Question about 2005 Nissan King Cab

1 Answer

2004 king kab 3.0 electric morrors

My left side mirror does not move can it be striped and repaired?and where would the obvious fault lie?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,036 Answers

Often it is a wiring problem within the loom that goes to the door.

It is easier to strip the rubber boot off it, and check if you are actually getting a power supply to it. Use auto-wire strippers, and tape over afterwards, or push a map pin through the insulation - and put a meter on that.

At least this will identify if the fault is a power supply fault, or a break in continuity / motor fault.

Buying a good repair manual will give you the wiring colours to check.

Posted on Sep 04, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How d I swith passenger side mirror on a power mirror on a 2004 Jeep Grand Cherokee limited edition


no symptoms posted (broke glass or ???) can we be on same page?
"how do I switch," verb switch , the mirror as switches inside, too.

please say what that word means. switch and the failure.
1: remove and replace with new.
2: move right to left and left to right side.

why would you do that #2
fold away mirrors/ Export only (this is usa forum so..)
these,NASA grade mirrors are very complex... not just glass and plastic. heaters ,motors, memory , etc.

the FSM cover all tests for the mirror, including scan data.

ill quote the FSM now , 8 steps (just 1 fail,not heat, not memory failure or fold failure)
ONE MIRROR INOPERATIVE
(1) If the one inoperative mirror is on the passenger
side, go to Step 2. If the one inoperative mirror is
on the driver side, go to Step 3.
(2) Check if the passenger front door will lock and
unlock using the power lock switch on the driver side
front door. If OK, go to Step 3. If not OK, go to Step 6.
(3) Disconnect and isolate the battery negative
cable. Remove the trim panel from the front door.
Disconnect the 12-way mirror wire harness connector
from the door wire harness connector.
(4) Using two jumper wires, test the mirror as
shown in the Mirror Test chart (Fig. 2). If the mirror
tests OK, go to Step 5. If the mirror does not test
OK, replace the faulty mirror.
(5) Disconnect the 12-way door wire harness connector
from the door module connector receptacle.
Check all of the circuits of the door wire harness
between the connector for the mirror and the connector
for the door module for opens or shorts. If all of
the circuits are OK, replace the faulty door module.
If any of the circuits are not OK, repair the open or
shorted circuit(s) as required.
(6) Use a DRB scan tool and the proper Diagnostic
Procedures manual to test and repair the faulty Programmable
Communications Interface (PCI) data bus
communication between the two door modules.

(bar stool answer) all cars. mostly
pull door skins
unplug motor conn.
unscrew mirror base from door.
extract mirror,

Mar 07, 2015 | 2004 Jeep Grand Cherokee

1 Answer

I have a 1984 Nissan King Kab and it just started flooding out at idle. This happened at a stop light and I could not restart it until the engine was cold. Once I could get it restarted, I can see the gas...


The float is probably stuck just take a wrench and tape on the side of it and if that dont work you will have to take the float out and adjust it.

May 31, 2011 | 1984 Nissan King Cab

1 Answer

The side view mirrors will not move using the control


There are 2 fuses associated with the power mirrors, fuses F4 & F3.

The next thing to check ( if equiped ) do the power seats still work ?
The reason I ask, is if the power seats do not work, this ( usually ) is a broken splice in the driver's side door sill. The broken wire also has other items associated with it.

Start with checking the fuses, and if they are good check for power at the power mirror switch on the :
F3 - Orange w/ Light Green stripe wire.
F4 is for the power fold module ( in 06 a King Ranch option ).

Aug 03, 2010 | 2006 Ford F-150

1 Answer

Electric folding door mirror not working


Try helping the mirror move by hand. The pivot rusts from not being used. Gently work it around.

Feb 03, 2010 | 2004 Land Rover Range Rover

1 Answer

Pass side view mirror-2004 sedona


its pretty simple. take the inside inspection plate off, dont break tabs, unplug the electric connector, take out the 3 screws and mirror comes off. replace in reverse order. Its easier if you roll down window.

Jan 18, 2010 | 2006 Kia Sedona

1 Answer

Genesis technology pkg. how to stop mirrors from tilting when shi


On the drivers sidedoor mirror controls put the morror selector to the middle position.

Feb 27, 2009 | 2009 Hyundai Genesis

1 Answer

How to change the passenger side mirror on a 2005 dodge ram 1500


Possible Phillips or TORX screw opposite of mirror to Remove trim fight it off snaps are Hard ans scary to pull trim piece off but be brave aftre that trim is off look for Plug for morror Unplug it and should be 2-3 10mm Bolts holding mirror on take them out and Reverse procedure to Install new Mirror EASY Job

Jan 12, 2009 | 1996 Dodge Ram 1500 Club Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...