Question about 1996 Buick Century

1 Answer



Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 421 Answers

Check there drivers door jamb they will break inside the rubber boot you can also run a new ground through there to solve the problem good luck and please rate -jeff

Posted on Sep 05, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Buick century power window

i have fixed this problem on mine remove front drivers door panel trace your ground wire from window switch and make sure you have a good ground once you fix your ground you will fix your windows

Sep 24, 2013 | 1994 Buick Century

1 Answer

What else would cause the power windows to not work in a 2000 buick century other than the fuse and the switch

I have the same problem try this pull the swith out of the door panel. without disconecting on the bottom side of the connector i ran a long piece of wire from the neg batt terminal to the black wire the windows worked a broken or damaged ground seems to be common.the driver door i pull out the locking clip on the connector wich gave me better access to the black wire

Mar 03, 2013 | 2000 Buick Century

1 Answer

Buick century 1998 power window passenger side will not work , nothing work mechinal , all other windows work

You most likely have a bad window lift motor or MORE LIKELY a broken window regulator. The door must be disassembled to replace either or both of these.
It could also be a bad window control switch or a broken wire in the door-jamb area. Please note that EITHER of the switches for the passenger window (the driver's control switch or the one on the passenger door) can cause BOTH of the switches to not work to move the passenger window. In this case, electrical diagnosis must be performed to locate the cause of the problem.

Oct 10, 2011 | 1998 Buick Century

2 Answers

Buick century 1995 only the rear windows work electric windows

Check the front window solenoid, and the window switches to see if your getting power to, and out of the switchs.

Mar 30, 2011 | 1995 Buick Century

1 Answer

Wher is the power window relay for 1996 s-10 truck

Your problem is likely in the master switch on the driver side. Try getting a drivers door switch from the junkyard. I have a 96 Silhouette that I experienced the same problem with. After changing out the motor, and the passenger switch I finally traced it to the master switch. Power goes to the drivers door switch first and then over to the passenger door. It could actually be both switches. A bad relay would affect both windows not just the one side.

Jun 05, 2010 | 1996 Chevrolet S-10 Pickup

3 Answers

Power windows on 1997 buick century stop working

check all fuses, and check driver door master switch and the wiring going to it. sometimes a wire or to break were they come out of door and go inside to dash.good luck.

Oct 14, 2009 | 1997 Buick Century

2 Answers

How to fix my drivers side power window in a 1996 Buick century wagon it started by being very sluggish going up but now does not respond at all. the fuse is good. I think the switch is OK because it won't...

Remove the door panel. You will see the motor, remove the thre star screws, then remove the motor. Remove the motor cap which is held on by one screw. you will see three plastic plugs, remove these and replace with new ones or ball barrings if defective. Pack with grease when reinstalling. Now if it is not the motor then you have a defective regulator. Start by removing the pens holding in the regulator using a hammer and a punch, then drill out the aluminum rivits using 1/4 inch drill. Replace these with 1/4 bolds and lock nuts. Punch out and remove the aluminum holding in the glass, replace these also with 1/4 bolts and lock nuts. If one is going bad then likely all of them will follow. Purchase the regulators and motors if defective on on line,much cheaper. It will take you about 4 hours to replace the first motor and window reglator.

Aug 31, 2009 | 1996 Buick Century

1 Answer

The driver's side power window is stuck half way up on 1998 buick century limited. What is the problem?

It could be the fuse, does it go down? If not chk. fuse, if fuse ok, see if you can help it down by pushing down on window wile working switch, and also same wile trying to go up, if it don't work or if its slow chanses are the motor is tired and needs replaced or its lost power like bad switch or broken wire. there is also a chanse it came off the track in witch case the door panel will have to be removed.

Apr 14, 2009 | Buick Century Cars & Trucks

1 Answer

1999 Buick Century - passenger side power window does not work

Replace the Driver side window switch. These have a corrosion issue.

Mar 27, 2009 | 1999 Buick Century

Not finding what you are looking for?
1996 Buick Century Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides