Question about 1992 Geo Tracker

3 Answers

Hood How do I open the hood? I can't find a release. Where should I be looking? Please advise. Thank you

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Take it to a full service gas station and ask them to check the oil, they will find it for u

Posted on Nov 12, 2008

Actually I found it in the glove box at the top. Thanks everyone!

Posted on Oct 04, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Geo Master
  • 60,691 Answers

Under the dash near the driver side kick panel.

Posted on Sep 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to replace a hood release cable but first need to open the hood without a hood release lever. Any suggestions? Also may need to adjust the hood mechanism because the hood is so hard to release.


Hi!!
Grab the release cable with a pair of channel lock pliers to pull it open. Lubricate all release mechanism including the release lever, that will easy the release lever.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Jan 04, 2011 | 1991 Dodge Dynasty

2 Answers

Engine hood wont open hood pull handle pulls out but wont release


Try pulling on the hood release, while someone else lifts the hood. If this doesn't work. You can access the underside of the hood release by taking the front grille out. If you look closely you'll see the retainer screws that can be removed from the front. Once the grille is out or loosened enougt to get your hand in behind, you can release the hood latch from the underside with a screwdriver and then repair the hood latch after you've opened it.

Dec 09, 2009 | 1990 Chevrolet Suburban

2 Answers

Trying too find the hood relies on a 1968 cougar XR7


Hello buttercup666...For 1985-88 models, the latch was moved to the left kick panel, below the parking brake release. Once you've pulled the latch, the hood will pop up about an inch. To further open the hood, stand directly in front of the grille and use your left hand to push up the release under the hood. The release is slightly to the left of center.
Good luck i hope this helps, please rate my response a fixya

May 29, 2009 | 1986 Mercury Cougar

1 Answer

1993 toyota hood release wont open hood


try getting a pair of pliers and gripping the cable on the back off the release and popping the bonnet,
if this is no good you may have to go to the dealer to get them to open the bonnet and replace the macanism

Dec 11, 2008 | 1995 Toyota Pickup

2 Answers

Stuck hood on 2000 ford 250, latch release won't work


Ok, open the door, stand next to the door, pull the hood release while slapping your hand on the hood or have someone else lift the front edge while you pull on the latch..... should get in...

Oct 07, 2008 | 2006 Ford F-250 Super Duty

1 Answer

97 850 with stuck hood


The whole mechanism is run by two cables. The first from the hood release latch to the left side hood catch. The second from the left hood catch to the right one.
First look and see if the second cable is disconnected from the left hood catch. if it is just pull it and the right should open. If not...
Have somebody with skinny arms to reach up from under the car and manually pull the lever on the right hood catch.
Hope this helps...

Sep 19, 2008 | 1997 Volvo 850

1 Answer

Opening hood on 1992 Ford Explorer


I had the same problem with my hood. I had that handy wire hanging out of the front but it didn't want to release the hood. The cable was jammed and the hood had to be manually released via ratchet. After you can get the hood open maneuver the cable under the plastic piece where the hood meets the grill to stop this from happening again.

Aug 22, 2008 | 1992 Ford Explorer

2 Answers

BROKEN HOOD RELEASE CABLE.NEED TO OPEN MY HOOD


One of the 2 cables on my hood release is loose. One works fine and releases (dirver's side) but the other is loose and does not. I cannot get my hood up. I have a 1998 Jaguar XJ8
Thank you ....

Aug 06, 2008 | Avanti Studebaker Cars & Trucks

2 Answers

Hood latch


There is no other way to release the hood other than either trying to reach the latch release from under the car or removing the grille.

Jul 28, 2008 | 1993 Acura Legend

Not finding what you are looking for?
1992 Geo Tracker Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...