Question about 1999 Dodge Durango

1 Answer

Wiring have a 99 durango that nutural safty switch wires were torn could you please tell me what wires go where,,,,the truck will not star,,,would that cause it

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 2,920 Answers

You would need to color match the wires in order to reconnect them so you need to locate where they were torn loose from and hook them back up and yes it will keep it fro starting

Posted on Oct 24, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 99 Durango 5.9 rpm goes up and down rep. Crsen wires plugs cap rotor bug still runs really rough

Check to see if all the vacuum hoses are connected to the right source.
Sir Dana

Apr 27, 2017 | Dodge Cars & Trucks

1 Answer

Tried to start engine yesterday, won't do anything, you can't even hear a click coming from the starter.Batteries are fully charged, just doesn't seem to have power going to the starter. I checked all...

You do not tell us what kind of car you are working on.. BUT, you need to check the wire that comes from the ign switch to the starter.. its the small wire. to see if it gets 12V when someone turns the key to the start position. Iit is not receiving power from the switch then the ign switch is probably bad. Or there is a short before it gets to tthe starter. Something to try.. Attach a wire 12Gage to the pos battery post. take the other end and put it against the post where the wire from the ign switch attaches. this should give you a postive indication that the starter works. Make sure car is in nutural.. it could ne a nutural safety switch if automatic or a clutch depress switch if it is a stick. Post and let us know what you find.

Mar 30, 2015 | Cars & Trucks

2 Answers

99 durango 165,000 miles runs good when running. It had the PCM changed when I bought it. Did a tune up and all maintenance. It would shut down after a while. Replaced coll temp,wire harness to PCM, map...

Make sure they put the right pcm in it. The dealer can tell you with the vin#. Then check to see that your pcm has that same number, letters etc. All may not be needed. Try to have the pcm#s when you call them

Apr 30, 2010 | 1999 Dodge Durango

2 Answers

Car wont start at all not turn over or anything has power just wont start check everything still nothhing

try to start it while moving the gear shif all around. if it trys to crank put a new nutural safty switch in it.

Aug 05, 2009 | 1999 Dodge Neon

1 Answer

1995 quest wont start

Either the switch or the nutural safety switch is bad or the wiring from the switch to the nutural switch or the to the starter solenoid is open or disconnected. Either trace wiring or test or replace switch(s).

Jun 19, 2009 | 1995 Nissan Quest

3 Answers

1999 Dodge Durango driver side window does not roll up nor down.

Remove the door panel and find the window motor Unplug it and using a separate car battery run cables directly to the window motor When you switch the polarity the motor will either bring the window up or down or if noting happened change the window motor and window regulator assembly.

Jun 08, 2009 | 1999 Dodge Durango

1 Answer

Two of the plug wires got switched and i dont know which ones. its a 99 durango slt with 5.2 liter. if i had a picture or diagram to tell me where each plug wire goes i could fix.

the firing order is 1-8-4-3-6-5-7-2 , distributor spins clockwise, so find number one on the distributor cap and then the next cylinder will be #8 and so on in a clockwise direction

Mar 18, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides