting for 2wd to 4wd. There should be a small panel on the drivers dash buttons for 2wd, 4wd lo and 4wd hi.

Simply press the desired button while stationary and if the system is functioning properly then it will shift and the light for the engaged type of drive will be lighted. Generally you would like to be in 2wd for this vehicle.

Mar 10, 2010 | 1996 Chevrolet Blazer

1 Answer

1999 chevy blazer 4wd not working. in 2wh hi.service 4wd light is on, on the dash. no lights on any of the dash buttons. any suggestions.


switch, 4x4 motor, 4x4 module can cause the lamp to come on need the code most parts stores will tell you code with out charging a dime

Apr 27, 2009 | 1999 Chevrolet Blazer

1 Answer

Service 4 wheel drive comes on at times on 2002 trailblazer


there is something wrong with you 4wd system might be electrial problem get it check be gmc service tech for diag code

Mar 08, 2009 | 1999 GMC Jimmy

2 Answers

My 2000 blazer won,t select 4wd hi/low or auto


there is a vacuum solonoid on the firewall in the middle with 2 vac lines and a 2 wire plug
thats ur problem
push the button and smack it with the handle of a screwdriver should work

Feb 02, 2009 | 2001 Chevrolet Blazer

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

424 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...