Question about 2002 Ford Crown Victoria

1 Answer

CROWN VICTORIA IT CRANKS UP BUT GIOES DEAD IF I DONT STAY ON GAS.CHECKES FUEL PUMP AND FILTER AND THATS GOOD. WHAT COULD BE THE PROBLEM

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Try the entire air intake for leaks.

Posted on Oct 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 95 Ford crown Vic it will turn over but won't crank,it has half a tank of gas,changed the fuel relays,all fuses good in all fuse boxes but it will not start only turn over I'm lost


check codes first--may find problem there.
check spark on more then 1 cylinder.
check fuel pressure and volume--if fuel filter is stopped up, may have overworked fuel pump. With fuel cap off you should hear fuel pump running (key on) If not running, check for power at sub harness--Lastly tap on bottom of fuel tank with RUBBER hammer while someone else is cranking vehicle--if it starts get it to where you can remove tank before turning off--very often one time deal.

Jan 26, 2015 | 1995 Ford Crown Victoria

1 Answer

I have a 1997 crown victoria it just turn over but want start. fuel pump


does it kinda start or just turns over? check for fuel pressure. do this by putting key in on position and then checking to see if any gas will come out of the shradder valve (located on the fuel rail). if there is no gas coming out. fuel pump is dead. check to see if you are getting power to the fuel pump before ou rip it out...might be a busted wire going to the fuel pump

May 29, 2010 | 1997 Ford Crown Victoria

1 Answer

`86 Crown Vic fuel pump problem?


modern gas formulas break down rapidly and will clog and deteriorate most fuel system parts. drain your tank. replace fuel pump and strainer sock, fuel filter.its also a good idea to run a quality fuel conditioner for your first tank full

Jan 02, 2010 | 1986 Ford Crown Victoria

3 Answers

2000 Crown Vic cranks but won't start.


Check the fuel pump reset switch again, if it is popped back out then replace that little switch in the trunk, any ford one will do. it works off a magnet and a bearing to close the circuit for the fuel pump. easy fix.

Oct 05, 2009 | 2000 Ford Crown Victoria

2 Answers

2000 Ford Crown Victoria


when you hold the accelerator does the vehicle stay running? if so the problem is in ithe IAC idle air control motor, take a small screw driver and using the handle tap the iac motor and usualy the motor will kick in and the vehicle will run fine then if the problem is rectified replace the IAC

Nov 24, 2008 | 2000 Ford Crown Victoria

Not finding what you are looking for?
2002 Ford Crown Victoria Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...